Effect of Offering Concentrate Rations with Different Energy Densities on Calf Performance

1993 ◽  
Vol 1993 ◽  
pp. 209-209 ◽  
Author(s):  
R.J. Fallon ◽  
J.R. Twigge
Keyword(s):  
Energy Density ◽  
Rapid Growth ◽  
High Energy ◽  
Solid Food ◽  
Milk Replacer ◽  
Successful Transition ◽  
Calf Performance ◽  
Ad Libitum

The primary aim of the calf rearer is to ensure a successful transition from non ruminant to ruminant status while achieving rapid growth and an early intake of solid food. Newbold, Blake and Hagges (1991), found that increasing the concentration of ME in either the starter or milk replacer will not promote more rapid growth, but will simply reduce the rate of starter consumption. This present study investigated the extent to which the energy density of a calf starter ration affected starter intake and liveweight gain in calves receiving a fixed allowance of a high energy milk replacer with ad libitum access to solid calf starter rations.

scholarly journals Decoquinate, lasalocid and monensin for starter feeds and the performance of holstein calves to 20 weeks of age

2002 ◽  
Vol 59 (3) ◽  
pp. 421-426 ◽  
Author(s):  
Carla Maris Bittar Nussio ◽  
John Tal Huber ◽  
Luiz Gustavo Nussio
Keyword(s):  
Dry Matter ◽  
Dry Matter Intake ◽  
Milk Replacer ◽  
Dairy Herds ◽  
Free Access ◽  
Hot Climate ◽  
Calf Performance ◽  
Access To Water ◽  
Holstein Calves ◽  
Ad Libitum

The large utilization of coccidiostats in dairy herds has raised the question regards the best product to use, based on better animal performance. Sixty-four Holstein calves were randomly assigned to four treatments at 10 (±4) d of age to evaluate calf performance when fed approved coccidiostats available on the market in Arizona, USA. Calves received a dry calf starter without (control) or with one of the following coccidiostats: lasalocid, 30 mg kg-1; decoquinate, 19 mg kg-1; and monensin, 30 mg kg-1. Calves received 3.6 kg d-1 of a commercial 22% CP:20% fat milk replacer until 6 wk of age. Calves were offered starter "ad libitum" up to 2 kg d-1, and calves had free access to water throughout the trial. Alfalfa hay was offered "ad libitum" after weaning. Performance and dry matter intake (DMI) were monitored for 20 weeks and broken down in different periods of measurement (0-6, 7-12 and 13-20 weeks, respectively). Despite the lower dry matter intake and weight gain for females on monensin treatment during the whole period, differences among coccidiostats were seldom observed under the conditions of this study. Good calf management and the dry, hot climate of Arizona perhaps diminished the chances for subclinical and chronic disease appearance which negated potential differences and differences in calf performances.

scholarly journals A plant-based, low-fat diet decreases ad libitum energy intake compared to an animal-based, ketogenic diet: An inpatient randomized controlled trial

2020 ◽  
Author(s):  
Kevin D Hall ◽  
Juen Guo ◽  
Amber B. Courville ◽  
James Boring ◽  
Robert Brychta ◽  
...  
Keyword(s):  
Energy Density ◽  
Energy Intake ◽  
Body Fat ◽  
Dietary Fat ◽  
High Energy ◽  
High Energy Density ◽  
Low Fat ◽  
Low Carbohydrate ◽  
Competing Models ◽  
Ad Libitum

Competing models of obesity and its treatment often contrast the relative roles of dietary fat versus carbohydrate. Advocates of low-carbohydrate diets posit that intake of high glycemic carbohydrates leads to elevated postprandial insulin thereby promoting body fat accumulation while increasing hunger and energy intake according to the carbohydrate-insulin model of obesity. Alternatively, proponents of low-fat diets argue that high fat intake promotes body fat storage due to passive overconsumption of energy resulting from the high energy density of dietary fat. To test these competing models, 20 adults without diabetes aged (mean±SE) 29.9±1.4 y with BMI=27.8±1.3 kg/m2 were admitted as inpatients to the NIH Clinical Center and randomized to consume ad libitum either a plant-based, low-fat (PBLF) diet (75.2% carbohydrate, 10.3% fat, non-beverage energy density = 1.1 kcal/g) or an animal-based, ketogenic, low-carbohydrate (ABLC) diet (75.8% fat,10.0% carbohydrate, non-beverage energy density = 2.2 kcal/g) for two weeks followed immediately by the alternate diet for two weeks. Three daily meals plus snacks amounting to twice each subject’s estimated energy requirements were provided and subjects were instructed to eat as much or as little as desired. The PBLF diet resulted in substantially greater glucose and insulin levels whereas the ABLC diet led to increased blood ketones of ~3 mM which is thought to suppress appetite. However, ad libitum energy intake was 689±73 kcal/d lower during the PBLF diet as compared to the ABLC diet (p<0.0001) with no significant differences in appetite ratings or enjoyment of meals. These data challenge the veracity of the carbohydrate-insulin model of obesity and suggest that the PBLF diet had benefits for appetite control whereas the ABLC diet had benefits for lowering blood glucose and insulin.

