scholarly journals Molecular weight analysis of antithrombin III-heparin and antithrombin III-thrombin-heparin complexes.

1986 ◽  
Vol 261 (9) ◽  
pp. 4143-4147
Author(s):  
C H Pletcher ◽  
M T Cunningham ◽  
G L Nelsestuen
Blood ◽  
1989 ◽  
Vol 73 (7) ◽  
pp. 1873-1879
Author(s):  
CF Scott ◽  
RW Colman

Controversy exists in the literature concerning the potentiating effect of heparin on the inactivation rate of factor XIa by antithrombin III (AT III) in both purified systems and in plasma. We have analyzed the factors that could influence this reaction and found that ionic strength of the medium, as well as the type and concentration of the heparin preparations accounted for the major discrepancies in the literature. At I = 0.43 N, a preparation of bovine lung heparin at 1 U/mL did not augment the inactivation rate of factor XIa by inhibitors in plasma or by purified AT III. However, when ionic strength was decreased, a progressive increase in the potentiating effect was observed, reaching 6.5-fold at I = 0.15 N. At saturating concentrations of heparin, which results in the formation of 100% AT III-heparin complex, (greater than ten-fold molar excess over AT III) in purified systems, all heparin preparations (porcine, bovine, low molecular weight [LMW], and high affinity) yielded an approximately 30-fold augmentation of the factor XIa inactivation rate. However, when heparin was less than saturating, we observed that various heparin preparations affected the AT III-induced inactivation of factor XIa to different degrees even though they exhibited the same inhibitory activity (1 U/mL) against thrombin. This variation resulted from differences in the number of AT III binding sites in each heparin preparation, despite a similar Kd for each. Addition of high molecular weight kininogen (HK) to AT III-heparin complexes did not enhance their ability to inhibit factor XIa, and high concentrations of HK decreased the inactivation rate. A high therapeutic dose of heparin only permits the formation of 2.5% to 16.5% of the AT III-heparin complexes that can be achieved at saturation. We observed that 1 U/mL heparin (bovine lung heparin) (high therapeutic concentration) in virtually undiluted plasma only accelerated the inactivation rate of factor XIa (in the absence of other active enzymes) less than two-fold. These new observations further support our previous conclusion that therapeutic levels of heparin have little to no influence on the inactivation rate of factor XIa in plasma.


Blood ◽  
1989 ◽  
Vol 73 (7) ◽  
pp. 1873-1879 ◽  
Author(s):  
CF Scott ◽  
RW Colman

Abstract Controversy exists in the literature concerning the potentiating effect of heparin on the inactivation rate of factor XIa by antithrombin III (AT III) in both purified systems and in plasma. We have analyzed the factors that could influence this reaction and found that ionic strength of the medium, as well as the type and concentration of the heparin preparations accounted for the major discrepancies in the literature. At I = 0.43 N, a preparation of bovine lung heparin at 1 U/mL did not augment the inactivation rate of factor XIa by inhibitors in plasma or by purified AT III. However, when ionic strength was decreased, a progressive increase in the potentiating effect was observed, reaching 6.5-fold at I = 0.15 N. At saturating concentrations of heparin, which results in the formation of 100% AT III-heparin complex, (greater than ten-fold molar excess over AT III) in purified systems, all heparin preparations (porcine, bovine, low molecular weight [LMW], and high affinity) yielded an approximately 30-fold augmentation of the factor XIa inactivation rate. However, when heparin was less than saturating, we observed that various heparin preparations affected the AT III-induced inactivation of factor XIa to different degrees even though they exhibited the same inhibitory activity (1 U/mL) against thrombin. This variation resulted from differences in the number of AT III binding sites in each heparin preparation, despite a similar Kd for each. Addition of high molecular weight kininogen (HK) to AT III-heparin complexes did not enhance their ability to inhibit factor XIa, and high concentrations of HK decreased the inactivation rate. A high therapeutic dose of heparin only permits the formation of 2.5% to 16.5% of the AT III-heparin complexes that can be achieved at saturation. We observed that 1 U/mL heparin (bovine lung heparin) (high therapeutic concentration) in virtually undiluted plasma only accelerated the inactivation rate of factor XIa (in the absence of other active enzymes) less than two-fold. These new observations further support our previous conclusion that therapeutic levels of heparin have little to no influence on the inactivation rate of factor XIa in plasma.


