scholarly journals EFFECT OF CNG IN A FUEL DOSE ON THE COMBUSTION PROCESS OF A COMPRESSION-IGNITION ENGINE

Transport ◽  
2015 ◽  
Vol 30 (2) ◽  
pp. 162-171 ◽  
Author(s):  
Maciej Mikulski ◽  
Sławomir Wierzbicki
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Alternative Fuels ◽  
Combustion Process ◽  
Diesel Oil ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Compression Ignition Engines ◽  
Main Component

Currently, one of the major trends in the research of contemporary combustion engines involves the potential use of alternative fuels. Considerable attention has been devoted to methane, which is the main component of Natural Gas (NG) and can also be obtained by purification of biogas. In compression-ignition engines fired with methane or Compressed Natural Gas (CNG), it is necessary to apply a dual-fuel feeding system. This paper presents the effect of the proportion of CNG in a fuel dose on the process of combustion. The recorded time series of pressure in a combustion chamber was used to determine the repeatability of the combustion process and the change of fuel compression-ignition delay in the combustion chamber. It has been showed that NG does not burn completely in a dual-fuel engine. The best conditions for combustion are ensured with higher concentrations of gaseous fuel. NG ignition does not take place simultaneously with diesel oil ignition. Moreover, if a divided dose of diesel is injected, NG ignition probably takes place at two points, as diesel oil.

Experimental Study on Low Temperature Combustion Dual Fuel Biodiesel/Natural Gas Engine

2015 ◽  
Author(s):  
A. Gharehghani ◽  
M. Mirsalim ◽  
A. Jazayeri ◽  
R. Hosseini
Keyword(s):  
Diesel Engine ◽  
Low Temperature ◽  
Natural Gas ◽  
Alternative Fuels ◽  
Combustion Process ◽  
Dual Fuel ◽  
Low Temperature Combustion ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Temperature Combustion

Low Temperature combustion (LTC) strategies are capable of simultaneous reduction in NOx and particulate matter (PM) emissions. However, this combustion process generally leads to higher HC and CO emissions together with more cyclic variation (unstable combustion) especially at light engine loads. These emissions could drastically be reduced using certain alternative fuels like natural gas and biodiesel in LTC or PCI combustion engines. In the present research, a single cylinder compression ignition engine has been modified to operate in dual fuel mode with natural gas injection into the intake manifold as the main fuel and biodiesel as the pilot fuel to ignite the gas/air mixture. The combustion characteristics, engine performance and exhaust emissions of the reactivity controlled compression ignition (RCCI) dual fueled CNG/biodiesel engine are investigated and compared with the conventional diesel engine mode at various load conditions. The analysis of the results revealed that biodiesel as the high reactivity fuel in RCCI mode leads to higher in-cylinder pressure together with shorter heat release rate duration, compared to the common diesel engine. Experimental results indicated that combining the low temperature combustion concept and alternative fuels (e.g. biodiesel and naturals gas) causes lower levels of unburned hydrocarbon (UHC) and carbon monoxide (CO) as well as nitrogen oxide (NOx) emissions.

scholarly journals Hydroxyl radicals as an indicator of knocking combustion in the dual-fuel compression-ignition engine

2017 ◽  
Vol 168 (1) ◽  
pp. 178-185
Author(s):  
Jakub LASOCKI ◽  
Piotr ORLIŃSKI ◽  
Marcin WOJS ◽  
Marlena OWCZUK ◽  
Anna MATUSZEWSKA
Keyword(s):  
Combustion Chamber ◽  
Hydroxyl Radicals ◽  
Current Knowledge ◽  
Combustion Process ◽  
Diesel Oil ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Working Medium ◽  
Engine Components

The occurrence of knocking combustion is one of the basic problems of dual-fuel compression-ignition engines supplied with diesel oil and gaseous fuel. In order to detect this phenomenon and evaluate its intensity, several methods are commonly used, including the analysis of pressure of working medium in the combustion chamber of the engine or vibrations of certain engine components. This paper discusses the concept of using mass fraction of hydroxyl radicals as the indicator of the occurrence of knocking combustion. Current knowledge on the conditions of hydroxyl radical formation in the engine combustion chamber has been systematized and the results of research on this subject have been presented. Theoretical considerations are illustrated by exemplary results of simulation studies of the combustion process in a dual-fuel compression-ignition engine supplied with diesel oil and methane. The conclusions drawn may be -useful for the development of dual-fuel engine control systems.

