409. F-centre profiles associated with electronic stopping power in LiF bombarded with high energy ions

Vacuum ◽  
1974 ◽  
Vol 24 (5) ◽  
pp. 222
1973 ◽  
Vol 18 (1) ◽  
pp. 189-195 ◽  
Author(s):  
A. Perez ◽  
P. Thevenard ◽  
J. Davenas ◽  
C. H. S. Dupuy

2003 ◽  
Vol 797 ◽  
Author(s):  
Koichi Awazu ◽  
Makoto Fujimaki ◽  
Yoshimichi Ohki ◽  
Tetsuro Komatsubara

ABSTRACTWe have developed a nano-micro structure fabrication method in rutile TiO2 single crystal by use of swift heavy-ion irradiation. The area where ions heavier than Cl ion accelerated with MeV-order high energy were irradiated was well etched by hydrofluoric acid, by comparison etching was not observed in the pristine TiO2 single crystal. Noticed that the irradiated area could be etched to a depth at which the electronic stopping power of the ion decayed to a value of 6.2keV/nm. We also found that the value of the electronic stopping power was increased, eventually decreased against depth in TiO2 single crystal with, e.g. 84.5MeV Ca ion. Using such a beam, inside of TiO2 single crystal was selectively etched with 20% hydrofluoric acid, while the top surface of TiO2 single crystal subjected to irradiation was not etched. Roughness of the new surface created in the single crystal was within 7nm with the atomic forth microscopy measurement.


1984 ◽  
Vol 37 ◽  
Author(s):  
R. P. Livi ◽  
S. Paine ◽  
C. R. Wie ◽  
M. H. Mendenhall ◽  
J. Y. Tang ◽  
...  

AbstractThin gold films over GaAs wafers with different dopants (Cr, Si, Te, and Zn) were used to study the role of he substrate electronic properties in the electrical contact and adhesion modification induced by MeV/nucleon heavy ion bombardment. The enhanced adhesion was studied using a scratch test; the results show very different modifications of adhesion depending on the bulk electronic properties of the substrate. The sample with a Cr compensation doped substrate showed enhancement in adhesion for beam doses as low as 1012 ions/cm2, but Si and Te doped (n–type) substrates showed a sudden enhancement in adhesion for doses around 1014 ions/cm2. Samples with Si and Te doped substrates were used to sudy the bombarding ion dE/dx dependence of the induced adhesion for 19F and 35C1 ions with electronic stopping power ranging from 161 eV/Å to 506 eV/Å. In this range the dose threshold fgfjhe ops! of induced adhesion has a power law dependence, D = D0(dE/dx)− (1.90 ± 1.0)


1974 ◽  
Vol 29 (10) ◽  
pp. 1442-1448 ◽  
Author(s):  
H. Schmidt ◽  
H. Ewald

Abstract A Computer program for following the trajectories of high energy ions in a fcc-lattice has been written to study the energy loss of 60 MeV 127I ions channeled between (100)- and (111)- planes of a Au-single crystal. The motion of the ions is treated classically. It is assumed that the ion has only one important interaction at a time as it moves through the lattice. The interaction potential used in the calculation is a screened Coulomb potential with a screening function derived from Thomas-Fermi-theory. The slowing down of the incident ions through inelastic encounters with the atoms of the medium is described by a stopping power function which increases exponentially with the distance from the midplane of the channel walls.


1982 ◽  
Vol 93 (2) ◽  
pp. 94-96 ◽  
Author(s):  
Y.H. Ohtsuki ◽  
H. Nitta

1992 ◽  
Vol 279 ◽  
Author(s):  
Abdelilah Slaoui ◽  
Marie-Claude Busch ◽  
Eric Doorhyee ◽  
Marcel Toulemonde ◽  
Paul Siffert

ABSTRACTIn this work, we present experimental observations of radiation damage in thermal SiO2 films grown on silicon, induced by energetic (> 0.2 GeV) O, Ni and Xe ions bombardement. The structural analysis of the SiO2 films, using infrared absorption spectroscopy, ellipsometry and etch rate measurements, points to atomic displacements, broken and strained Si-O bonds induced by irradiation. We have also estimated the damage production cross section and the track radii of the ions in the amorphous SiO2 films as a function of the electronic stopping power.


2003 ◽  
Author(s):  
Gohta Niimi ◽  
Yoshifumi Ueno ◽  
Kentaro Nishigori ◽  
Tatsuya Aota ◽  
Hidehiko Yashiro ◽  
...  

Author(s):  
Joseph J. Comer ◽  
Charles Bergeron ◽  
Lester F. Lowe

Using a Van De Graaff Accelerator thinned specimens were subjected to bombardment by 3 MeV N+ ions to fluences ranging from 4x1013 to 2x1016 ions/cm2. They were then examined by transmission electron microscopy and reflection electron diffraction using a 100 KV electron beam.At the lowest fluence of 4x1013 ions/cm2 diffraction patterns of the specimens contained Kikuchi lines which appeared somewhat broader and more diffuse than those obtained on unirradiated material. No damage could be detected by transmission electron microscopy in unannealed specimens. However, Dauphiné twinning was particularly pronounced after heating to 665°C for one hour and cooling to room temperature. The twins, seen in Fig. 1, were often less than .25 μm in size, smaller than those formed in unirradiated material and present in greater number. The results are in agreement with earlier observations on the effect of electron beam damage on Dauphiné twinning.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
H. Amekura ◽  
M. Toulemonde ◽  
K. Narumi ◽  
R. Li ◽  
A. Chiba ◽  
...  

AbstractDamaged regions of cylindrical shapes called ion tracks, typically in nano-meters wide and tens micro-meters long, are formed along the ion trajectories in many insulators, when high energy ions in the electronic stopping regime are injected. In most cases, the ion tracks were assumed as consequences of dense electronic energy deposition from the high energy ions, except some cases where the synergy effect with the nuclear energy deposition plays an important role. In crystalline Si (c-Si), no tracks have been observed with any monomer ions up to GeV. Tracks are formed in c-Si under 40 MeV fullerene (C60) cluster ion irradiation, which provides much higher energy deposition than monomer ions. The track diameter decreases with decreasing the ion energy until they disappear at an extrapolated value of ~ 17 MeV. However, here we report the track formation of 10 nm in diameter under C60 ion irradiation of 6 MeV, i.e., much lower than the extrapolated threshold. The diameters of 10 nm were comparable to those under 40 MeV C60 irradiation. Furthermore, the tracks formed by 6 MeV C60 irradiation consisted of damaged crystalline, while those formed by 40 MeV C60 irradiation were amorphous. The track formation was observed down to 1 MeV and probably lower with decreasing the track diameters. The track lengths were much shorter than those expected from the drop of Se below the threshold. These track formations at such low energies cannot be explained by the conventional purely electronic energy deposition mechanism, indicating another origin, e.g., the synergy effect between the electronic and nuclear energy depositions, or dual transitions of transient melting and boiling.


Sign in / Sign up

Export Citation Format

Share Document