Property change of bagasse as cell-immobilizing carrier and coproduction of hydrogen-butanol in fixed-bed reactor by repeated cycle fermentation

The relationship between the filter media and the behaviour of anaerobic bacteria was studied using anaerobic fixed-bed reactors. At an HRT of 48 hours, the number of suspended acidogenic bacteria was higher than those attached to the filter media. On the other hand, the number of attached methanogenic bacteria was more than ten times as higher than that of suspended ones. The numbers of suspended and deposited acidogenic and methanogenic bacteria in the reactor operated at an HRT of 3 hours were almost the same as those in the reactor operated at an HRT of 48 hours. Accumulation of attached bacteria was promoted by decreasing the HRT of the reactor. The number of acidogenic bacteria in the reactor packed sparsely with the filter media was higher than that in the closely packed reactor. The number of methanogenic bacteria in the sparsely packed reactor was lower than that in the closely packed reactor.

Download Full-text

Modeling of aerated upflow fixed bed reactors for nitrification

Water Science & Technology ◽

10.2166/wst.1999.0193 ◽

1999 ◽

Vol 39 (4) ◽

pp. 85-92 ◽

Cited By ~ 7

Author(s):

J. Behrendt

Keyword(s):

Mathematical Model ◽

Mass Transfer ◽

Liquid Phase ◽

Gas Phase ◽

Fixed Bed ◽

Fixed Bed Reactor ◽

Bulk Liquid ◽

Initial Value ◽

Fixed Bed Reactors ◽

Number Of Cells

A mathematical model for nitrification in an aerated fixed bed reactor has been developed. This model is based on material balances in the bulk liquid, gas phase and in the biofilm area. The fixed bed is divided into a number of cells according to the reduced remixing behaviour. A fixed bed cell consists of 4 compartments: the support, the gas phase, the bulk liquid phase and the stagnant volume containing the biofilm. In the stagnant volume the biological transmutation of the ammonia is located. The transport phenomena are modelled with mass transfer formulations so that the balances could be formulated as an initial value problem. The results of the simulation and experiments are compared.

Download Full-text

Design of a continuous flow immobilized-cell reactor for biosynthetical production of L-aspartic acid

Collection of Czechoslovak Chemical Communications ◽

10.1135/cccc19852122 ◽

1985 ◽

Vol 50 (10) ◽

pp. 2122-2133 ◽

Cited By ~ 2

Author(s):

Jindřich Zahradník ◽

Marie Fialová ◽

Jan Škoda ◽

Helena Škodová

Keyword(s):

Aspartic Acid ◽

Continuous Flow ◽

Immobilized Cells ◽

Scale Up ◽

Fixed Bed ◽

Packed Bed ◽

Fixed Bed Reactor ◽

Experimental Program ◽

Design Parameters ◽

Immobilized Cell

An experimental study was carried out aimed at establishing a data base for an optimum design of a continuous flow fixed-bed reactor for biotransformation of ammonium fumarate to L-aspartic acid catalyzed by immobilized cells of the strain Escherichia alcalescens dispar group. The experimental program included studies of the effect of reactor geometry, catalytic particle size, and packed bed arrangement on reactor hydrodynamics and on the rate of substrate conversion. An expression for the effective reaction rate was derived including the effect of mass transfer and conditions of the safe conversion-data scale-up were defined. Suggestions for the design of a pilot plant reactor (100 t/year) were formulated and decisive design parameters of such reactor were estimated for several variants of problem formulation.

Download Full-text

Bio-Oil Characterizations of Spirulina Platensis Residue (SPR) Pyrolysis Products for Renewable Energy Development

Key Engineering Materials ◽

10.4028/www.scientific.net/kem.849.47 ◽

2020 ◽

Vol 849 ◽

pp. 47-52

Author(s):

Siti Jamilatun ◽

Aster Rahayu ◽

Yano Surya Pradana ◽

Budhijanto ◽

Rochmadi ◽

...

Keyword(s):

Renewable Energy ◽

Spirulina Platensis ◽

Pyrolysis Temperature ◽

Renewable Energy Sources ◽

Fixed Bed ◽

Fixed Bed Reactor ◽

Oil Yield ◽

Optimum Temperature ◽

Pyrolysis Products ◽

Bio Oil

Nowadays, energy consumption has increased as a population increases with socio-economic developments and improved living standards. Therefore, it is necessary to find a replacement for fossil energy with renewable energy sources, and the potential to develop is biofuels. Bio-oil, water phase, gas, and char products will be produced by utilizing Spirulina platensis (SPR) microalgae extraction residue as pyrolysis raw material. The purpose of this study is to characterize pyrolysis products and bio-oil analysis with GC-MS. Quality fuel is good if O/C is low, H/C is high, HHV is high, and oxygenate compounds are low, but aliphatic and aromatic are high. Pyrolysis was carried out at a temperature of 300-600°C with a feed of 50 grams in atmospheric conditions with a heating rate of 5-35°C/min, the equipment used was a fixed-bed reactor. The higher the pyrolysis temperature, the higher the bio-oil yield will be to an optimum temperature, then lower. The optimum temperature of pyrolysis is 550°C with a bio-oil yield of 23.99 wt%. The higher the pyrolysis temperature, the higher the H/C, the lower O/C. The optimum condition was reached at a temperature of 500°C with the values of H/C, and O/C is 1.17 and 0.47. With an increase in temperature of 300-600°C, HHV increased from 11.64 MJ/kg to 20.63 MJ/kg, the oxygenate compound decreased from 85.26 to 37.55 wt%. Aliphatics and aromatics increased, respectively, from 5.76 to 36.72 wt% and 1.67 to 6.67 wt%.

Download Full-text