The Use of Styrenes as Embedding Media for Electron Microscopy

1971 ◽  
Vol 29 ◽  
pp. 488-489
Author(s):  
Edward D. De-Lamater ◽  
Eric Johnson ◽  
Thad Schoen ◽  
Cecil Whitaker
Keyword(s):  
Electron Microscopy ◽  
Surface Tension ◽  
Ultraviolet Light ◽  
Methyl Ethyl Ketone Peroxide ◽  
Methyl Ethyl ◽  
Styrene Polymerization ◽  
Radical Initiation ◽  
Tertiary Butyl ◽  
Low Viscosity ◽  
Free Radical Initiation

Monomeric styrenes are demonstrated as excellent embedding media for electron microscopy. Monomeric styrene has extremely low viscosity and low surface tension (less than 1) affording extremely rapid penetration into the specimen. Spurr's Medium based on ERL-4206 (J.Ultra. Research 26, 31-43, 1969) is viscous, requiring gradual infiltration with increasing concentrations. Styrenes are soluble in alcohol and acetone thus fitting well into the usual dehydration procedures. Infiltration with styrene may be done directly following complete dehydration without dilution.Monomeric styrenes are usually inhibited from polymerization by a catechol, in this case, tertiary butyl catechol. Styrene polymerization is activated by Methyl Ethyl Ketone peroxide, a liquid, and probably acts by overcoming the inhibition of the catechol, acting as a source of free radical initiation.Polymerization is carried out either by a temperature of 60°C. or under ultraviolet light with wave lengths of 3400-4000 Engstroms; polymerization stops on removal from the ultraviolet light or heat and is therefore controlled by the length of exposure.

The Critical Point Drying Method Applied to Scanning Electron Microscopy of L-929 Cells

1970 ◽  
Vol 28 ◽  
pp. 278-279
Author(s):  
Charles TurnbiLL ◽  
Delbert E. Philpott
Keyword(s):  
Electron Microscopy ◽  
Carbon Dioxide ◽  
Surface Tension ◽  
Critical Point ◽  
Freeze Drying ◽  
Attractive Alternative ◽  
Crystal Formation ◽  
Critical Point Drying ◽  
Time Required ◽  
Scanning Electron

The advent of the scanning electron microscope (SCEM) has renewed interest in preparing specimens by avoiding the forces of surface tension. The present method of freeze drying by Boyde and Barger (1969) and Small and Marszalek (1969) does prevent surface tension but ice crystal formation and time required for pumping out the specimen to dryness has discouraged us. We believe an attractive alternative to freeze drying is the critical point method originated by Anderson (1951; for electron microscopy. He avoided surface tension effects during drying by first exchanging the specimen water with alcohol, amy L acetate and then with carbon dioxide. He then selected a specific temperature (36.5°C) and pressure (72 Atm.) at which carbon dioxide would pass from the liquid to the gaseous phase without the effect of surface tension This combination of temperature and, pressure is known as the "critical point" of the Liquid.

Resolution in photoelectron microscopy

1991 ◽  
Vol 49 ◽  
pp. 458-459
Author(s):  
G. F. Rempfer
Keyword(s):  
Electron Microscopy ◽  
Electric Field ◽  
Ultraviolet Light ◽  
Uniform Field ◽  
Virtual Image ◽  
Lens System ◽  
Photoemission Electron Microscopy ◽  
Planar Electrode ◽  
Electron Lens ◽  
Photoemission Electron

In photoelectron microscopy (PEM), also called photoemission electron microscopy (PEEM), the image is formed by electrons which have been liberated from the specimen by ultraviolet light. The electrons are accelerated by an electric field before being imaged by an electron lens system. The specimen is supported on a planar electrode (or the electrode itself may be the specimen), and the accelerating field is applied between the specimen, which serves as the cathode, and an anode. The accelerating field is essentially uniform except for microfields near the surface of the specimen and a diverging field near the anode aperture. The uniform field forms a virtual image of the specimen (virtual specimen) at unit lateral magnification, approximately twice as far from the anode as is the specimen. The diverging field at the anode aperture in turn forms a virtual image of the virtual specimen at magnification 2/3, at a distance from the anode of 4/3 the specimen distance. This demagnified virtual image is the object for the objective stage of the lens system.

Electron microscopy and diffraction of crystalline dendrimers and macrocycles

1993 ◽  
Vol 51 ◽  
pp. 1218-1219
Author(s):  
C. J. Buchko ◽  
P. M. Wilson ◽  
Z. Xu ◽  
J. Zhang ◽  
S. Lee ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Liquid Crystalline ◽  
Structural Information ◽  
High Resolution Electron Microscopy ◽  
Scanning Calorimetry ◽  
Tertiary Butyl ◽  
Phenyl Acetylene ◽  
Selected Area Electron Diffraction ◽  
Liquid Crystalline Phases ◽  
Resolution Electron

The synthesis of well-defined organic molecules with unique geometries opens new opportunities for understanding and controlling the organization of condensed matter. Here, we study dendrimers and macrocycles which are synthesized from rigid phenyl-acetylene spacer units, Both units are solubilized by the presence of tertiary butyl groups located at the periphery of the molecule. These hydrocarbon materials form crystalline and liquid crystalline phases which have been studied by differential scanning calorimetry, hot stage optical microscopy, and wide-angle x-ray scattering (WAXS).The precisely defined architecture of these molecules makes it possible to investigate systematic variations in chemical architecture on the nature of microstructural organization. Here we report on the transmission electron microscopy (TEM), selected area electron diffraction (SAED), and high resolution electron microscopy (HREM) studies of crystalline thin films formed by deposition of these materials onto carbon substrates from dilute solution. Electron microscopy is very attractive for gaining structural information on new molecules due to the scarcity of material to grow single crystals suitable for conventional crystallography.

