Introduction (problem statement and relevance). Now it is difficult to imagine the automotive industry without constant improvement of the power plant. This is due to the constant tightening of environmental standards, so in environmental standards Euro 6 there is a limit of the countable concentration of particulate matters. To meet the Euro 6 environmental standard, vehicle manufacturers use catalytic converters, and gasoline particle filters (GPF). These methods of reducing the emissions of the exhaust gas are quite common, but they also have a limitation on the service life. The use of only catalytic converters and GPF may not be sufficient to meet the Euro 7 standards in the future. So, there is a need to reduce emissions with exhaust gases by improving the combustion process.The purpose of work is to investigate the combustion process of a turbocharged gasoline direct injection engine to reduce particulate matter by increasing the injection pressure and optimizing the injection timing. Methodology and research methods. The studies are of an experimental nature, the reliability of the data is confirmed by the use of modern measuring equipment and post processing of the measured data. Scientific novelty and results. The fuel injection parameters, which have a significant influence on the particulate matter formation and oxidation are defined.Practical significance. The recommendations to reduce particulate matter formation and to meet the requirements of the future Euro standards are given.
