scholarly journals Experimental optimization of engine performance of a dual-fuel compression-ignition engine operating on hydrogen-compressed natural gas and Moringa biodiesel

2021 ◽  
Vol 7 ◽  
pp. 607-619
Author(s):  
Babalola Aisosa Oni ◽  
Samuel Eshorame Sanni ◽  
Anayo Jerome Ibegbu ◽  
Ameloko Anthony Aduojo
Author(s):  
Liu Shenghua ◽  
Wang Ziyan ◽  
Ren Jiang

A natural gas and diesel dual-fuel turbocharged compression ignition (CI) engine is developed to reduce emissions of a heavy-duty diesel engine. The compressed natural gas (CNG) pressure regulator is specially designed to feed back the boost pressure to simplify the fuel metering system. The natural gas bypass improves the engine response to acceleration. The modes of diesel injection are set according to the engine operating conditions. The application of honeycomb mixers changes the flowrate shape of natural gas and reduces hydrocarbon (HC) emission under low-load and lowspeed conditions. The cylinder pressures of a CI engine fuelled with diesel and dual fuel are analysed. The introduction of natural gas makes the ignition delay change with engine load. Under the same operating conditions, the emissions of smoke and NOx from the dual-fuel engine are both reduced. The HC and CO emissions for the dual-fuel engine remain within the range of regulation.


Author(s):  
N. T. Shoemaker ◽  
C. M. Gibson ◽  
A. C. Polk ◽  
S. R. Krishnan ◽  
K. K. Srinivasan

Different combustion strategies and fuel sources are needed to deal with increasing fuel efficiency demands and emission restrictions. One possible strategy is dual fueling using readily available resources. Propane and natural gas are readily available with the current infrastructure and biodiesel is growing in popularity as a renewable fuel. This paper presents experimental results from dual fuel combustion of methane (as a surrogate for natural gas) and propane as primary fuels with biodiesel pilots in a 1.9 liter, turbocharged, 4-cylinder compression ignition engine at 1800 rev/min. Experiments were performed with different percentage energy substitutions (PES) of propane and methane and at different brake mean effective pressures (BMEP/bmep). Brake thermal efficiency (BTE) and emissions (NOx, HC, CO, CO2, O2 and smoke) were also measured. Maximum PES levels for B100-methane dual fueling were limited to 70% at 2.5 bars bmep and 48% at 10 bars bmep, and corresponding values for B100-propane dual fueling were 64% and 43%, respectively. Maximum PES was limited by misfire at 2.5 bars bmep and the onset of engine knock at 10 bars bmep. Dual fuel BTEs approached straight B100 values at 10 bars bmep while they were significantly lower than B100 values at 2.5 bars bmep. In general, dual fueling was beneficial in reducing NOx and smoke emissions by 33% and 50%, respectively, from baseline B100 levels; however, both CO and THC emissions were significantly higher than baseline B100 levels at all PES and loads.


Transport ◽  
2015 ◽  
Vol 30 (2) ◽  
pp. 162-171 ◽  
Author(s):  
Maciej Mikulski ◽  
Sławomir Wierzbicki

Currently, one of the major trends in the research of contemporary combustion engines involves the potential use of alternative fuels. Considerable attention has been devoted to methane, which is the main component of Natural Gas (NG) and can also be obtained by purification of biogas. In compression-ignition engines fired with methane or Compressed Natural Gas (CNG), it is necessary to apply a dual-fuel feeding system. This paper presents the effect of the proportion of CNG in a fuel dose on the process of combustion. The recorded time series of pressure in a combustion chamber was used to determine the repeatability of the combustion process and the change of fuel compression-ignition delay in the combustion chamber. It has been showed that NG does not burn completely in a dual-fuel engine. The best conditions for combustion are ensured with higher concentrations of gaseous fuel. NG ignition does not take place simultaneously with diesel oil ignition. Moreover, if a divided dose of diesel is injected, NG ignition probably takes place at two points, as diesel oil.


Mechanika ◽  
2021 ◽  
Vol 27 (6) ◽  
pp. 492-497
Author(s):  
Dariusz SZPICA ◽  
Marcin DZIEWIĄTKOWSKI

Further restrictions on the use of compression-ignition engines in transportation are prompting the search for adaptations to run on other fuels. One of the most popular alternative fuels is Compressed Natural Gas (CNG), which due to its low carbon content can be competitive with classical fuels. This paper presents the results of testing a Cummins 6BT compression ignition engine that has undergone numerous modifications to convert to CNG power. The sequential gas injection system and the ignition system were installed in this engine. The compression ratio was also lowered from 16.5 to 11.5 by replacing the pistons. Tests conducted on an engine dynamometer were to show the differences in emission and conversion in the catalyst of hydrocarbons contained in the exhaust gases. Two structurally different catalysts operating at different exhaust temperatures (400 and 500)±2.5°C were used. The catalyst operating at 500±2.5°C showed a 23.5% higher conversion rate than the catalyst operating at a lower temperature in the range of the speed range tested. Also the external indicators, such as power and torque for the case of higher operating temperature took values over 70% higher. The research is one of the stages of a comprehensive assessment of the possibility of adaptation of compression ignition engines to CNG-only fueling.


Sign in / Sign up

Export Citation Format

Share Document