Improved gamma radiation shielding traits of epoxy composites: Evaluation of mass attenuation coefficient, effective atomic and electron number

2021 ◽  
Vol 179 ◽  
pp. 109183
Author(s):  
Mohammed J.R. Aldhuhaibat ◽  
Maitham S. Amana ◽  
Najwa J. Jubier ◽  
A.A. Salim
Keyword(s):  
Gamma Radiation ◽  
Attenuation Coefficient ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Epoxy Composites ◽  
Electron Number ◽  
Mass Attenuation

Gamma radiation shielding properties of glasses within the TeO2-TiO2-ZnO system

2019 ◽  
Vol 107 (6) ◽  
pp. 517-522 ◽  
Author(s):  
M. Almatari
Keyword(s):  
Gamma Radiation ◽  
Attenuation Coefficient ◽  
Atomic Number ◽  
Effective Atomic Number ◽  
Mean Free Path ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Glass System ◽  
Shielding Properties ◽  
Mass Attenuation

Abstract Radiations are widely used in hospitals and health services in radiotherapy and molecular imaging using x-ray and gamma radiation which considered as the most penetrating radiations and very difficult to shield. In this study, the radiation shielding properties of different zinc oxide (ZnO) concentrations of the (95-x)TeO2-5TiO2-xZnO (x=5, 10, 15, 20, 25, 30 and 40 mol%) glass system was investigated to be introduced as a new transparency effective shielding material. In order to study shielding properties, mass attenuation coefficients in the energy range of 0.015–15 MeV photon energies for the current glass system were calculated using ParShield software. Moreover, half value layer, mean free path and effective atomic number were evaluated using the obtained attenuation coefficient. The results indicated that if ZnO was added to the current glass system the mass attenuation coefficient will be decreased as well as effective atomic number values. The highest mass attenuation coefficient at all energies was found to be in TT5Z5 glass sample as well as the effective atomic number value.

scholarly journals Estimation of the X/γ- ray shielding properties of different glass system using Monte Carlo Simulation

2021 ◽  
Vol 12 (2) ◽  
pp. 1117-1122
Author(s):  
Ayano Shanko, MD, Et. al.
Keyword(s):  
Monte Carlo Simulation ◽  
Monte Carlo ◽  
Attenuation Coefficient ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Glass System ◽  
Effective Electron ◽  
X Ray ◽  
Shielding Properties ◽  
Mass Attenuation

The aim of the research is to estimate the X-ray shielding properties of different glass systems using Monte Carlo Simulation. X-ray glass is also known as radiation shielding glass. Glass provides protection against the absorption of energy radiation. The shielding layer is formed by a high concentration of lead and barium. The mass attenuation coefficient, the effective atomic number and the effective electron density are used to determine the position of gamma-ray photons in matter. Shield characterization in terms of mass attenuation coefficient (μm), transmission fraction (T), effective atomic numbers (Zeff), half-value layer (HVL) and exposure build-up. factor (EBF) of a glass system is estimated by the Monte Carlo Simulation. The random sampling and statistical analysis are computed using the monte carlo simulation. Various external factors are considered as the input parameters. The different composition of the glass will be examined using the Monte Carlo simulation and the shielding capability would be determined for the various samples.

scholarly journals Effect of Flyash Addition on Mechanical and Gamma Radiation Shielding Properties of Concrete

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Kanwaldeep Singh ◽  
Sukhpal Singh ◽  
Gurmel Singh
Keyword(s):  
Gamma Radiation ◽  
Attenuation Coefficient ◽  
Cement Content ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Mechanical Parameters ◽  
Cement Ratio ◽  
Concrete Mixtures ◽  
Water To Cement Ratio ◽  
Shielding Properties

Six concrete mixtures were prepared with 0%, 20%, 30%, 40%, 50%, and 60% of flyash replacing the cement content and having constant water to cement ratio. The testing specimens were casted and their mechanical parameters were tested experimentally in accordance with the Indian standards. Results of mechanical parameters show their improvement with age of the specimens and results of radiation parameters show no significant effect of flyash substitution on mass attenuation coefficient.