scholarly journals Catalyst Conversion Rates Measurement on Engine Fueled with Compressed Natural Gas (CNG) Using Different Operating Temperatures

Mechanika ◽  
2021 ◽  
Vol 27 (6) ◽  
pp. 492-497
Author(s):  
Dariusz SZPICA ◽  
Marcin DZIEWIĄTKOWSKI
Keyword(s):  
Natural Gas ◽  
Alternative Fuels ◽  
Injection System ◽  
Compression Ignition ◽  
Low Carbon ◽  
Compression Ignition Engine ◽  
Compressed Natural Gas ◽  
Compression Ignition Engines ◽  
Conversion Rates ◽  
Lower Temperature

Further restrictions on the use of compression-ignition engines in transportation are prompting the search for adaptations to run on other fuels. One of the most popular alternative fuels is Compressed Natural Gas (CNG), which due to its low carbon content can be competitive with classical fuels. This paper presents the results of testing a Cummins 6BT compression ignition engine that has undergone numerous modifications to convert to CNG power. The sequential gas injection system and the ignition system were installed in this engine. The compression ratio was also lowered from 16.5 to 11.5 by replacing the pistons. Tests conducted on an engine dynamometer were to show the differences in emission and conversion in the catalyst of hydrocarbons contained in the exhaust gases. Two structurally different catalysts operating at different exhaust temperatures (400 and 500)±2.5°C were used. The catalyst operating at 500±2.5°C showed a 23.5% higher conversion rate than the catalyst operating at a lower temperature in the range of the speed range tested. Also the external indicators, such as power and torque for the case of higher operating temperature took values over 70% higher. The research is one of the stages of a comprehensive assessment of the possibility of adaptation of compression ignition engines to CNG-only fueling.

scholarly journals Combustion Stability, Performance and Emission Characteristics of a CI Engine Fueled with Diesel/n-Butanol Blends

Energies ◽  
2021 ◽  
Vol 14 (10) ◽  
pp. 2817
Author(s):  
Arkadiusz Jamrozik ◽  
Wojciech Tutak ◽  
Karol Grab-Rogaliński
Keyword(s):  
Alternative Fuels ◽  
Specific Energy Consumption ◽  
Combustion Process ◽  
Combustion Stability ◽  
Dual Fuel ◽  
Initial Increase ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Engine Operation ◽  
Energy Share

The development of compression ignition engines depends mainly on using alternative fuels, such as alcohols. The paper presents the results of tests of a stationary compression ignition engine fueled with mixtures of diesel oil and n-butanol with an energy share from 0 to 60%. The combustion and emission results of a dual-fuel engine were compared to a conventional diesel-only engine. As part of the work, the combustion process, including changes in pressure and heat release rate, as well as exhaust emissions from the test engine, were investigated. The main operational parameters of the engine were determined, including mean indicated pressure, thermal efficiency and specific energy consumption. Moreover, the stability of the engine operation was analyzed. The research shows that the 60% addition of n-butanol to diesel fuel increases the ignition delay (by 39%) and shortens the combustion duration (by 57%). In addition, up to 40%, it results in increased pmax, HRRmax and PPRmax. The engine was characterized by the highest efficiency, equal to 41.35% when operating on DB40. In the whole range of alcohol content, the dual-fuel engine was stable. With the increase of n-butanol content to 40%, the emission of NOx increased. The lowest concentration of CO was obtained during the combustion of DB50. After the initial increase (for DB20), the THC emission was reduced to the lowest value for DB40. Increasing the energy share of alcohol to 60% resulted in a significant, more than 43 times, reduction in soot emissions.

scholarly journals A dual-fuel compression ignition engine – distinctive features

2010 ◽  
Vol 141 (2) ◽  
pp. 33-39
Author(s):  
Sławomir LUFT
Keyword(s):  
Internal Combustion Engines ◽  
Combustion Process ◽  
Diesel Oil ◽  
Gas Analysis ◽  
Exhaust Emission ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Spark Ignition Engines ◽  
Compression Ignition Engine ◽  
Distinctive Features

