High-pressure–low-temperature metamorphism of metasedimentary rocks, southern Menderes Massif, western Turkey

Lithos ◽  
2008 ◽  
Vol 101 (3-4) ◽  
pp. 218-232 ◽  
Author(s):  
Donna L. Whitney ◽  
Christian Teyssier ◽  
Seth C. Kruckenberg ◽  
Valerie L. Morgan ◽  
Lindsay J. Iredale
2004 ◽  
Vol 46 (3) ◽  
pp. 641-669 ◽  
Author(s):  
GAËTAN RIMMELÉ ◽  
TEDDY PARRA ◽  
BRUNO GOFFÉ ◽  
ROLAND OBERHÄNSLI ◽  
LAURENT JOLIVET ◽  
...  

2006 ◽  
Vol 144 (1) ◽  
pp. 67-104 ◽  
Author(s):  
JEAN-LUC RÉGNIER ◽  
JOCHEN E. MEZGER ◽  
CEES W. PASSCHIER

The tectonic setting of the southern Menderes Massif, part of the western Anatolide belt in western Turkey, is characterized by the exhumation of deeper crustal levels onto the upper crust during the Eocene. The lowermost tectonic units of the Menderes Massif are exposed in the Çine Massif, where Proterozoic basement orthogneisses of the Çine nappe are in tectonic contact with Palaeozoic metasedimentary rocks of the Selimiye nappe. In the southern Çine Massif, orthogneiss and metasedimentary rocks are separated by the southerly dipping Selimiye shear zone, preserving top-to-the-S shearing under greenschist facies conditions. In contrast, in the western Çine Massif, the orthogneiss is deformed and mylonitic near the contact with the metasedimentary rocks. The geometry of the mylonite zone and the observed shear directions change from north to southwest. In the north, the mylonite zone dips shallowly to the north, with top-to-the-N shear sense indicators showing northward thrusting of the orthogneiss over the metasedimentary rocks. In the southwest, the mylonite zone resembles a steep N–S striking strike-slip shear zone associated with top-to-the-SSW sense of shear. Overall, the geometry of the mylonite shear zone is consistent with northward movement of the orthogneiss relative to the metasedimentary rocks. Different shear senses are attributed to strain partitioning.AFM diagrams and P–T pseudosections with mineral parageneses of metasedimentary rocks of the Selimiye nappe and metasedimentary enclaves within the orthogneiss of the Çine nappe indicate a single Barrovian-type metamorphism. An earlier higher pressure phase is evident from staurolite–chloritoid inclusions in garnets of the Çine nappe, suggesting a clockwise P–T path. A similar path is inferred for the Selimiye nappe. Index minerals and the sequence of mineral parageneses point to a single amphibolite facies metamorphic event affecting metasedimentary rocks of both nappes, which predates Eocene emplacement of the high pressure–low temperature Lycian and Cycladic blueschist nappes. Northward thrusting of the orthogneiss onto the metasedimentary rocks of the Selimiye nappe is coeval with amphibolite facies metamorphism. Recently postulated polymetamorphism cannot be supported by this study. Petrological data provide no evidence for burial of the lower units of the Menderes Massif to depth greater than 30 km during closure of the Neo-Tethys. A major pre-Eocene tectonic event associated with top-to-the-N thrusting and Barrovian-type metamorphism could lend support to the idea of a Neo-Tethys (sensu stricto) suture south of the Menderes Massif and below the Lycian nappes.


2021 ◽  
pp. 160309
Author(s):  
M. Osorio-García ◽  
K. Suárez-Alcántara ◽  
Y. Todaka ◽  
A. Tejeda-Ochoa ◽  
M. Herrera Ramírez ◽  
...  

2020 ◽  
pp. 146808742096933
Author(s):  
Xiangyu Meng ◽  
Sicheng Liu ◽  
Jingchen Cui ◽  
Jiangping Tian ◽  
Wuqiang Long ◽  
...  

A novel method called high-pressure air (HPA) jet controlled compression ignition (JCCI) based on the compound thermodynamic cycle was investigated in this work. The combustion process of premixed mixture can be controlled flexibly by the high-pressure air jet compression, and it characterizes the intensified low-temperature reaction and two-stage high-temperature reaction. The three-dimensional (3D) computational fluid dynamics (CFD) numerical simulation was employed to study the emission formation process and mechanism, and the effects of high-pressure air jet temperature and duration on emissions were also investigated. The simulation results showed that the NOx formation is mainly affected by the first-stage high-temperature reaction due to the higher reaction temperature. Overall, this combustion mode can obtain ultra-low NOx emission. The second-stage high-temperature reaction plays an important role in the CO and THC formation caused by the mixing effect of the high-pressure air and original in-cylinder mixture. The increasing air jet temperature leads to a larger high-temperature in-cylinder region and more fuel in the first-stage reaction, and therefore resulting in higher NOx emission. However, the increasing air jet temperature can significantly reduce the CO and THC emissions. For the air jet duration comparisons, both too short and too long air jet durations could induce higher NOx emission. A higher air jet duration would result in higher CO emission due to the more high-pressure air jet with relatively low temperature.


1985 ◽  
Vol 119 (1) ◽  
pp. 225-232 ◽  
Author(s):  
Bernard Galiois ◽  
Jacques Gaultier ◽  
Christian Hauw ◽  
Daniel Chasseau ◽  
Alain Meresse ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document