The generation of symmetrical duct velocity profiles of high uniform shear

1964 ◽  
Vol 20 (2) ◽  
pp. 201-208 ◽  
Author(s):  
J. L. Livesey ◽  
J. T. Turner

The logical design method of Owen & Zienkiewicz (1957), for the generation of linear shear flow, is successfully applied to the case of symmetrical velocity profiles in a two-dimensional duct. Shear parameters as high as 0·8 (corresponding to $\hat{V}| \overline {V} = 1\cdot4$) are obtained experimentally. Some slight modification to the theoretical grid spacing is required because of the non-uniformity of the upstream flow.The decay of the profiles is confined to that due to the developing boundary layer and to the breakdown of the physically impossible condition at the centre, where symmetry implies a change in sign of the uniform shear.

A phenomenon of boundary-layer instability is discussed from the theoretical and experimental points of view. The china-clay evaporation technique shows streaks on the surface, denoting a vortex system generated in the region of flow upstream of transition. Experiments on a swept wing are described briefly, while experiments on the flow due to a rotating disk receive much greater attention. In the latter case, the axes of the disturbance vortices take the form of equi-angular spirals, bounded by radii of instability and of transition. A frequency analysis of the disturbances shows that there is a narrow band of disturbance components of high amplitude, some frequencies within this band corresponding to disturbances fixed relative to the surface and others corresponding to moving waves. Furthermore, the determination of velocity profiles for the rotating-disk flow is described, the agreement with the theoretical solution for laminar flow being quite satisfactory; for turbulent flow, however, the empirical theories are not very satisfactory. In order to explain the vortex phenomenon just discussed, the general equations of motion in orthogonal curvilinear co-ordinates are examined by superimposing an infinitesimal disturbance periodic in space and time on the main flow, and linearizing for small disturbances. An important result is that, within the range of certain approximations, the velocity component in the direction of propagation of the disturbance may be regarded as a two-dimensional flow for stability purposes; then the problem of stability formally resembles the well-known two dimensional problem. However, it is important to emphasize that this result—namely, that the flow curvature has little influence on stability—is applicable only to the possible modes of instability in a local region. The nature of three-dimensional flows is discussed, and the importance of co-ordinates along and normal to the stream-lines outside the boundary layer is examined. In accord with the formal two-dimensional nature of the instability, there is a whole class of velocity distributions, corresponding to different directions, which may exhibit instability. The question of stability at infinite Reynolds number is examined in detail for these profiles. As for ordinary two-dimensional flows, the wave velocity of the disturbance must lie somewhere between the maximum and minimum of the velocity profile considered. The points where the wave velocity equals the fluid velocity are called critical points, of which most of the profiles considered have two. Then Tollmien’s criterion that velocity profiles with a point of inflexion are unstable at infinite Reynolds number is extended to the case of profiles with two critical points. One particular profile—namely, that for which the point of inflexion lies at the point of zero velocity—may generate neutral disturbances of zero phase velocity, corresponding to the disturbances visualized by the china-clay technique. A variational method for the solution of certain of the eigenvalue problems associated with stability at infinite Reynolds number is derived, found by comparison with an exact solution to be very accurate, and applied to the rotating disk. The fixed vortices predicted by the theory have as their axes equi-angular spirals of angle 103°, in good agreement with experiment, but the agreement between theoretical and experimental wave number is not good, the discrepancy being attributed to viscosity. Finally, the correlation between the experimentally observed and theoretically possible disturbances is discussed and certain conclusions drawn therefrom. The streamlines of the disturbed boundary layer show the existence of a double row of vortices, one row of which produces the streaks in the china clay. Application of the theory to other physical phenomena is described.


