Recoverable and reusable aluminium solvated species used as a homogeneous catalyst for biodiesel production from brown grease

2015 ◽  
Vol 501 ◽  
pp. 48-55 ◽  
Author(s):  
Carlo Pastore ◽  
Emanuele Barca ◽  
Guido Del Moro ◽  
Antonio Lopez ◽  
Giuseppe Mininni ◽  
...  
2019 ◽  
Author(s):  
Chem Int

Biodiesel produced by transesterification process from vegetable oils or animal fats is viewed as a promising renewable energy source. Now a day’s diminishing of petroleum reserves in the ground and increasing environmental pollution prevention and regulations have made searching for renewable oxygenated energy sources from biomasses. Biodiesel is non-toxic, renewable, biodegradable, environmentally benign, energy efficient and diesel substituent fuel used in diesel engine which contributes minimal amount of global warming gases such as CO, CO2, SO2, NOX, unburned hydrocarbons, and particulate matters. The chemical composition of the biodiesel was examined by help of GC-MS and five fatty acid methyl esters such as methyl palmitate, methyl stearate, methyl oleate, methyl linoleate and methyl linoleneate were identified. The variables that affect the amount of biodiesel such as methanol/oil molar ratio, mass weight of catalyst and temperature were studied. In addition to this the physicochemical properties of the biodiesel such as (density, kinematic viscosity, iodine value high heating value, flash point, acidic value, saponification value, carbon residue, peroxide value and ester content) were determined and its corresponding values were 87 Kg/m3, 5.63 Mm2/s, 39.56 g I/100g oil, 42.22 MJ/Kg, 132oC, 0.12 mgKOH/g, 209.72 mgKOH/g, 0.04%wt, 12.63 meq/kg, and 92.67 wt% respectively. The results of the present study showed that all physicochemical properties lie within the ASTM and EN biodiesel standards. Therefore, mango seed oil methyl ester could be used as an alternative to diesel engine.


2021 ◽  
Author(s):  
Wijittra Wongjaikham ◽  
Doonyapong Wongsawaeng ◽  
Vareeporn Ratnitsai ◽  
Manita Kamjam ◽  
Kanokwan Ngaosuwan ◽  
...  

Abstract Fatty acid methyl esters (FAMEs) are sustainable biofuel that can alleviate high oil cost and environmental impacts of petroleum-based fuel. A modified 1,200 W high efficiency fruit blender was employed for continuous transesterification of various refined vegetable oils and waste cooking oil (WCO) using sodium hydroxide as a homogeneous catalyst. The following factors have been investigated on their effects on FAME yield: baffles, reaction volume, total reactant flow rate, methanol-oil molar ratio, catalyst concentration and reaction temperature. Results indicated that the optimal conditions were: 2,000 mL reaction volume, 50 mL/min total flow rate, 1% and 1.25% catalyst concentration for refined palm oil and WCO, respectively, 6:1 methanol-to-oil molar ratio and 62 - 63oC, obtaining yield efficiency over 96.5% FAME yield of 21.14 ´ 10-4 g.J-1 (for palm oil) and 19.39 ´ 10-4 g.J-1 (for WCO). All the properties of produced FAMEs meet the EN 14214 and ASTM D6751 standards. The modified household fruit blender could be a practical and low-cost alternative biodiesel production apparatus for continuous biodiesel production for small communities in remote areas.


Catalysts ◽  
2020 ◽  
Vol 10 (10) ◽  
pp. 1189 ◽  
Author(s):  
Mirit Kolet ◽  
Daniel Zerbib ◽  
Faina Nakonechny ◽  
Marina Nisnevitch

Among the renewable energy sources is biodiesel. This fuel is usually produced by catalytic transesterification of vegetable oils and animal fats under heating and pressure. Brown grease is a mixture of oils, fats, solids and detergents from food industry wastes that is captured in grease traps. Brown grease is classified as waste and must be treated and disposed of appropriately. It contains oils and fats that can be converted into biodiesel. However, the high concentration of free fatty acids in brown grease does not enable the use of conventional biodiesel production schemes. This study proposes a new scheme for biodiesel production from brown grease. In addition, conditions for the effective separation of a fat phase from brown grease were tested, and the composition of a fatty phase was determined for several grease traps. Esterification and transesterification of brown grease lipids were carried out with methanol, where the Lewis acids BF3 and AlCl3 were used as catalysts and the reaction was activated by ultrasound. The results show that biodiesel can be obtained from brown grease by esterification and transesterification within several minutes under ultrasonic activation at room temperature. These results open prospects for the development of efficient, low-cost and environmentally friendly biodiesel production.


Author(s):  
J. Vaishnavi Sree ◽  
Boddu Akhil Chowdary ◽  
Kottu Santosh Kumar ◽  
Mohana Preethi Anbazhagan ◽  
Sindhu Subramanian

Sign in / Sign up

Export Citation Format

Share Document