Preparation and characterization of biomass carbon-based solid acid catalyst for the esterification of oleic acid with methanol

2013 ◽  
Vol 133 ◽  
pp. 618-621 ◽  
Author(s):  
Tiantian Liu ◽  
Zhilong Li ◽  
Wei Li ◽  
Congjiao Shi ◽  
Yun Wang
2018 ◽  
Vol 156 ◽  
pp. 03002
Author(s):  
Iwan Ridwan ◽  
Mukhtar Ghazali ◽  
Adi Kusmayadi ◽  
Resza Diwansyah Putra ◽  
Nina Marlina ◽  
...  

The oleic acid solubility in methanol is low due to two phase separation, and this causes a slow reaction time in biodiesel production. Tetrahydrofuran as co-solvent can decrease the interfacial surface tension between methanol and oleic acid. The objective of this study was to investigate the effect of co-solvent, methanol to oleic acid molar ratio, catalyst amount, and temperature of the reaction to the free fatty acid conversion. Oleic acid esterification was conducted by mixing oleic acid, methanol, tetrahydrofuran and Amberlyst 15 as a solid acid catalyst in a batch reactor. The Amberlyst 15 used had an exchange capacity of 2.57 meq/g. Significant free fatty acid conversion increments occur on biodiesel production using co-solvent compared without co-solvent. The highest free fatty acid conversion was obtained over methanol to the oleic acid molar ratio of 25:1, catalyst use of 10%, the co-solvent concentration of 8%, and a reaction temperature of 60°C. The highest FFA conversion was found at 28.6 %, and the steady state was reached after 60 minutes. In addition, the use of Amberlyst 15 oleic acid esterification shows an excellent performance as a solid acid catalyst. Catalytic activity was maintained after 4 times repeated use and reduced slightly in the fifth use.


2014 ◽  
Vol 881-883 ◽  
pp. 297-301 ◽  
Author(s):  
Yan Zhi Liu ◽  
Shun Ping Wang ◽  
Kun Yuan ◽  
Huian Tang

The solid acid catalyst (ACSA) for the gutter oil esterification to biodiesel was prepared via active carbon as raw material by introducing the-SO3H group onto the surface of it. The ACSA were characterized by Fourier transform infrared spectroscopy (FT-IR), thermogravimetric analysis (TGA) and elemental analysis (EA), respectively. And the results showed that the-SO3H groups were successfully introduced onto the surface of the active carbon and the containing of the-SO3H groups are higher than 0.017g per gram of ACSA.


2020 ◽  
Vol 32 (6) ◽  
pp. 1404-1408
Author(s):  
Taslim ◽  
Dian Halimah Batubara ◽  
Seri Maulina ◽  
Iriany ◽  
Okta Bani

Cogon grass (Imperata cylindrica) is convertible into glucose by hydrolysis process, which usually requires a catalyst. A solid acid catalyst of sulfonated carbon was used in this work. This study aimed to observe the viability of candlenut shell as carbonaceous source in solid acid catalyst production and to characterize the sulfonated carbon. The carbonization was performed at 250-550 ºC for 4 h, while sulfonation was carried out at 100-180 ºC for 6 h. Sulfonated carbon was then characterized by H+ activity/acid density test, scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDX) and Fourier transform infrared (FTIR) spectroscopy. Sulfonated carbon was then tested as a heterogeneous catalyst for hydrolysis reaction. The reaction was performed in a stainless steel batch reactor at 100 ºC for 6 h. Glucose formed by hydrolysis was measured by dinitrosalicylic acid (DNS) method. Results of this study suggested that sulfonated carbon derived from candlenut shell may be used as a catalyst for cogon grass cellulose hydrolysis to produce glucose


2020 ◽  
Vol 152 ◽  
pp. 320-330 ◽  
Author(s):  
Czarina M. Mendaros ◽  
Alchris W. Go ◽  
Winston Jose T. Nietes ◽  
Babe Eden Joy O. Gollem ◽  
Luis K. Cabatingan

2019 ◽  
Vol 7 (1) ◽  
pp. 55-80 ◽  
Author(s):  
Fatemeh Ghorbani ◽  
Seied Ali Pourmousavi ◽  
Hamzeh Kiyani

Background: Much attention has been focused on heterogeneous catalysts. Reactions with these recoverable and reusable catalysts are clean, selective with high efficiency. Among the heterogeneous solid acid catalyst in organic synthesis, Carbon-Based Solid Acids (CBSAs), which are important solid acid with many practical and research applications have been extensively studied. In this work, green Pistachio peel, a biomass waste, was converted into a novel carbon-based solid acid catalyst (Pis-SO3H). Objective: The aim of this work is to synthesize highly sulfonated carbon as an efficient, recyclable, nontoxic solid acid catalyst by simultaneous sulfonation, dehydration and carbonization of green Pistachio peel as biomass and investigate the catalytic activity of Pis-SO3H in acetalization, thioacetalization, acylation of aldehydes and synthesis of 3,3'-Arylmethylene-bis(4-hydroxycoumarin) derivatives. Method: Pis-SO3H was synthesized by an integrated fast one-step hydrothermal carbonization and sulfonation process in the presence of sulfuric acid. The characterization of the physicochemical properties of Pis-SO3H was achieved by XRD, FT-IR, FE-SEM, and elemental analysis. Results: The result of acid-base titration showed that the total acidity of the catalyst was 7.75 mmol H+g−1. This new heterogeneous catalyst has been efficiently used for the chemoselective thioacetalization, acetalization and acylation of aldehyde and the synthesis of biscoumarins under solvent-free conditions. All the reactions work easily in high yields. The antimicrobial activity of some of the biscoumarins was evaluated in screening by disk diffusion assay for the zone of inhibition. Conclusion: The catalytic activity of the Pis-SO3H was investigated during acetalization, thioacetalization, acylation and synthesis of biscoumarins. The results of protection of carbonyl groups and synthesis of biscoumarins in the present work offer effective alternatives for environmentally friendly utilization of abundant biomass waste.


Sign in / Sign up

Export Citation Format

Share Document