A new method for connate water saturation calculation using time-lapse logging data

2006 ◽  
Vol 50 (3-4) ◽  
pp. 204-210 ◽  
Author(s):  
Jianmeng Sun ◽  
Shiyi Zheng ◽  
Jianhai Ma
1964 ◽  
Vol 4 (01) ◽  
pp. 49-55 ◽  
Author(s):  
Pietro Raimondi ◽  
Michael A. Torcaso

Abstract The distribution of the oil phase in Berea sandstone resulting from increasing and decreasing the water saturation by imbibition was investigated Three types of distribution were recognized: trapped, normal and lagging. The amount of oil in each of these distributions was determined as a function of saturation by carrying out a miscible displacement in the oil phase under steady-state conditions of saturation. These conditions were maintained by flowing water and oil simultaneously in given ratios and by using a displacing solvent having essentially the same density and viscosity as the oil.A correlation shows the amount of trapped oil at any saturation to be directly proportional to the conventional residual oil saturation Sir The factor of proportionality is related to the fractional permeability to the water phase. Part of the oil which was not trapped was displaced in a piston- like manner (normal part) and part was eluted gradually (lagging part). The observed phenomena are more than of mere academic importance. Oil which is trapped may well provide the fuel essential for forward combustion and thus be beneficial. On the contrary, in tertiary recovery operations, it is this trapped oil which seems to make current techniques uneconomic. Introduction A typical oilfield may initially contain connate water and oil. After a period of primary production water often enters the field either from surrounding aquifers or from surface injection. During primary production evolution and establishment of a free gas saturation usually occurs. The effect and importance of this third phase is fully recognized. However, this investigation is limited to a two- phase system, one wetting phase (water) and one non-wetting phase (oil). The increase in water content of a water-wet system is termed imbibition. In a relative permeability-saturation diagram such as the one shown in Fig. 1, the initial conditions of the field would he represented by a point below a water saturation of about 35 per cent, i.e., where the imbibition and the drainage curves to the non-wetting phase nearly coincide. When water enters the field the relative permeability to oil decreases along the imbibition curve. At watered-out conditions the relative permeability to the oil becomes zero. At this point a considerable amount of oil, called residual oil, (about 35 per cent in Fig. 1) remains unrecovered. Any attempt to produce this oil will require that its saturation be increased. In Fig. 1 this would mean retracing the imbibition curve upwards. In addition, processes like alcohol and fire flooding, which can be employed at any stage of production, involve the complete displacement of connate water and an increase, or imbibition, of water saturation ahead of the displacing front. Thus, in several types of oil production it is the imbibition-relative permeability curve which rules the flow behavior. For this reason a knowledge of the distribution of the non-wetting phase, as obtained through imbibition, whether "coming down" or "going up" on the imbibition curve, is important. SPEJ P. 49^


Geophysics ◽  
2020 ◽  
Vol 85 (4) ◽  
pp. H51-H60
Author(s):  
Feng Zhou ◽  
Iraklis Giannakis ◽  
Antonios Giannopoulos ◽  
Klaus Holliger ◽  
Evert Slob

In oil drilling, mud filtrate penetrates into porous formations and alters the compositions and properties of the pore fluids. This disturbs the logging signals and brings errors to reservoir evaluation. Drilling and logging engineers therefore deem mud invasion as undesired and attempt to eliminate its adverse effects. However, the mud-contaminated formation carries valuable information, notably with regard to its hydraulic properties. Typically, the invasion depth critically depends on the formation porosity and permeability. Therefore, if adequately characterized, mud invasion effects could be used for reservoir evaluation. To pursue this objective, we have applied borehole radar to measure mud invasion depth considering its high radial spatial resolution compared with conventional logging tools, which then allows us to estimate the reservoir permeability based on the acquired invasion depth. We investigate the feasibility of this strategy numerically through coupled electromagnetic and fluid modeling in an oil-bearing layer drilled using freshwater-based mud. Time-lapse logging is simulated to extract the signals reflected from the invasion front, and a dual-offset downhole antenna mode enables time-to-depth conversion to determine the invasion depth. Based on drilling, coring, and logging data, a quantitative interpretation chart is established, mapping the porosity, permeability, and initial water saturation into the invasion depth. The estimated permeability is in a good agreement with the actual formation permeability. Our results therefore suggest that borehole radar has significant potential to estimate permeability through mud invasion effects.


2020 ◽  
Vol 24 (1) ◽  
pp. 159-167 ◽  
Author(s):  
Adam R. Mangel ◽  
Stephen M. J. Moysey ◽  
John Bradford

Abstract. Ground-penetrating radar (GPR) reflection tomography algorithms allow non-invasive monitoring of water content changes resulting from flow in the vadose zone. The approach requires multi-offset GPR data that are traditionally slow to collect. We automate GPR data collection to reduce the survey time significantly, thereby making this approach to hydrologic monitoring feasible. The method was evaluated using numerical simulations and laboratory experiments that suggest reflection tomography can provide water content estimates to within 5 % vol vol−1–10 % vol vol−1 for the synthetic studies, whereas the empirical estimates were typically within 5 %–15 % of measurements from in situ probes. Both studies show larger observed errors in water content near the periphery of the wetting front, beyond which additional reflectors were not present to provide data coverage. Overall, coupling automated GPR data collection with reflection tomography provides a new method for informing models of subsurface hydrologic processes and a new method for determining transient 2-D soil moisture distributions.


SIMULATION ◽  
2019 ◽  
pp. 003754971985713 ◽  
Author(s):  
Zhenzihao Zhang ◽  
Turgay Ertekin

This study developed a data-driven forecasting tool that predicts petrophysical properties from rate-transient data. Traditional estimations of petrophysical properties, such as relative permeability (RP) and capillary pressure (CP), strongly rely on coring and laboratory measurements. Coring and laboratory measurements are typically conducted only in a small fraction of wells. To contend with this constraint, in this study, we develop artificial neural network (ANN)-based tools that predict the three-phase RP relationship, CP relationship, and formation permeability in the horizontal and vertical directions using the production rate and pressure data for black-oil reservoirs. Petrophysical properties are related to rate-transient data as they govern the fluid flow in oil/gas reservoirs. An ANN has been proven capable of mimicking any functional relationship with a finite number of discontinuities. To generate an ANN representing the functional relationship between rate-transient data and petrophysical properties, an ANN structure pool is first generated and trained. Cases covering a wide spectrum of properties are then generated and put into training. Training of ANNs in the pool and comparisons among their performance yield the desired ANN structure that performs the most effectively among the ANNs in the pool. The developed tool is validated with blind tests and a synthetic field case. Reasonable predictions for the field cases are obtained. Within a fraction of second, the developed ANNs infer accurate characteristics of RP and CP for three phases as well as residual saturation, critical gas saturation, connate water saturation, and horizontal permeability with a small margin of error. The predicted RP and CP relationship can be generated and applied in history matching and reservoir modeling. Moreover, this tool can spare coring expenses and prolonged experiments in most of the field analysis. The developed ANNs predict the characteristics of three-phase RP and CP data, connate water saturation, residual oil saturation, and critical gas saturation using rate-transient data. For cases fulfilling the requirement of the tool, the proposed technique improves reservoir description while reducing expenses and time associated with coring and laboratory experiments at the same time.


2005 ◽  
Vol 48 (3) ◽  
pp. 771-776 ◽  
Author(s):  
Long JIN ◽  
Xiao-Hong CHEN ◽  
Jing-Ye LI

Sign in / Sign up

Export Citation Format

Share Document