scholarly journals Solvent-free mechanochemical synthesis and X-ray studies of Cu(II) and Ni(II) complexes of 5-(3,4,5-Trimethoxybenzyl)pyrimidine-2,4-diamine (Trimethoprim) in a ball-mill

2016 ◽  
Vol 20 ◽  
pp. S376-S381 ◽  
Author(s):  
Adedibu C. Tella ◽  
Uche B. Eke ◽  
Samson O. Owalude
2016 ◽  
Vol 12 ◽  
pp. 2364-2371 ◽  
Author(s):  
Laszlo Jicsinszky ◽  
Marina Caporaso ◽  
Katia Martina ◽  
Emanuela Calcio Gaudino ◽  
Giancarlo Cravotto

A number of per-6-substituted cyclodextrin derivative syntheses have been effectively carried out in a planetary ball mill under solvent-free conditions. The preparation of Bridion® and important per-6-amino/thiocyclodextrin intermediates without polar aprotic solvents, a source of byproducts and persistent impurities, could be performed. Isolation and purification processes could also be simplified. Considerably lower alkylthiol/halide ratio were necessary to reach the complete reaction in comparison with thiourea or azide reactions. While the presented mechanochemical syntheses were carried out on the millimolar scale, they are easily scalable.


2012 ◽  
Vol 44 (3) ◽  
pp. 331-339 ◽  
Author(s):  
Z.Z. Lazarevic ◽  
C. Jovalekic ◽  
D. Sekulic ◽  
M. Slankamenac ◽  
M. Romcevic ◽  
...  

Powdery nickel ferrite, NiFe2O4 has been obtained by soft mechanochemical synthesis in a planetary ball mill. Ni(OH)2 and Fe(OH)3 are used as initial compounds. This mixture was mechanically activated for 25h, uniaxial pressed and sintered at 1100?C for 2h. The phase composition of the sintered sample was analyzed by X-ray diffraction (XRD), energy dispersive spectrometer (EDS) and Raman spectroscopy. Morphologies were examined by scanning electron microscopy (SEM). The electrical DC/resistivity/conductivity at different temperatures was measured using a Source Meter Keithley 2410. An Impedance/Gain-Phase Analyzer (HP-4194) was used to measure the impedance spectra (100Hz - 10MHz) at different temperatures.


2012 ◽  
Vol 10 (6) ◽  
pp. 1907-1912
Author(s):  
Joana Zaharieva ◽  
Maria Milanova ◽  
Dimitar Todorovsky

AbstractThe paper considers the possibilities for mechanochemical synthesis of rare earth complexes. The complex Eu(TTA)3·phen (HTTA — 2-thenoyltrifluoroacetone, phen — 1,10-phenanthroline) is synthesized by mechanical treatment of a mixture of EuCl3.6H2O, HTTA, phen and NaOH in planetary ball mill Pulverisette 7 for 30 min at 800 min−1. The non reacted starting reagents and reaction side products are separated by treating activated mixture with water-ethanol solution following a procedure proposed in the literature. The elemental composition, X-ray diffraction pattern, IR spectra, optical properties (excitation and emission spectra, luminescence lifetime) and morphology of the mechanochemically synthesized complex are compared with those of the complex prepared from solution by the conventional method. The results confirm close similarity in the molecular structure and identity of the elemental composition, X-ray diffractograms and fluorescence properties of the compounds prepared by both methods.


2010 ◽  
Vol 24 (03) ◽  
pp. 343-350 ◽  
Author(s):  
F. TAVANGARIAN ◽  
R. EMADI

Pure nanocrystalline forsterite ( Mg 2 SiO 4) powder was successfully synthesized by mechanochemical route and subsequent annealing. The starting materials were talc ( Mg 3 Si 4 O 10( OH )2) and magnesium carbonate ( MgCO 3) powders. To produce forsterite powder, first talc and magnesium carbonate powders were calcined at 1200°C for 1 h and 700°C for 2 h, respectively. After that the mixture of obtained powders was milled by a planetary ball mill, and then annealed at 1000°C and 1200°C for 1 h. Thermogravimetric (TG) analysis, X-ray diffraction (XRD), and scanning electron microscopy (SEM) techniques were utilized to characterize the initial and prepared powders. The results showed that a single phase nanocrystalline forsterite powder with a crystallite size of 49 nm was obtained after 40 h milling and subsequent annealing at 1000°C for 1 h.


2009 ◽  
Vol 3 (1-2) ◽  
pp. 9-12 ◽  
Author(s):  
Jelena Bobic ◽  
Mirjana Vijatovic ◽  
Tadej Rojac ◽  
Biljana Stojanovic

BaBi4Ti4O15 (BBiT) was prepared from stoichiometric amounts of BaTiO3 (BT) and Bi4Ti3O12 (BIT) obtained via mechanochemical synthesis. Mechanochemical synthesis was performed in air atmosphere in a planetary ball mill. BBiT ceramics were sintered at 1100?C, 1110?C and 1120?C for 1 h without pre-calcination step. The formation of phase and crystal structure of BT, BIT and BBiT were verified using X-ray analysis. The morphology of obtained powders and microstructure were examined using scanning electron microscopy. The electrical properties of sintered samples were carried out and BBiT shows behaviour typical for relaxor ferroelectrics and dielectric constant at room temperature is approximately 93. .