scholarly journals Evaluation of Digestible lysine levels in diets with high energy density for finishing pigs

2015 ◽  
pp. 4522-4533
Author(s):  
Janeth Colina R ◽  
Miguel Díaz E ◽  
Luis Manzanilla M ◽  
Humberto Araque M ◽  
Gonzálo Martínez G ◽  
...  
Keyword(s):  
Body Weight ◽  
Weight Gain ◽  
Energy Density ◽  
Carcass Characteristics ◽  
High Energy ◽  
High Energy Density ◽  
Daily Weight Gain ◽  
Finishing Pigs ◽  
Productive Performance ◽  
Ad Libitum

ABSTRACTObjective. To evaluate the effects of different levels of digestible lysine in diets with high energy density on productive performance and carcass characteristics of finishing pigs. Materials and Methods. Seventy crossbred barrows (initial body weight of 83.36 kg) were used and allotted in a randomized block design with five treatments, seven replications and two pigs per experimental unit. Pigs were fed ad libitum with diets containing 3.5 kcal/kg of ME and five levels of digestible lysine (0.46, 0.52, 0.58, 0.64 and 0.70%) during four weeks. Final live weight (FLW), daily feed intake (DFI), daily weight gain (DWG), feed conversion (FC), daily lysine intake (DLI), and the amount of lysine per body weight gain (DLI/DWG), were evaluated. At the end of the experiment, blood samples were taken from each pig to determine urea nitrogen concentration (UN) in serum and slaughtered to evaluate quantitative and qualitative carcass characteristics. Results. The FLW increased linearly (p<0.05).There were no differences among treatments for DFI, DWG, FC, carcass characteristics and UN. The DLI and DLI/DWG varied significantly (p<0.001) and increased linearly (p<0.001) with each lysine level. Pigs that consumed the limiting diet in lysine (0.46%) showed less DLI and DLI/DWG (p<0.001) than pigs fed the other diets. Conclusions. The amount of DLI/DWG increased with the evaluated levels of digestible lysine in diets with high energy density, without effects on productive performance and carcass characteristics of finishing pigs. RESUMENObjetivo. Evaluar los efectos de diferentes niveles de lisina digestible en dietas con alta densidad energética sobre el desempeño productivo y características de la canal de cerdos en finalización. Materiales y métodos. Se utilizaron 70 cerdos (peso inicial de 83.36 kg) mestizos castrados, distribuidos en un diseño de bloques al azar con cinco tratamientos, siete repeticiones y dos cerdos por unidad experimental. Los cerdos fueron alimentados ad libitum con dietas que contenían 3.5 Mcal/kg de energía metabolizable y cinco niveles de lisina digestible (0.46, 0.52, 0.58, 0.64 y 0.70%) durante cuatro semanas. Se evaluaron: peso vivo final (PVF), consumo diario de alimento (CDA), ganancia diaria de peso (GDP), conversión de alimento (CA), consumo diario de lisina (CDLis) y la cantidad de lisina por peso ganado (CDLis/GDP). Al final de experimento, se extrajeron muestras de sangre de todos los cerdos para determinar la concentración de nitrógeno ureico (NU) en suero sanguíneo y luego se sacrificaron para evaluar las características cualitativas y cuantitativas de la canal. Resultados. No se observaron diferencias significativas entre tratamientos para CDA, GDP, CA, características de la canal y NU. El PVF incrementó linealmente (p<0.05). El CDLis y la CDLis/GDP variaron significativamente (p<0.001) e incrementaron linealmente (p<0.001) con cada nivel de lisina. Los cerdos que consumieron la dieta limitante en lisina (0.46%) mostraron menor consumo y CDLis/GDP (p<0.001) que los cerdos alimentados con las otras dietas. Conclusiones. Los niveles de lisina digestible evaluados en dietas con alta densidad energética aumentan la CDLis/GDP, sin efectos sobre el desempeño productivo y las características de la canal de los cerdos en finalización.