1987 ◽  
Vol 58 (04) ◽  
pp. 1064-1067 ◽  
Author(s):  
K Kodama ◽  
B Pasche ◽  
P Olsson ◽  
J Swedenborg ◽  
L Adolfsson ◽  
...  

SummaryThe mode of F Xa inhibition was investigated on a thromboresistant surface with end-point attached partially depoly-merized heparin of an approximate molecular weight of 8000. Affinity chromatography revealed that one fourth of the heparin used in surface coating had high affinity for antithrombin III (AT). The heparin surface adsorbed AT from both human plasma and solutions of purified AT. By increasing the ionic strength in the AT solution the existence of high and low affinity sites could be shown. The uptake of AT was measured and the density of available high and low affinity sites was found to be in the range of 5 HTid 11 pic.omoles/cmf, respectively Thus the estimated density of biologically active high and low ailmity heparm respectively would be 40 and 90 ng/cm2 The heparin coating did not take up or exert F Xa inhibition by itself. With AT adsorbed on both high and low affinity heparin the surface had the capacity to inhibit several consecutive aliquots of F Xa exposed to the surface. When mainly high affinity sites were saturated with AT the inhibition capacity was considerably lower. Tt was demonstrated that the density of AT on both high and low affinity heparin determines the F Xa inhibition capacity whereas the amount of AT on high affinity sites limits the rate of the reaction. This implies that during the inhibition of F Xa there is a continuous surface-diffusion of AT from sites of a lower class to the high affinity sites where the F Xa/AT complex is formed and leaves the surface. The ability of the immobilized heparin to catalyze inhibition of F Xa is likely to be an important component for the thromboresistant properties of a heparin coating with non-compromized AT binding sequences.


1977 ◽  
Vol 38 (02) ◽  
pp. 0494-0503 ◽  
Author(s):  
D. S Pepper ◽  
D Banhegyi ◽  
J. D Cash

SummaryAntithrombin III (AT III) complexes were isolated from human serum by affinity chromatography and gel filtration. In the first step of the preparation, using heparin-agarose chromatography, we observed that the complexed form of AT III bound less strongly to the gel than the free form and that about half of the AT III was free. With further purification a 2.5 × 105 molecular weight complex was isolated. Using 125I labelled human thrombin, this complex was radioactive indicating the presence of thrombin. Only in a synthetic thrombin-AT III system was a 9 × 104 molecular weight complex detected, but not in serum. These facts suggest that in serum AT III complexes may exist in a polymeric form. Also, an AT III antigen derived from the original AT III molecule, but not complexed, was isolated which may be a degradation product.Abbreviations used: AT-III, antithrombin III. Hepes, N-2-Hydroxyethylpiperazine-N-2-Ethanesulphonic acid.


1983 ◽  
Vol 49 (02) ◽  
pp. 109-115 ◽  
Author(s):  
M Hoylaerts ◽  
E Holmer ◽  
M de Mol ◽  
D Collen

SummaryTwo high affinity heparin fragments (A/r 4,300 and M, 3,200) were covalently coupled to antithrombin III (J. Biol. Chem. 1982; 257: 3401-3408) with an apparent 1:1 stoichiometry and a 30-35% yield.The purified covalent complexes inhibited factor Xa with second order rate constants very similar to those obtained for antithrombin III saturated with these heparin fragments and to that obtained for the covalent complex between antithrombin III and native high affinity heparin.The disappearance rates from plasma in rabbits of both low molecular weight heparin fragments and their complexes could adequately be represented by two-compartment mammillary models. The plasma half-life (t'/j) of both low Afr-heparin fragments was approximately 2.4 hr. Covalent coupling of the fragments to antithrombin III increased this half-life about 3.5 fold (t1/2 ≃ 7.7 hr), approaching that of free antithrombin III (t1/2 ≃ 11 ± 0.4 hr) and resulting in a 30fold longer life time of factor Xa inhibitory activity in plasma as compared to that of free intact heparin (t1/2 ≃ 0.25 ± 0.04 hr).