Investigation and Characterization of Gamma Radiation Shielding Capacity of Heavy Minerals-Based Composite Materials

2020 ◽  
Vol 6 (4) ◽  
Author(s):  
Mohammad Asaduzzaman Chowdhury ◽  
Md. Bengir Ahmed Shuvho ◽  
Md Azizul Islam ◽  
Muhammad Borhan Uddin ◽  
Ruhul Amin Khan
Keyword(s):  
Composite Materials ◽  
Gamma Radiation ◽  
Attenuation Coefficient ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Integrated System ◽  
Heavy Minerals ◽  
Linear Attenuation Coefficient ◽  
Density Surface ◽  
Effects Of Radiation

Abstract Radiation shielding is an indispensable ingredient in the design of an integrated system to attenuate the effects of radiation during various operations such as space, aircraft, and nuclear plant. Discerning and exploiting the properties of composite materials compatible for radiation shielding in those applications are therefore primary obligation. In this study, we present here the results of control, ilmenite-, and garnet-based composites radiation shielding capabilities. The gamma radiation shielding competency of control, ilmenite-, and garnet-based composite materials has been examined by using linear attenuation coefficient, mass attenuation coefficient (MAC), tenth value layer (TVL), and half value layer (HVL). A comparison among those composite materials has been studied to find out the best one for radiation shielding material. Factors influencing the radiation shielding capabilities such as mechanical properties, thermal properties, density, surface morphology, and Fourier-transform infrared spectroscopy (FTIR) analysis have been studied in comparative investigations. In this work, we show that garnet-based composite material has viable radiation shielding performances as compared to the control and ilmenite-based composites. Garnet-based composite exhibits lower impact energy to withstand against gamma radiation as compared to the other tested shielding materials.

scholarly journals Photon Shielding Characterization of SiO2-PbO-CdO-TiO2 Glasses for Radiotheraphy Shielding Application

2021 ◽  
pp. 32-38
Author(s):  
Idris M. Mustapha ◽  
Atimga B. James ◽  
Sulayman M. Bello
Keyword(s):  
Attenuation Coefficient ◽  
Energy Region ◽  
Effective Atomic Number ◽  
Mean Free Path ◽  
Mass Attenuation Coefficient ◽  
Photoelectric Effect ◽  
High Energy ◽  
Radiation Shielding ◽  
Sudden Increase ◽  
Mass Attenuation

In this study, photon attenuation parameters of (30-x) SiO2–15PbO–10CdO-xTiO2, with x = 0, 2, 4, 6, 8 and 10% mol, were determined and their application as shielding material were discussed. The WinXCOM software was used to determine the mass attenuation coefficient of the studied glasses for the energy range (0.015-15MeV). The mass attenuation coefficient of the glass samples first decline up to 0.09 MeV and slightly increase abruptly and then declined uniformly for all the glasses to approximately zero after about 10 MeV.   The effective atomic number (Zeff) was also calculated for the glass samples and were observe to raise from 0.015 to 0.02 MeV and then decreased between 0.02-5 MeV. On account of the dominance of the photoelectric effect in the low energy region, there was a sudden increase in Zeff at about 0.08 MeV close to the absorption edge of the Pb (0.088 MeV). The rapid increment was observed at 0.1–1.5 MeV by transcending typical Compton scattering interaction at intermediate energies for Zeff'’s and began to decrease in the same form again. The lower Zeff   values were found in low and high energy region for all SPCT glasses. The calculated mean free path, half value layer and tenth value layer values were observe to decline as the TiO2 doping of the glasses increased which accounts for the  three photon interaction mechanisms effectiveness in the variation of MFP and HVL values with energy. It can be concluded that SPCT glasses may be considered an alternative material for radiation shielding practices.

Gamma-Rays Absorption Studies of PbO-SiO2 Glass System

2010 ◽  
Vol 93-94 ◽  
pp. 71-74
Author(s):  
N. Chanthima ◽  
Jakrapong Kaewkhao ◽  
Weerapong Chewpraditkul ◽  
Pichet Limsuwan
Keyword(s):  
Attenuation Coefficient ◽  
Effective Atomic Number ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Glass System ◽  
Interaction Cross Section ◽  
Absorption Studies ◽  
Total Interaction ◽  
Better Than ◽  
Mass Attenuation

Mass attenuation coefficient, total interaction cross-section and effective atomic number of xPbO:(100-x)SiO2, where 30 x 70 (% weight), glass system have been investigated at 662 keV on the basis of the mixture rule. The results are in good agreement with the theoretical values, calculated by WinXCom. The mass attenuation coefficient increases with PbO content, due to higher probability of photoelectric absorption in glass. However, Compton scattering gives dominant contribution to the total mass attenuation coefficient for the glass samples studied. The shielding properties of the glass samples are also better than ordinary shielding concretes and commercial window glasses. These results indicate that the glass systems prepared in this study has a potential to be used as radiation shielding materials.

