scholarly journals Microstructure and mechanical properties of solid state recycled 4Cr5MoSiV (H11) steel prepared by powder metallurgy

2021 ◽  
pp. 100184
Author(s):  
Gyanendra Bhatta ◽  
Luis De Los Santos Valladares ◽  
Xinggang Liu ◽  
Zhaojun Ma ◽  
A. Bustamante Domínguez ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Powder Metallurgy ◽  
Solid State ◽  
Microstructure And Mechanical Properties

scholarly journals Study on Microstructure and Mechanical Properties of Al7068 Reinforced with Silicon Carbide and Fly Ash by Powder Metallurgy

2021 ◽  
Vol 7 (09) ◽  
pp. 47-53
Author(s):  
Md Mehtab Alam and B.S Motgi
Keyword(s):  
Mechanical Properties ◽  
Silicon Carbide ◽  
Fly Ash ◽  
Powder Metallurgy ◽  
Aluminum Matrix ◽  
Hydraulic Press ◽  
Powder Form ◽  
X Ray ◽  
Microstructure And Mechanical Properties ◽  
Scanning Electron

The paper deals with detailed study on microstructure and mechanical properties of aluminum 7068 reinforced with fly ash and silicon carbide by powder metallurgy, aluminum 7068, silicon carbide and fly ash were taken in powder form of required size and mixed together in varying proportion according to specification and compacted with pressure of 400MPa using hydraulic press to make samples and then samples were sintered at 600°c for 2 hours, the samples were tested for density, compressive strength, hardness and microstructure was analyzed using scanning electron microscope, energy dispersive x-ray study was carried out in order to confirm presence of silicon carbide and fly ash in aluminum matrix.

Investigation of Microstructure and Mechanical Properties of Semi-Solid State Joining of SSM Aluminum Alloys

2014 ◽  
Vol 496-500 ◽  
pp. 371-375 ◽  
Author(s):  
Apirit Petkhwan ◽  
Prapas Muangjunburee ◽  
Jessada Wannasin
Keyword(s):  
Mechanical Properties ◽  
Solid State ◽  
Weld Metal ◽  
Butt Joint ◽  
A356 Aluminum Alloy ◽  
Globular Microstructure ◽  
Microstructure And Mechanical Properties ◽  
A356 Aluminum ◽  
Semi Solid ◽  
Solid State Joining

In this research, the semi-solid state joining of SSM A356 aluminum alloy was investigated. The butt-joint of SSM A356 was heated by an induction heating coil to create a localized semisolid pool. Then a stirrer was applied into the joint seam in order to mix the weld metal. The accurate controlling of temperature during joining was measured. The effects of stirring rate on physical, macrostructure, microstructure and mechanical properties were studied. Experimental results showed that increase in stirring rates, the surface of the joint was smooth. The weld metal consisted of the globular microstructure and also voids. The density of weld metal zone increased by an appropriate stirring. The best tensile strength was achieved with 1750 rpm, 70 mm/min for 103.4 MPa.

Sign in / Sign up

Export Citation Format

Share Document