For many years in the Department of Automobiles and Internal Combustion Engines in Technical University of Radom there are carried out investigations on dual-fuel compression ignition engine in which the ignition is initiated by a pilot diesel oil dose and the applied main fuels have properties similar to those applied in spark ignition engines. The tested fuels were methanol, ethanol, LPG and natural gas. Analysis of the obtained results allowed to make some generalizations and to determine advantages as well as problems which should be solved for higher efficiency, power and durability. The paper will present information on efficiency, power, toxic exhaust emission and chosen parameters of combustion process of a dual-fuel compression ignition engine as well as on a difficult to control – knock combustion which may result in lower engine durability and piston crank mechanism failure.

scholarly journals Numerical and Experimental Investigation of Combustion and Knock in a Dual Fuel Gas/Diesel Compression Ignition Engine

2012 ◽  
Vol 2012 ◽  
pp. 1-10 ◽  
Author(s):  
A. Gharehghani ◽  
S. M. Mirsalim ◽  
S. A. Jazayeri
Keyword(s):  
Natural Gas ◽  
Diesel Oil ◽  
Combustion Characteristic ◽  
Simultaneous Increase ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Swirl Ratio ◽  
Characteristic Analysis ◽  
Mode Of Operation ◽  
Intake Pressure

Conventional compression ignition engines can easily be converted to a dual fuel mode of operation using natural gas as main fuel and diesel oil injection as pilot to initiate the combustion. At the same time, it is possible to increase the output power by increasing the diesel oil percentage. A detailed performance and combustion characteristic analysis of a heavy duty diesel engine has been studied in dual fuel mode of operation where natural gas is used as the main fuel and diesel oil as pilot. The influence of intake pressure and temperature on knock occurrence and the effects of initial swirl ratio on heat release rate, temperature-pressure and emission levels have been investigated in this study. It is shown that an increase in the initial swirl ratio lengthens the delay period for auto-ignition and extends the combustion period while it reduces NOx. There is an optimum value of the initial swirl ratio for a certain mixture intake temperature and pressure conditions that can achieve high thermal efficiency and low NOxemissions while decreases the tendency to knock. Simultaneous increase of intake pressure and initial swirl ratio could be the solution to power loss and knock in dual fuel engine.

Phenomenological Modeling of Combustion in Pre-Chamber and the Pilot Flame for Natural Gas Engines

2019 ◽  
Author(s):  
Long Liu ◽  
Xia Wen ◽  
Qian Xiong ◽  
Xiuzhen Ma
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Alternative Fuels ◽  
Gas Flow ◽  
Combustion Process ◽  
Clean Energy ◽  
Combustion Model ◽  
Flame Surface ◽  
Flow Process ◽  
Natural Gas Engines

Abstract With energy shortages and increasing environmental problems, natural gas, as a clean energy, has the advantages of cheap price and large reserves and has become one of the main alternative fuels for marine diesel engines. For large bore natural gas engines, pre-chamber spark plug ignition can be used to increase engine efficiency. The engine mainly relies on the flame ejected from the pre-chamber to ignite the mixture of natural gas and air in the main combustion chamber. The ignition flame in the main combustion chamber is the main factor affecting the combustion process. Although the pre-chamber natural gas engines have been extensively studied, the characteristics of combustion in the pre-chamber and the development of ignition flame in the main combustion chamber have not been fully understood. In this study, a two-zone phenomenological combustion model of pre-chamber spark-ignition natural gas engines is established based on the exchange of mass and energy of the gas flow process in the pre-chamber and the main combustion chamber. The basic characteristics of the developed model are: a spherical flame surface is used to describe the combustion state in the pre-chamber, and according to the turbulent jet theory, the influence of turbulence on the state of the pilot flame is considered based on the Reynolds number. According to the phenomenological model, the time when the flame starts to be injected from the pre-chamber to the main combustion chamber, and the parameters such as the length of the pilot flame are analyzed. The model was verified by experimental data, and the results showed that the calculated values were in good agreement with the experimental values. It provides an effective tool for mastering the law of flame development and supporting the optimization of combustion efficiency.

Sign in / Sign up

Export Citation Format

Share Document