scholarly journals The effect of phase change on stability of convective flow in a layer of volatile liquid driven by a horizontal temperature gradient

2018 ◽  
Vol 838 ◽  
pp. 248-283 ◽  
Author(s):  
Roman O. Grigoriev ◽  
Tongran Qin

Buoyancy–thermocapillary convection in a layer of volatile liquid driven by a horizontal temperature gradient arises in a variety of situations. Recent studies have shown that the composition of the gas phase, which is typically a mixture of vapour and air, has a noticeable effect on the critical Marangoni number describing the onset of convection as well as on the observed convection pattern. Specifically, as the total pressure or, equivalently, the average concentration of air is decreased, the threshold of the instability leading to the emergence of convective rolls is found to increase rather significantly. We present a linear stability analysis of the problem which shows that this trend can be readily understood by considering the transport of heat and vapour through the gas phase. In particular, we show that transport in the gas phase has a noticeable effect even at atmospheric conditions, when phase change is greatly suppressed.

A phase change may hinder or enhance convection, depending on its characteristics. Univariant transformations such as may occur in the mantle constitute a barrier to convection unless the motion starts at some distance above or below the transition level; an initial temperature gradient in excess of the adiabatic value is also required. Multivariant transformations only require, in the transformation zone, an initial gradient slightly greater than the adiabatic value for a homogeneous layer. The effect on convection of transformation rates is not likely to be serious.


2006 ◽  
Vol 9 (05) ◽  
pp. 530-542 ◽  
Author(s):  
Hadi Nasrabadi ◽  
Kassem Ghorayeb ◽  
Abbas Firoozabadi

Summary We present formulation and numerical solution of two-phase multicomponent diffusion and natural convection in porous media. Thermal diffusion, pressure diffusion, and molecular diffusion are included in the diffusion expression from thermodynamics of irreversible processes. The formulation and the numerical solution are used to perform initialization in a 2D cross section. We use both homogeneous and layered media without and with anisotropy in our calculations. Numerical examples for a binary mixture of C1/C3 and a multicomponent reservoir fluid are presented. Results show a strong effect of natural convection in species distribution. Results also show that there are at least two main rotating cells at steady state: one in the gas cap, and one in the oil column. Introduction Proper initialization is an important aspect of reliable reservoir simulations. The use of the Gibbs segregation condition generally cannot provide reliable initialization in hydrocarbon reservoirs. This is caused, in part, by the effect of thermal diffusion (caused by the geothermal temperature gradient), which cannot be neglected in some cases; thermal diffusion might be the main phenomenon affecting compositional variation in hydrocarbon reservoirs, especially for near-critical gas/condensate reservoirs (Ghorayeb et al. 2003). Generally, temperature increases with increasing burial depth because heat flows from the Earth's interior toward the surface. The temperature profile, or geothermal gradient, is related to the thermal conductivity of a body of rock and the heat flux. Thermal conductivity is not necessarily uniform because it depends on the mineralogical composition of the rock, the porosity, and the presence of water or gas. Therefore, differences in thermal conductivity between adjacent lithologies can result in a horizontal temperature gradient. Horizontal temperature gradients in some offshore fields can be observed because of a constant water temperature (approximately 4°C) in different depths in the seabed floor. The horizontal temperature gradient causes natural convection that might have a significant effect on species distribution (Firoozabadi 1999). The combined effects of diffusion (pressure, thermal, and molecular) and natural convection on compositional variation in multicomponent mixtures in porous media have been investigated for single-phase systems (Riley and Firoozabadi 1998; Ghorayeb and Firoozabadi 2000a).The results from these references show the importance of natural convection, which, in some cases, overrides diffusion and results in a uniform composition. Natural convection also can result in increased horizontal compositional variation, an effect similar to that in a thermogravitational column (Ghorayeb and Firoozabadi 2001; Nasrabadi et al. 2006). The combined effect of convection and diffusion on species separation has been the subject of many experimental studies. Separation in a thermogravitational column with both effects has been measured widely (Schott 1973; Costeseque 1982; El Mataaoui 1986). The thermogravitational column consists of two isothermal vertical plates with different temperatures separated by a narrow space. The space can be either without a porous medium or filled with a porous medium. The thermal diffusion, in a binary mixture, causes one component to segregate to the hot plate and the other to the cold plate. Because of the density gradient caused by temperature and concentration gradients, convection flow occurs and creates a concentration difference between the top and bottom of the column. Analytical and numerical models have been presented to analyze the experimental results (Lorenz and Emery 1959; Jamet et al. 1992; Nasrabadi et al. 2006). The experimental and theoretical studies show that the composition difference between the top and bottom of the column increases with permeability until an optimum permeability is reached. Then, the composition difference declines as permeability increases. The process in a thermogravitational column shows the significance of the convection from a horizontal temperature gradient.