A HIGH ENERGY DENSITY ZINC/OXYGEN BATTERY SYSTEM

1966 ◽  
Author(s):  
S. CHODOSH ◽  
E. KATSOULIS ◽  
M. ROSANSKY
Keyword(s):  
Energy Density ◽  
High Energy ◽  
High Energy Density ◽  
Battery System

Efficient Co-Harvesting of Solar Energy and Low-Grade Heat by Molecular Photoswitches for High Energy Density, Long-Term Stable Solar Thermal Battery

2019 ◽  
Author(s):  
Zhao-Yang Zhang ◽  
Tao LI
Keyword(s):  
Energy Density ◽  
Solar Energy ◽  
High Performance ◽  
High Energy ◽  
Solar Thermal ◽  
High Energy Density ◽  
Low Grade ◽  
Thermal Battery ◽  
Low Grade Heat

Solar energy and ambient heat are two inexhaustible energy sources for addressing the global challenge of energy and sustainability. Solar thermal battery based on molecular switches that can store solar energy and release it as heat has recently attracted great interest, but its development is severely limited by both low energy density and short storage stability. On the other hand, the efficient recovery and upgrading of low-grade heat, especially that of the ambient heat, has been a great challenge. Here we report that solar energy and ambient heat can be simultaneously harvested and stored, which is enabled by room-temperature photochemical crystal-to-liquid transitions of small-molecule photoswitches. The two forms of energy are released together to produce high-temperature heat during the reverse photochemical phase change. This strategy, combined with molecular design, provides high energy density of 320-370 J/g and long-term storage stability (half-life of about 3 months). On this basis, we fabricate high-performance, flexible film devices of solar thermal battery, which can be readily recharged at room temperature with good cycling ability, show fast rate of heat release, and produce high-temperature heat that is >20<sup> o</sup>C higher than the ambient temperature. Our work opens up a new avenue to harvest ambient heat, and demonstrate a feasible strategy to develop high-performance solar thermal battery.

Efficient Co-Harvesting of Solar Energy and Low-Grade Heat by Molecular Photoswitches for High Energy Density, Long-Term Stable Solar Thermal Battery

2019 ◽  
Author(s):  
Zhao-Yang Zhang ◽  
Tao LI
Keyword(s):  
Energy Density ◽  
Solar Energy ◽  
High Performance ◽  
High Energy ◽  
Solar Thermal ◽  
High Energy Density ◽  
Low Grade ◽  
Thermal Battery ◽  
Low Grade Heat

Solar energy and ambient heat are two inexhaustible energy sources for addressing the global challenge of energy and sustainability. Solar thermal battery based on molecular switches that can store solar energy and release it as heat has recently attracted great interest, but its development is severely limited by both low energy density and short storage stability. On the other hand, the efficient recovery and upgrading of low-grade heat, especially that of the ambient heat, has been a great challenge. Here we report that solar energy and ambient heat can be simultaneously harvested and stored, which is enabled by room-temperature photochemical crystal-to-liquid transitions of small-molecule photoswitches. The two forms of energy are released together to produce high-temperature heat during the reverse photochemical phase change. This strategy, combined with molecular design, provides high energy density of 320-370 J/g and long-term storage stability (half-life of about 3 months). On this basis, we fabricate high-performance, flexible film devices of solar thermal battery, which can be readily recharged at room temperature with good cycling ability, show fast rate of heat release, and produce high-temperature heat that is >20<sup> o</sup>C higher than the ambient temperature. Our work opens up a new avenue to harvest ambient heat, and demonstrate a feasible strategy to develop high-performance solar thermal battery.

Si Nanowire Anode Prepared by Chemical Etching for High Energy Density Lithium-ion Battery

2013 ◽  
Vol 28 (11) ◽  
pp. 1207-1212 ◽  
Author(s):  
Jian-Wen LI ◽  
Ai-Jun ZHOU ◽  
Xing-Quan LIU ◽  
Jing-Ze LI
Keyword(s):  
Energy Density ◽  
Lithium Ion Battery ◽  
Chemical Etching ◽  
Lithium Ion ◽  
High Energy ◽  
High Energy Density ◽  
Si Nanowire
Sign in / Sign up

Export Citation Format

Share Document