Thermal stability, mechanical properties, and gamma radiation shielding performance of polyvinyl chloride/Pb(NO3)2 composites

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Sayed A. Waly ◽  
Ahmed M. Abdelreheem ◽  
Mohamed M. Shehata ◽  
Omayma A. Ghazy ◽  
Zakaria I. Ali
Keyword(s):  
Thermal Stability ◽  
Attenuation Coefficient ◽  
Polyvinyl Chloride ◽  
Polymer Matrix ◽  
Composite Films ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Point Sources ◽  
Linear Attenuation Coefficient ◽  
Mass Attenuation

Abstract Radiation shielding composites based on polyvinyl chloride (PVC) reinforced with different weight ratios of Pb(NO3)2 (5, 10, and 20 wt%) were prepared using the solution-casting technique. Fourier-transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), thermogravimetric analysis (TGA), scanning electron microscopy, and tensile testing method were used to characterize the PVC composite films. FTIR and XRD investigations illustrate the structural change and modification of the as-prepared PVC composites. The morphological analysis of the composite revealed that Pb(NO3)2 was dispersed uniformly within PVC polymer matrix. TGA revealed that the incorporation of Pb(NO3)2 improved the thermal stability of the investigated composites, whereas adding Pb(NO3)2 to the polymer matrix worsened its tensile properties. The as-prepared composite films were investigated for radiation-shielding of gamma-rays radioactive point sources (241Am, 133Ba, 137Cs, and 60Co). Linear attenuation coefficient (μ, cm−1), mass attenuation coefficient (μ/ρ, cm2/g), and half-value layer (HVL, cm) have been estimated from the obtained data using the MicroShield program. Reasonable agreement was attended between theoretical and experimental results. The deviation between the experiment and theoretical values of mass attenuation coefficient is being to be lower than 9%, and this can be correlated to the good distribution of Pb(NO3)2. The results revealed that adding Pb(NO3)2 to PVC polymer composites improved their mass attenuation coefficient.

Gamma radiation shielding characteristics of some soft and hard woods of medicinal plants from Nallamala forest of Andhra Pradesh

2014 ◽  
Vol 4 (4) ◽  
pp. 150-157
Author(s):  
E. Rajasekhar ◽  
R. Jeevan Kumar ◽  
K. Venkataramaniah ◽  
K. L. Narasimham
Keyword(s):  
Medicinal Plants ◽  
Gamma Radiation ◽  
Attenuation Coefficient ◽  
Andhra Pradesh ◽  
Radiation Effects ◽  
Mass Attenuation Coefficient ◽  
Radiation Shielding ◽  
Linear Attenuation Coefficient ◽  
Relaxation Length ◽  
Medicinal Uses

Wood is a complex biomaterial useful for various applications. Wood can also be used to shield radiation from nuclear sources. In the present study, the radiation effects on various wood materials of medicinal plants collected from Nallamala forest in Andhra Pradesh, India was investigated. Gamma radiation shielding characteristics such as linear attenuation coefficient, mass attenuation coefficient, half- value thickness and relaxation length of ten different types of wood materials were measured for gamma energies 511, 662, 1173, 1275 and 1332 keV from 22Na, 137Cs and 60Co radioactive sources . Measurements were performed using a gamma spectrometer consisting of NaI (Tl) scintillation detector coupled to an 8K PC based Nuclear MCA with a good geometry set up. Classification of wood and their medicinal uses also studied. Analysis of results showed an appreciable evidence of radiation attenuation, attenuation coefficient decreasing with increase of gamma en-ergy and significant variation for different species.

Sign in / Sign up

Export Citation Format

Share Document