scholarly journals Analysis of natural gas flow reversal in integrated energy system based on dynamic simulation

2021 ◽  
Vol 7 ◽  
pp. 1149-1158
Author(s):  
Jiang Zhai ◽  
Xiaoxin Zhou ◽  
Yalou Li
2020 ◽  
Vol 12 (20) ◽  
pp. 8320
Author(s):  
Mohammad Hemmati ◽  
Mehdi Abapour ◽  
Behnam Mohammadi-Ivatloo ◽  
Amjad Anvari-Moghaddam

Coordinated multi-carrier energy systems with natural gas and electricity energies provide specific opportunities to improve energy efficiency and flexibility of the energy supply. The interdependency of electricity and natural gas networks faces multiple challenges from power and gas flow in corresponding feeders and pipes and connection points between two infrastructures’ points of view. However, the energy hub concepts as the fundamental concept of multi-carrier energy systems with multiple conversion, storage, and generation facilities can be considered as a connection point between electricity and gas grids. Hence, this paper proposes an optimal operation of coordinated gas and electricity distribution networks by considering interconnected energy hubs. The proposed energy hub is equipped with combined heat and power units, a boiler, battery energy storage, a heat pump, and a gas-fired unit to meet the heating and electrical load demands. The proposed model is formulated as a two-stage scenario-based stochastic model aiming to minimize total operational cost considering wind energy, electrical load, and real-time power price uncertainties. The proposed integrated energy system can participate in real-time and day-ahead power markets, as well as the gas market, to purchase its required energy. The AC-power flow and Weymouth equation are extended to describe power and gas flow in feeders and gas pipelines, respectively. Therefore, a realistic model for the integrated electricity and gas grids considering coupling constraints is satisfied. The proposed model is tested on the integrated energy system and consists of a 33-bus electrical network and a 6-node gas grid with multiple interconnected energy hubs, where the numerical results reveal the effectiveness of the proposed model.


Author(s):  
Xue Li ◽  
Guoda Tian ◽  
Qingxin Shi ◽  
Tao Jiang ◽  
Fangxing Li ◽  
...  

1989 ◽  
Vol 111 (1) ◽  
pp. 22-33
Author(s):  
V. C. Ting ◽  
J. J. S. Shen

This paper presents the orifice calibration results for nominal 15.24, 10.16, and 5.08-cm (6, 4, 2-in.) orifice meters conducted at the Chevron’s Sand Hills natural gas flow measurement facility in Crane, Texas. Over 200 test runs were collected in a field environment to study the accuracy of the orifice meters. Data were obtained at beta ratios ranging from 0.12 to 0.74 at the nominal conditions of 4576 kPa and 27°C (650 psig and 80°F) with a 0.57 specific gravity processed, pipeline quality natural gas. A bank of critical flow nozzles was used as the flow rate proving device to calibrate the orifice meters. Orifice discharge coefficients were computed with ANSI/API 2530-1985 (AGA3) and ISO 5167/ASME MFC-3M-1984 equations for every set of data points. The uncertainty of the calibration system was analyzed according to The American National Standard (ANSI/ASME MFC-2M-A1983). The 10.16 and 5.08-cm (4 and 2-in.) orifice discharge coefficients agreed with the ANSI and ISO standards within the estimated uncertainty level. However, the 15.24-cm (6-in.) meter deviated up to − 2 percent at a beta ratio of 0.74. With the orifice bore Reynolds numbers ranging from 1 to 9 million, the Sand Hills calibration data bridge the gap between the Ohio State water data at low Reynolds numbers and Chevron’s high Reynolds number test data taken at a larger test facility in Venice, Louisiana. The test results also successfully demonstrated that orifice meters can be accurately proved with critical flow nozzles under realistic field conditions.


Energy Policy ◽  
2017 ◽  
Vol 106 ◽  
pp. 288-297 ◽  
Author(s):  
Maaike C. Bouwmeester ◽  
J. Oosterhaven

2013 ◽  
Vol 15 ◽  
pp. 27-37 ◽  
Author(s):  
Mahmood Farzaneh-Gord ◽  
Hamid Reza Rahbari ◽  
Mahdi Bajelan ◽  
Lila Pilehvari

Author(s):  
Nataliia Fialko ◽  
◽  
Julii Sherenkovskiy ◽  
Nataliia Meranova ◽  
Serhii Aloshko ◽  
...  

For microjet burners of the stabilizer type, a study of the regularities of the natural gas flow in the inner cavity of the flame stabilizer has been carried out. A comparative analysis of the features of heat transfer from the inner surfaces of the stabilizer walls is carried out for two variants of its configuration: flat and in the presence of trapezoidal niches on its lateral surfaces.


2011 ◽  
Vol 31 (14-15) ◽  
pp. 2605-2615 ◽  
Author(s):  
Hee Bum Lee ◽  
Bum Jin Park ◽  
Shin Hyung Rhee ◽  
Jun Hong Bae ◽  
Kyung Won Lee ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document