Assessing the potential for biofuel production of corn stover pyrolysis using a pressurized batch reactor

Fuel ◽  
2012 ◽  
Vol 95 ◽  
pp. 563-572 ◽  
Author(s):  
Jewel A. Capunitan ◽  
Sergio C. Capareda
BioResources ◽  
2020 ◽  
Vol 15 (4) ◽  
pp. 8662-8676
Author(s):  
Maria Mushtaq ◽  
Muhammad Javaid Asad ◽  
Muhammad Zeeshan Hyder ◽  
Syed Muhammad Saqlan Naqvi ◽  
Saad Imran Malik ◽  
...  

Utilization of biomass for production of second generation bioethanol was considered as a way to reduce burdens of fossil fuel in Pakistan. The materials wheat straw, rice straw, cotton stalk, corn stover, and peel wastes were used in this experiment. Various parameters, such as acidic and alkali pretreatment, enzymatic hydrolysis by cellulases, and effect of proteases inhibitors on ethanol production, were examined. Fermentation was completed by the yeasts Saccharomyces cerevisiae and Clostridium thermocellum separately, and their ethanol production were compared and maximum ethanol yield was obtained with wheat straw i.e.,11.3 g/L by S. cerevisiae and 8.5 g/L by C. thermocellum. Results indicated that a higher quantity of sugar was obtained from wheat straw (19.6 ± 1.6 g/L) followed by rice straw (17.6 ± 0.6 g/L) and corn stover (16.1 ± 0.9 g/L) compared to the other evaluated biomass samples. A higher yield of ethanol (11.3 g/L) was observed when a glucose concentration of 21.7 g/L was used, for which yeast fermentation efficiency was 92%. Results also revealed the increased in ethanol production (93%) by using celluases in combination with recombinant Serine protease inhibitors from C. thermocellum. It is expected that the use of recombinant serpins with cellulases will play a major role in the biofuel production by using agricultural biomass. This will also help in the economics of the biofuel.


2012 ◽  
Vol 47 ◽  
pp. 372-386 ◽  
Author(s):  
Zhengxi Tan ◽  
Shuguang Liu ◽  
Norman Bliss ◽  
Larry L. Tieszen

Fuel ◽  
2016 ◽  
Vol 168 ◽  
pp. 1-6 ◽  
Author(s):  
Zhengbo Yue ◽  
Ding Ma ◽  
Shuchuan Peng ◽  
Xiang Zhao ◽  
Tianhu Chen ◽  
...  

2017 ◽  
Vol 4 (4) ◽  
pp. 721-729 ◽  
Author(s):  
Jonathan Ranisau ◽  
Emmanuel Ogbe ◽  
Aaron Trainor ◽  
Mohammed Barbouti ◽  
Mohamed Elsholkami ◽  
...  

2020 ◽  
Vol 841 ◽  
pp. 150-154
Author(s):  
Thirada Rodseanglung ◽  
Tanakorn Ratana ◽  
Monrudee Phongaksorn ◽  
Sabaithip Tungkamani

This research focus on catalytic hydrotreating of Jatropha Bio-oil derived fast pyrolysis into biofuel was investigated to determine the effects of the supported type (Al2O3 TiO2 and Al2O3-TiO2 mix-oxide) and of the variables temperature (300-340 °C). The synthesized catalysts were prepared by sol-gel method for support and wet-impregnation with solution promoter on support, and characterization by BET NH3-TPD XRD and NO-TPD for active site analysis of catalysts. The reaction was carried out in a Parr batch reactor under H2 atmosphere about 50 bar for 2 h. The catalytic activity was evaluated for % fatty acid conversion (%FFA), %HDO, %selective to paraffin/olefin products. The results showed that the CMA gave the %FFA is highest, but low selective products, then the CMT gave the % HDO high than CMA, while the mixed-oxide were proving the %HDO, %FFA conversion and % selective is increasing because the TiO2 incorporated with Al2O3 effect to increase the amount of rim site, it’s active site for HYD partway.


2014 ◽  
Vol 108 ◽  
pp. 248-253 ◽  
Author(s):  
Shoujie Ren ◽  
Hanwu Lei ◽  
Lu Wang ◽  
Gayatri Yadavalli ◽  
Yupeng Liu ◽  
...  

2021 ◽  
Vol 64 (1) ◽  
pp. 161-175
Author(s):  
Joshua J. Jackson ◽  
Michael D. Montross

HighlightsTotal transportation costs were reduced by 32% to 63% with distributed biobutanol depots.An 8 km distance to the depot manifested the most desirable transportation costs.Across regions, biomass transport costs from field to depot were similar at equivalent distances.Abstract. The transportation efficiencies of centralized biomass processing facilities were compared to a proposed distributed preprocessing network with centralized refining facilities. Centralized biomass processing was defined as transport of baled corn stover directly from the field to the refinery. Distributed preprocessing with centralized refining was defined as transport of baled corn stover from the field to a biobutanol preprocessing depot and transport of completely dewatered crude biobutanol solution from the depot to a centralized refinery. For both systems, the locations of the corn fields, as identified through the cropland data layer, and of the refinery were fixed. For the distributed system, the biobutanol depot locations were variable and depended on different maximum transport distances (8 to 80 km) from the field to the depot. In this case study, site-specific transportation costs and biobutanol production capacities were developed for different agricultural regions in Kentucky. The distributed system produced a 32% to 63% reduction in total transportation cost with decreased (50% to 90%) fuel use as compared to the centralized system. The GIS transportation model demonstrated that on-farm biofuel production could be an effective means of producing biofuel and reducing transportation costs. Keywords: Biomass transport, Depot, Distributed biomass collection, GIS location-allocation, Minimize facilities, Satellite facilities.


Sign in / Sign up

Export Citation Format

Share Document