2003 ◽  
Vol 3 (5) ◽  
pp. 1609-1631 ◽  
Author(s):  
D. Brunner ◽  
J. Staehelin ◽  
H. L. Rogers ◽  
M. O. Köhler ◽  
J. A. Pyle ◽  
...  

Abstract. A rigorous evaluation of five global Chemistry-Transport and two Chemistry-Climate Models operated by several different groups in Europe, was performed. Comparisons were made of the models with trace gas observations from a number of research aircraft measurement campaigns during the four-year period 1995-1998. Whenever possible the models were run over the same four-year period and at each simulation time step the instantaneous tracer fields were interpolated to all coinciding observation points. This approach allows for a very close comparison with observations and fully accounts for the specific meteorological conditions during the measurement flights. This is important considering the often limited availability and representativity of such trace gas measurements. A new extensive database including all major research and commercial aircraft measurements between 1995 and 1998, as well as ozone soundings, was established specifically to support this type of direct comparison. Quantitative methods were applied to judge model performance including the calculation of average concentration biases and the visualization of correlations and RMS errors in the form of so-called Taylor diagrams. We present the general concepts applied, the structure and content of the database, and an overall analysis of model skills over four distinct regions. These regions were selected to represent various atmospheric conditions and to cover large geographical domains such that sufficient observations are available for comparison. The comparison of model results with the observations revealed specific problems for each individual model. This study suggests the further improvements needed and serves as a benchmark for re-evaluations of such improvements. In general all models show deficiencies with respect to both mean concentrations and vertical gradients of important trace gases. These include ozone, CO and NOx at the tropopause. Too strong two-way mixing across the tropopause is suggested to be the main reason for differences between simulated and observed CO and ozone values. The generally poor correlations between simulated and measured NOx values suggest that in particular the NOx input by lightning and the convective transport from the polluted boundary layer are still not well described by current parameterizations, which may lead to significant differences in the spatial and seasonal distribution of NOx in the models. Simulated OH concentrations, on the other hand, were found to be in surprisingly good agreement with measured values.


1966 ◽  
Vol 44 (4) ◽  
pp. 511-517 ◽  
Author(s):  
D. M. Ogilvie ◽  
R. H. Stinson

Adult animals have been used for most of the previous mammalian temperature selection studies, and relatively few systematic observations have been made with young animals. In this investigation, laboratory mice (Mus musculus), ranging in age from 1 to 84 days, were studied in a horizontal temperature gradient established along a 5-ft copper bar. Despite poorly developed locomotion and cold immobilization, it was shown that the temperature selection response is present at birth. The initially high level of selection appeared to be maintained for about 2 weeks, after which it began to decrease, rapidly at first, and then more slowly until the adult level was reached.


2009 ◽  
Vol 9 (5) ◽  
pp. 1711-1722 ◽  
Author(s):  
R. K. Pathak ◽  
W. S. Wu ◽  
T. Wang

Abstract. Strong atmospheric photochemistry in summer can produce a significant amount of secondary aerosols, which may have a large impact on regional air quality and visibility. In the study reported herein, we analyzed sulfate, nitrate, and ammonium in PM2.5 samples collected using a 24-h filter system at suburban and rural sites near four major cities in China (Beijing, Shanghai, Guangzhou, and Lanzhou). Overall, the PM2.5 mass concentrations were high (with a mean value of 55–68 gμgm−3), which reflects the long-known particulate pollution in China's large urban centers. We observed very high concentrations of sulfate and nitrate at the Beijing and Shanghai sites, and, in particular, abnormally high levels of nitrate (24-h average concentration up to 42 gμgm−3 and contributing up to 25% of the PM2.5 mass) in the ammonium-poor samples. The Beijing and Shanghai aerosols were characterized by high levels of aerosol acidity (~220–390 nmol m−3) and low levels of in-situ pH (−0.77 to −0.52). In these samples, the formation of the observed high concentrations of particulate nitrate cannot be explained by homogeneous gas-phase reaction between ammonia and nitric acid. Examination of the relation of nitrate to relative humidity and aerosol loading suggests that the nitrate was most probably formed via the heterogeneous hydrolysis of N2O5 on the surface of the moist and acidic aerosols in Beijing and Shanghai. In comparison, the samples collected in Lanzhou and Guangzhou were ammonium-rich with low levels of aerosol acidity (~65–70 nmol m−3), and the formation of ammonium nitrate via the homogeneous gas-phase reaction was favored, which is similar to many previous studies. An empirical fit has been derived to relate fine nitrate to aerosol acidity, aerosol water content, aerosol surface area, and the precursor of nitrate for the data from Beijing and Shanghai.


Sign in / Sign up

Export Citation Format

Share Document