1994 ◽  
Vol 72 (02) ◽  
pp. 275-280 ◽  
Author(s):  
David Brieger ◽  
Joan Dawes

SummaryIt is widely reported that persistent anti-Xa activity follows administration of low molecular weight heparins. To identify the effectors of this activity we have injected 125I-labelled Enoxaparin sodium into rabbits and subsequently analysed the circulating radiolabelled material and anti-Xa activity by affinity and size exclusion chromatography. Antithrombin III-binding material derived from the injected drug was responsible for all the anti-Xa amidolytic activity. At early times after injection additional anticoagulant activity which was largely attributable to tissue factor pathway inhibitor was measured by the Heptest clotting assay after removal of glycosaminoglycans from plasma samples. Small radiolabelled fragments, including penta/hexasaccharide with affinity for antithrombin III, were detectable in the circulation 1 week later, and sulphated oligosaccharides persisted for 3-4 weeks. Significant quantities of radiolabel remained in the liver and kidney several weeks post-injection; these organs may sequester some of the injected drug and give rise to circulating biologically active material by degradation and secretion of catabolic products into the plasma.


Polymers ◽  
2021 ◽  
Vol 13 (14) ◽  
pp. 2373
Author(s):  
Celine Moreira ◽  
Richard Lloyd ◽  
Gavin Hill ◽  
Florence Huynh ◽  
Ana Trufasila ◽  
...  

Polyethylene films are one of the most frequently used packaging materials in our society, due to their combination of strength and flexibility. An unintended consequence of this high use has been the ever-increasing accumulation of polyethylene films in the natural environment. Previous attempts to understand their deterioration have either focused on their durability using polymer analysis; or they have focused on changes occurring during outdoor exposure. Herein, this study combines those strategies into one, by studying the chemical and physical changes in the polyethylene structure in a laboratory using molecular weight and IR spectroscopic mapping analysis, combined with temperate UV-accelerated weathering cycles. This approach has been correlated to real-world outdoor exposure timeframes by parallel testing of the sample polyethylene films in Florida and France. The formation of polyethylene microparticles or polyethylene waxes is elucidated through comparison of drop point testing and molecular weight analysis.


1987 ◽  
Author(s):  
J Dawes ◽  
D S Pepper

Antithrombin III (ATIII) and heparin cofactor II (HCII) are currently thought to be the most important protein mediators of the anticoagulant and antithrombotic activities of glycosamino-glycans. A simple, quantitative method for assessing the affinity of a protein for a sulphated polymer in the liquid phase, based on competition with immobilised heparin, has been developed. Using this technique, the binding of ATIII and HCII to a wide range of glycosaminoglycans and other sulphated polymers have been compared, and the contributions to binding of size, degree of sulphation and backbone structure of the polymers analysed.In the presence of the high protein concentrations found in plasma, unfractionated heparin inhibited the binding of ATIII to immobilised heparin with a Ki of 1 x 10-6. Binding was destroyed by N-desulphation. 1 Results with a range of low molecular weight (LMW) heparins and heparan sulphates are consistent with the view that they all contain the ATIII-binding sequence, but at a lower molar ratio than heparin. Highly sulphated synthetic polymers such as dextran sulphate bound ATIII by a different mechanism, which was molecular weight-dependent.The affinity of HCII for heparins increased markedly with heparin chain length. Binding was largely, but not entirely, mediated by sulphate residues. HCII bound to heparan and dermatan sulphates with lower affinities than to heparin, and to synthetic sulphated polymers with similar or higher affinities. Pentosan polysulphate (SP54) bound HCII as effectively as did heparin. Binding of HCII to dextran sulphate was highly dependent on molecular weight. The affinity of HCII for a sulphated polymer appears to depend both on its chain length and density of sulphation.Thus the profiles of binding of ATIII and HCII to glycosaminoglycans and other sulphated polymers are quite different. This technique is useful both for investigating the interactions of existing therapeutic anticoagulants and assessing new products.


Sign in / Sign up

Export Citation Format

Share Document