Relative Reactivities of 1,1,1-Trichloroethane and 1,1,1-Trichlorotrifluoroethane in Competitive Addition Reactions

1992 ◽  
Vol 57 (6) ◽  
pp. 1291-1298 ◽  
Author(s):  
František Adámek ◽  
Milan Hájek ◽  
Zbyněk Janoušek
Keyword(s):  
Free Radical ◽  
Reaction Mechanism ◽  
Relative Reactivity ◽  
Addition Reactions ◽  
Radical Initiation ◽  
Amine Complexes ◽  
Free Radical Initiation ◽  
Ru Complexes ◽  
Radical Initiators

Relative reactivity of CH3CCl3 and CF3CCl3 measured in competitive addition reactions with 1-hexene in the presence of free radical initiators or Cu, Pd and Ru complexes was found to depend on the type of catalyst. The unusual course of the reaction has been found in the additions catalyzed with copper(I)-amine complexes where CH3CCl3 in competition with CF3CCl3 was completely unreactive. The results have been explained in terms of the change of reaction mechanism and compared with classical free radical initiation.

scholarly journals Study of Experimental Investigations in the Presence of Ceramic Waste Powder

2021 ◽  
Vol 57 (4) ◽  
pp. 1-12
Author(s):  
Mohamed Farsane ◽  
Abdellah Anouar ◽  
Souad Chah ◽  
Said Dagdag ◽  
Miloud Bouzziri
Keyword(s):  
Methyl Ethyl Ketone ◽  
Polyester Resin ◽  
Unsaturated Polyester ◽  
Unsaturated Polyester Resin ◽  
Experimental Investigations ◽  
Methyl Ethyl Ketone Peroxide ◽  
Methyl Ethyl ◽  
Gel Time ◽  
Simple Method ◽  
Ceramic Waste

The paper aims to evaluate the gel time and exotherm temperature properties of the curing of unsaturated polyester resin at various amounts of Methyl ethyl ketone peroxide, cobalt octoate and porcelain powder. The gel time of samples are determined using the simple method, while the exotherm temperature are evaluated using the thermocouple. The variation of these properties is discussed theoretically and experimentally.

scholarly journals Improvement of acid solutions for stimulation of compacted high-temperature carbonate collectors

2021 ◽  
Vol 6 (3(62)) ◽  
pp. 11-14
Author(s):  
Oleh Zimin
Keyword(s):  
Surface Tension ◽  
Acetic Acid ◽  
High Temperature ◽  
Reaction Rate ◽  
Methyl Acetate ◽  
Surface Tension Coefficient ◽  
Gradual Transition ◽  
Acid Solutions ◽  
Hydrocarbon Production ◽  
Low Viscosity

The object of research in this work is the intensification of hydrocarbon production. The most problematic task of the study is the efficiency of intensification of compacted high-temperature carbonate reservoirs. Despite the gradual transition to renewable energy sources, natural gas and oil will play a dominant role in the world's energy balance in the next 20–30 years. Carbonate rocks have significant mining potential, but low filtration properties require intensification to improve reservoir permeability. High temperatures and pressures at great depths require the improvement of existing hydrocarbon production technologies. The most popular method for treating reservoirs containing carbonates is acid treatments in different variations, but for effective treatment it is necessary to achieve deep penetration of the solution into the formation. The study solves the problem of selection of effective carrier liquids for the preparation of acid solutions for the treatment of compacted high-temperature reservoirs with high carbonate content. To ensure quality treatment, acid solutions must have low viscosity and surface tension coefficient, low reaction rate, their chemical properties must ensure the absence of insoluble precipitates in the process of reactions with fluids and rocks, as well as be environmentally friendly. To select the most optimal carrier liquid, experiments were conducted to determine which candidate liquids provide the minimum reaction rate of acidic solutions with carbonates. Based on the analysis of industrial application data and literature sources, water, nephras, methanol, ethyl acetate, and methyl acetate were selected for further research. Widely studied acetic acid was chosen as the basic acid. Studies have shown that methyl acetate has a number of advantages, namely low reaction rate, low viscosity and surface tension coefficient. As well as the possibility of hydrolysis in the formation with the release of acetic acid, which significantly prolongs the reaction time of the solution with the rock and the depth of penetration of the active solution into the formation.

Sign in / Sign up

Export Citation Format

Share Document