Advantages and use of a newly developed load-bearing insulation material made of cattail

Development of Load-Bearing Thermal Insulation Recycled Concrete Block and Research on its Thermal Performance

Advanced Materials Research ◽

10.4028/www.scientific.net/amr.1004-1005.1503 ◽

2014 ◽

Vol 1004-1005 ◽

pp. 1503-1507 ◽

Cited By ~ 1

Author(s):

Xi Xi He ◽

Xing Ming Liang

Keyword(s):

Heat Transfer ◽

Heat Transfer Coefficient ◽

Transfer Coefficient ◽

Thermal Insulation ◽

Thermal Performance ◽

Recycled Concrete ◽

Recycled Aggregate ◽

Masonry Walls ◽

Insulation Material ◽

Load Bearing

A new kind of 310mm thick load-bearing thermal insulation block utilizing construction waste as coarse aggregate was developed and produced. Internal thermal bridge is reduced by special design of holes pattern and cut off by mal-posed thermal insulation layer arrangement. By testing heat transfer coefficient of four kinds of masonry walls, different aggregate type, masonry unit type and insulation material which affect thermal performance of masonry were studied. Results show that heat transfer coefficient of walls with recycled aggregates is lower than that with natural aggregates under the same condition. By filling thermal insulation material in block holes, heat transfer coefficient is dramatically lowered. Among four types of masonry walls, heat transfer coefficient of 310mm thick load-bearing block wall with recycled aggregate is the lowest, and its thermal insulation performance is the best.

Get full-text (via PubEx)

Load-Bearing in the Ovine Medial Tibial Condyle: Effect of Meniscectomy

Veterinary and Comparative Orthopaedics and Traumatology ◽

10.1055/s-0038-1633027 ◽

1993 ◽

Vol 06 (02) ◽

pp. 100-104 ◽

Cited By ~ 8

Author(s):

D. M. Pickles ◽

C. R. Bellenger

Keyword(s):

Knee Joint ◽

Contact Area ◽

Mammalian Species ◽

Total Removal ◽

Load Bearing ◽

Human Knee ◽

Biochemical Effects ◽

Pressure Sensitive ◽

Medial Meniscectomy ◽

Tibial Condyle

SummaryTotal removal of a knee joint meniscus is followed by osteoarthritis in many mammalian species. Altered load-bearing has been observed in the human knee following meniscectomy but less is known about biochemical effects of meniscectomy in other species. Using pressure sensitive paper in sheep knee (stifle) joints it was found that, for comparable loads, the load-bearing area on the medial tibial condyle was significantly reduced following medial meniscectomy. Also, for loads of between 50 N and 500 N applied to the whole joint, the slope of the regression of contact area against load was much smaller. Following medial meniscectomy, the ability to increase contact area as load increased was markedly reduced.The load bearing area on the medial tibial condyle was reduced following meniscectomy.

Get full-text (via PubEx)

Analysis and design guidelines of precast, prestressed concrete, composite load-bearing sandwich wall panels reinforced with CFRP grid

PCI Journal ◽

10.15554/pcij.03012010.147.162 ◽

2010 ◽

Vol 55 (2) ◽

pp. 147-162 ◽

Cited By ~ 37

Author(s):

Tarek K. Hassan ◽

Sami H. Rizkalla

Keyword(s):

Prestressed Concrete ◽

Design Guidelines ◽

Load Bearing ◽

Analysis And Design ◽

Wall Panels ◽

Sandwich Wall ◽

Precast Prestressed Concrete

Get full-text (via PubEx)

Effect of long-term loading on timber load-bearing elements

Pollack Periodica ◽

10.1556/606.2015.10.2.3 ◽

2015 ◽

Vol 10 (2) ◽

pp. 25-34

Author(s):

Kristian Sogel

Keyword(s):

Load Bearing

Get full-text (via PubEx)

Production of load bearing and hardfacing layers on aluminium alloys with the CO2 laser

International Congress on Applications of Lasers & Electro-Optics ◽

10.2351/1.5058494 ◽

1992 ◽

Cited By ~ 1

Author(s):

R. Volz

Keyword(s):

Co2 Laser ◽

Aluminium Alloys ◽

Load Bearing

Get full-text (via PubEx)

Restraint of Performance Decrease of Ni-MH Battery Performance under Low Temperature by Combined Use of Heat Insulation Material and Heater

2020 23rd International Conference on Electrical Machines and Systems (ICEMS) ◽

10.23919/icems50442.2020.9291055 ◽

2020 ◽

Author(s):

Haruya Kawano ◽

Shogo Nishikawa

Keyword(s):

Low Temperature ◽

Heat Insulation ◽

Insulation Material ◽

Combined Use ◽

Heat Insulation Material ◽

Mh Battery

Get full-text (via PubEx)

PARTICULAR QUALITIES OF CONSTRUCTION AND TECHNICAL EXPERTISE OF STRUCTURES AGRICULTURAL WAREHOUSE OF MINERAL FERTILIZERS

STATE AND DEVELOPMENT PROSPECTS OF AGRIBUSINESS. In the frame of the XXIII Agribusiness Forum of the South of Russia and the Exhibition «Interagromash» Volume 1 ◽

10.23947/interagro.2020.1.106-110 ◽

2020 ◽

Author(s):

I.O. Egorochkina ◽

◽

I.A. Serebryanaya ◽

S. A. Jamaldinov ◽

F.A. Bataeva ◽

...

Keyword(s):

Functional State ◽

Mineral Fertilizers ◽

Technical Expertise ◽

Technical Documentation ◽

Load Bearing ◽

Building Load

The article describes the features of construction and technical expertise of structures of agricultural warehouse of mineral fertilizers. A draft program for visual and detailed instrumental inspection of building load-bearing structures has been developed. In accordance with the recommendations of the regulatory and technical documentation, measures have been developed to repair and restore the functional state of damaged structures.

Get full-text (via PubEx)

SYNTHESIS OF ELEMENTS OF LOAD-BEARING SYSTEMS WITH A GIVEN LEVEL OF RELIABILITY

STATE AND DEVELOPMENT PROSPECTS OF AGRIBUSINESS. In the frame of the XXIII Agribusiness Forum of the South of Russia and the Exhibition «Interagromash» Volume 1 ◽

10.23947/interagro.2020.1.476-478 ◽

2020 ◽

Author(s):

Y.P. Manshin ◽

◽

E.Yu. Manshina ◽

Keyword(s):

Strain Measurement ◽

Field Strain ◽

Design Element ◽

Load Bearing ◽

Cyclic Bending ◽

Bending Stresses

The article considers an algorithm for analyzing the results of field strain-measurement studies of machine structures, which allows obtaining data for the modernization of elements in the form of coefficients of parameter changes. As the object of application of the method, the design element of the header was selected, which had failures due to insufficient endurance under cyclic bending stresses.

Get full-text (via PubEx)