1976 ◽  
Vol 76 (2) ◽  
pp. 383-399 ◽  
Author(s):  
K. G. Ranga Raju ◽  
J. Loeser ◽  
E. J. Plate

The properties of a turbulent boundary layer were investigated as they relate to the form drag on a two-dimensional fence. Detailed measurements were performed at zero pressure gradient of velocity profiles along smooth, rough and transitional flat plates. Upon comparison with other published data, these measurements resulted in simple formulae for the displacement thickness and the local shear coefficient and in a modification to the universal velocity defect law for equilibrium boundary layers.With these boundary layers, experiments were performed to determine the drag on a two-dimensional fence. These data were analysed along with data from previous investigations. It was found that after suitable blockage corrections all form-drag coefficients for two-dimensional fences collapsed on a single curve if they were calculated with the shear velocity as the reference velocity and plotted against the ratio of the fence height to the characteristic roughness parameter of the approaching flow.


1990 ◽  
Vol 27 (04) ◽  
pp. 250-256
Author(s):  
Stuart Wilkinson

An experimental aerodynamic boundary-layer investigation is performed over the suction surfaces of a typical two-dimensional mast/sail geometry. Velocity profiles are obtained at a number of locations which, together with visualization data and the corresponding static pressure distribution, are used to describe the fundamental nature of the complex partially separated flow field associated with such geometries. The velocity profiles are fully analyzed to provide thickness parameters and skin friction coefficients, suitable for use as representative data in the development of predictive theories involving viscid-inviscid interactions. The chordwise variations of the thickness parameters are graphically presented and discussed.


1966 ◽  
Vol 25 (1) ◽  
pp. 87-95 ◽  
Author(s):  
Simon L. Goren

The development of the boundary layer accompanying the formation of a free surface at y′ = 0, from the two-dimensional uniform shear flow u′ = ωyω, is discussed. The analysis shows that the surface velocity and surface position vary as the cube root of the distance downstream, while the mass-transfer coefficient varies inversely as the cube root of this distance. It is shown how these may be applied to the formation of capillary jets.


1969 ◽  
Vol 91 (3) ◽  
pp. 462-474 ◽  
Author(s):  
S. Wolf ◽  
J. P. Johnston

An analytical and experimental study on the effects of large distortions of inlet velocity profiles on flow regimes and performance in diffusers is reported. Experiments are restricted to flow in straight, two-dimensional diffusers with turbulent boundary layers. Systematic data are obtained for two general types of inlet flows: (1) simple, uniform shear flows in the core, and (2) severely nonuniform shear flows of the wake, jet, and step-shear type. For uniform shear flows a first order prediction method based on inviscid rotational flow and the boundary layer blockage concept is developed and verified for diffusers operating in the unstalled flow regime. For nonuniform shear flows the inviscid rotational model is shown to predict performance trends better than the irrotational model; however, the inviscid rotational model is inadequate as a precise prediction method because no account is taken of mixing in the core region. Geometry and performance correlations for peak pressure recovery (at constant N/W1) are also established.


1965 ◽  
Vol 22 (3) ◽  
pp. 443-448 ◽  
Author(s):  
A. J. Reynolds

The empirical description of turbulent wall layers across which the shear stress varies is considered. The description given by Townsend for zero-stress layers is found to be inapplicable to uniform pressure flows in pipes and two-dimensional channels, and to a boundary layer developing in the absence of a pressure gradient.


1968 ◽  
Vol 19 (1) ◽  
pp. 1-19 ◽  
Author(s):  
H. McDonald

SummaryRecently two authors, Nash and Goldberg, have suggested, intuitively, that the rate at which the shear stress distribution in an incompressible, two-dimensional, turbulent boundary layer would return to its equilibrium value is directly proportional to the extent of the departure from the equilibrium state. Examination of the behaviour of the integral properties of the boundary layer supports this hypothesis. In the present paper a relationship similar to the suggestion of Nash and Goldberg is derived from the local balance of the kinetic energy of the turbulence. Coupling this simple derived relationship to the boundary layer momentum and moment-of-momentum integral equations results in quite accurate predictions of the behaviour of non-equilibrium turbulent boundary layers in arbitrary adverse (given) pressure distributions.


Sign in / Sign up

Export Citation Format

Share Document