2017 ◽  
Vol 49 (3) ◽  
pp. 277-284 ◽  
Author(s):  
Zorica Lazarevic ◽  
Cedomir Jovalekic ◽  
Martina Gilic ◽  
Valentin Ivanovski ◽  
Ana Umicevic ◽  
...  

Yttrium orthoferrite (YFeO3) powder was prepared by a mechanochemical synthesis from a mixture of Y2O3 and ?-Fe2O3 powders in a planetary ball mill for 2.5 h. The obtained YFeO3 powder sample was characterized by X-ray diffraction (XRD), Raman and infrared spectroscopy. The average crystallite size calculated by the Scherrer equation was 12 nm. The M?ssbauer spectroscopy at room temperature confirms the superparamagnetic character of YFeO3 orthoferrite sample.


2019 ◽  
Vol 15 ◽  
pp. 963-970 ◽  
Author(s):  
Sora Park ◽  
Jeung Gon Kim

Mechanochemical polymerization is a rapidly growing area and a number of polymeric materials can now be obtained through green mechanochemical synthesis. In addition to the general merits of mechanochemistry, such as being solvent-free and resulting in high conversions, we herein explore rate acceleration under ball-milling conditions while the conventional solution-state synthesis suffer from low reactivity. The solvent-free mechanochemical polymerization of trimethylene carbonate using the organocatalysts 1,8-diazabicyclo[5.4.0]undec-7-ene (DBU) and 1,5,7-triazabicyclo[4.4.0]dec-5-ene (TBD) are examined herein. The polymerizations under ball-milling conditions exhibited significant rate enhancements compared to polymerizations in solution. A number of milling parameters were evaluated for the ball-milling polymerization. Temperature increases due to ball collisions and exothermic energy output did not affect the polymerization rate significantly and the initial mixing speed was important for chain-length control. Liquid-assisted grinding was applied for the synthesis of high molecular weight polymers, but it failed to protect the polymer chain from mechanical degradation.


Molecules ◽  
2021 ◽  
Vol 26 (4) ◽  
pp. 1101
Author(s):  
Anirban Karmakar ◽  
Anup Paul ◽  
Elia Pantanetti Sabatini ◽  
M. Fátima C. Guedes da Silva ◽  
Armando J. L. Pombeiro

The new coordination polymers (CPs) [Zn(μ-1κO1:1κO2-L)(H2O)2]n·n(H2O) (1) and [Cd(μ4-1κO1O2:2κN:3,4κO3-L)(H2O)]n·n(H2O) (2) are reported, being prepared by the solvothermal reactions of 5-{(pyren-4-ylmethyl)amino}isophthalic acid (H2L) with Zn(NO3)2.6H2O or Cd(NO3)2.4H2O, respectively. They were synthesized in a basic ethanolic medium or a DMF:H2O mixture, respectively. These compounds were characterized by single-crystal X-ray diffraction, FTIR spectroscopy, thermogravimetric and elemental analysis. The single-crystal X-ray diffraction analysis revealed that compound 1 is a one dimensional linear coordination polymer, whereas 2 presents a two dimensional network. In both compounds, the coordinating ligand (L2−) is twisted due to the rotation of the pyrene ring around the CH2-NH bond. In compound 1, the Zn(II) metal ion has a tetrahedral geometry, whereas, in 2, the dinuclear [Cd2(COO)2] moiety acts as a secondary building unit and the Cd(II) ion possesses a distorted octahedral geometry. Recently, several CPs have been explored for the cyanosilylation reaction under conventional conditions, but microwave-assisted cyanosilylation of aldehydes catalyzed by CPs has not yet been well studied. Thus, we have tested the solvent-free microwave-assisted cyanosilylation reactions of different aldehydes, with trimethylsilyl cyanide, using our synthesized compounds, which behave as highly active heterogeneous catalysts. The coordination polymer 1 is more effective than 2, conceivably due to the higher Lewis acidity of the Zn(II) than the Cd(II) center and to a higher accessibility of the metal centers in the former framework. We have also checked the heterogeneity and recyclability of these coordination polymers, showing that they remain active at least after four recyclings.


2017 ◽  
Vol 19 (7) ◽  
pp. 1674-1677 ◽  
Author(s):  
Yifeng Wang ◽  
Haojiang Wang ◽  
Yidong Jiang ◽  
Cheng Zhang ◽  
Juanjuan Shao ◽  
...  

A fast and highly enantioselective fluorination of β-keto esters catalyzed by diphenylamine linked bis(oxazoline)-Cu(OTf)2 complexes under solvent-free conditions has been developed using a planetary ball mill.


Sign in / Sign up

Export Citation Format

Share Document