Influence of deposition parameters on superconductivity and surface morphology of NdBa2Cu3O7−δ films grown by pulsed laser deposition with a single crystal target

1999 ◽  
Vol 324 (3-4) ◽  
pp. 198-210 ◽  
Author(s):  
Yijie Li ◽  
K Tanabe
Author(s):  
Michael P. Mallamaci ◽  
James Bentley ◽  
C. Barry Carter

Glass-oxide interfaces play important roles in developing the properties of liquid-phase sintered ceramics and glass-ceramic materials. Deposition of glasses in thin-film form on oxide substrates is a potential way to determine the properties of such interfaces directly. Pulsed-laser deposition (PLD) has been successful in growing stoichiometric thin films of multicomponent oxides. Since traditional glasses are multicomponent oxides, there is the potential for PLD to provide a unique method for growing amorphous coatings on ceramics with precise control of the glass composition. Deposition of an anorthite-based (CaAl2Si2O8) glass on single-crystal α-Al2O3 was chosen as a model system to explore the feasibility of PLD for growing glass layers, since anorthite-based glass films are commonly found in the grain boundaries and triple junctions of liquid-phase sintered α-Al2O3 ceramics.Single-crystal (0001) α-Al2O3 substrates in pre-thinned form were used for film depositions. Prethinned substrates were prepared by polishing the side intended for deposition, then dimpling and polishing the opposite side, and finally ion-milling to perforation.


2010 ◽  
Vol 75 ◽  
pp. 202-207
Author(s):  
Victor Ríos ◽  
Elvia Díaz-Valdés ◽  
Jorge Ricardo Aguilar ◽  
T.G. Kryshtab ◽  
Ciro Falcony

Bi-Pb-Sr-Ca-Cu-O (BPSCCO) and Bi-Pb-Sb-Sr-Ca-Cu-O (BPSSCCO) thin films were grown on MgO single crystal substrates by pulsed laser deposition. The deposition was carried out at room temperature during 90 minutes. A Nd:YAG excimer laser ( = 355 nm) with a 2 J/pulse energy density operated at 30 Hz was used. The distance between the target and substrate was kept constant at 4,5 cm. Nominal composition of the targets was Bi1,6Pb0,4Sr2Ca2Cu3O and Bi1,6Pb0,4Sb0,1Sr2Ca2Cu3OSuperconducting targets were prepared following a state solid reaction. As-grown films were annealed at different conditions. As-grown and annealed films were characterized by XRD, FTIR, and SEM. The films were prepared applying an experimental design. The relationship among deposition parameters and their effect on the formation of superconducting Bi-system crystalline phases was studied.


1998 ◽  
Author(s):  
Dana Miu ◽  
Aurelian Marcu ◽  
T. Yukawa ◽  
Constantin Grigoriu ◽  
Ioan Chis ◽  
...  

1999 ◽  
Vol 574 ◽  
Author(s):  
D. Kumar ◽  
K. G. Cho ◽  
Zhang Chen ◽  
V. Craciun ◽  
P. H. Holloway ◽  
...  

AbstractThe growth, structural and cathodoluminescent (CL) properties of europium activated yttrium oxide (Eu:Y2O3) thin films are reported. The Eu:Y2O3 films were grown in-situ using a pulsed laser deposition technique. Our results show that Eu:Y2O3 films can grow epitaxially on (100) LaAlO3 substrates under optimized deposition parameters. The epitaxial growth of Eu:Y2O3 films on LaAlO3, which has a lattice mismatch of ∼ 60 %, is explained by matching of the atom positions in the lattices of the film and the substrate after a rotation. CL data from these films are consistent with highly crystalline Eu:Y2O3 films with an intense CL emission at 611 nm.


Vacuum ◽  
2009 ◽  
Vol 84 (1) ◽  
pp. 155-157 ◽  
Author(s):  
S. Bakalova ◽  
A. Szekeres ◽  
G. Huhn ◽  
K. Havancsak ◽  
S. Grigorescu ◽  
...  

1994 ◽  
Vol 361 ◽  
Author(s):  
See-Hyung Lee ◽  
Tae W. Noh ◽  
Jai-Hyung Lee ◽  
Young-Gi Kim

ABSTRACTPulsed laser deposition was used to grow epitaxial LiNbO3 films on sapphire(0001) substrates with a single crystal LiNbO3 target. Using deposition temperatures below 450 °C, LiNbO3 films with correct stoichiometry could be grown without using Li-rich targets. Rutherford backscattering spectrometry measurements showed that the oxygen to niobium ratio is 3.00 ± 0.15 to 1.00. It was also found that the crystallographic orientations of the LiNbO3 films could be controlled by adjusting the oxygen pressure during deposition. An x-ray pole figure shows that epitaxial LiNbO3 films were grown on sapphire(0001), but with twin boundaries.


1995 ◽  
Vol 401 ◽  
Author(s):  
Sampriti Sen ◽  
E. Ching-Prado ◽  
A. Reynés-Figueroa ◽  
R. S. Katiyar ◽  
J. S. Horwitz ◽  
...  

AbstractA film of Sr0.35Ba0.65TiO3 (SBT) has been grown in situ by pulsed laser deposition on (001) LaAlO3 single crystal. From X-ray diffraction studies the sample is found to be in single phase and well oriented. Raman spectrum of the SBT film shows bands around 178, 219, 296, 513, 571 and 741 cm”. The spectrum is similar to that found in SBT ceramic material, but the frequencies of the phonons are shifted. This can be explained if the film is under stress due to the presence of defects. The bands at 296 and 741cm−1 correspond to the B1 and A1(LO) normal modes of the BaTiO3 (BT) system, and they are representative of the BT tetragonal phase, which at first glance appears to contradict earlier structural symmetry assignment for SBT(x=0.35) film at room temperature. Micro-Raman measurements from different regions of the film indicate that the SBT film is homogeneous. The bands at 296 and 741 cm−1 are broader in comparison to those in BT single crystal and SBT ceramic material. Temperature dependent halfwidths of these modes suggest strong contribution of defects. Temperature dependent results are discussed in terms of anharmonic contributions involving three and four phonon processes as well as defects. Also, the orthorhombic and rhombohedral phase transitions are discussed. Finally, SEM/EDAX and FT-IR techniques have been used for the structural characterization.


Sign in / Sign up

Export Citation Format

Share Document