Carbon dioxide gas embolism in the experimental animal

1996 ◽  
Vol 3 (4) ◽  
pp. S41-S42
Author(s):  
JA Reichert ◽  
K Nagao ◽  
CV Vinekar ◽  
DS Beebe ◽  
M Fowler ◽  
...  
Keyword(s):  
Carbon Dioxide ◽  
Experimental Animal ◽  
Gas Embolism ◽  
Carbon Dioxide Gas

Efficacy of occlusion of hepatic artery and risk of carbon dioxide gas embolism during laparoscopic hepatectomy in a pig model

2014 ◽  
Vol 21 (8) ◽  
pp. 592-598 ◽  
Author(s):  
Kenji Makabe ◽  
Hiroyuki Nitta ◽  
Takeshi Takahara ◽  
Yasushi Hasegawa ◽  
Shoji Kanno ◽  
...  
Keyword(s):  
Carbon Dioxide ◽  
Hepatic Artery ◽  
Laparoscopic Hepatectomy ◽  
Pig Model ◽  
Gas Embolism ◽  
Carbon Dioxide Gas

Peculiarities of interaction of liquefied carbon dioxide gas with high-viscous oil. Part 4. Sedimentation of complex structural units of the heavy phase

2018 ◽  
pp. 29-39
Author(s):  
A.A. Lobanov ◽  
◽  
K.A. Schekoldin ◽  
M.A. Zvonkov ◽  
M.V. Khlan ◽  
...  
Keyword(s):  
Carbon Dioxide ◽  
Structural Units ◽  
Carbon Dioxide Gas ◽  
Viscous Oil ◽  
Heavy Phase ◽  
Complex Structural

Enhancement of desorption amount of carbon dioxide gas from monoethanolamine solution using ultrasound and calcium chloride

2020 ◽  
Vol 59 (SK) ◽  
pp. SKKD08
Author(s):  
Yuya Kitamura ◽  
Hirokazu Okawa ◽  
Takahiro Kato ◽  
Katsuyasu Sugawara
Keyword(s):  
Carbon Dioxide ◽  
Calcium Chloride ◽  
Carbon Dioxide Gas

STRATIGRAPHIC, SPATIAL, AND STRUCTURAL STYLE OF NATURAL CARBON DIOXIDE GAS ACCUMULATIONS IN THE GREATER PERMIAN BASIN

2016 ◽  
Author(s):  
Ernie R. Slucher ◽  
◽  
Peter D. Warwick ◽  
Christina A. DeVera ◽  
Celeste D. Lohr ◽  
...  
Keyword(s):  
Carbon Dioxide ◽  
Permian Basin ◽  
Carbon Dioxide Gas ◽  
Structural Style ◽  
Natural Carbon

Biofuel Production from Carbon Dioxide Gas in Polluted Areas

2018 ◽  
pp. 127-139 ◽  
Author(s):  
Delia Teresa Sponza ◽  
Cansu Vural ◽  
Gokce Güney
Keyword(s):  
Carbon Dioxide ◽  
Biofuel Production ◽  
Carbon Dioxide Gas

scholarly journals Humidity Measurement in Carbon Dioxide with Capacitive Humidity Sensors at Low Temperature and Pressure

Sensors ◽  
2018 ◽  
Vol 18 (8) ◽  
pp. 2615 ◽  
Author(s):  
Andreas Lorek ◽  
Jacek Majewski
Keyword(s):  
Carbon Dioxide ◽  
Low Temperature ◽  
Sensor Calibration ◽  
Humidity Sensors ◽  
Near Surface ◽  
Adsorption Sites ◽  
Carbon Dioxide Gas ◽  
Individual Calibration ◽  
German Aerospace ◽  
Available Information

In experimental chambers for simulating the atmospheric near-surface conditions of Mars, or in situ measurements on Mars, the measurement of the humidity in carbon dioxide gas at low temperature and under low pressure is needed. For this purpose, polymer-based capacitive humidity sensors are used; however, these sensors are designed for measuring the humidity in the air on the Earth. The manufacturers provide only the generic calibration equation for standard environmental conditions in air, and temperature corrections of humidity signal. Because of the lack of freely available information regarding the behavior of the sensors in CO2, the range of reliable results is limited. For these reasons, capacitive humidity sensors (Sensirion SHT75) were tested at the German Aerospace Center (DLR) in its Martian Simulation Facility (MSF). The sensors were investigated in cells with a continuously humidified carbon dioxide flow, for temperatures between −70 °C and 10 °C, and pressures between 10 hPa and 1000 hPa. For 28 temperature–pressure combinations, the sensor calibration equations were calculated together with temperature–dependent formulas for the coefficients of the equations. The characteristic curves obtained from the tests in CO2 and in air were compared for selected temperature–pressure combinations. The results document a strong cross-sensitivity of the sensors to CO2 and, compared with air, a strong pressure sensitivity as well. The reason could be an interaction of the molecules of CO2 with the adsorption sites on the thin polymeric sensing layer. In these circumstances, an individual calibration for each pressure with respect to temperature is required. The performed experiments have shown that this kind of sensor can be a suitable, lightweight, and relatively inexpensive choice for applications in harsh environments such as on Mars.

Sign in / Sign up

Export Citation Format

Share Document