scholarly journals Clathrate Adhesion Induced by Quasi-Liquid Layer

Author(s):  
Ngoc N. Nguyen ◽  
Rüdiger Berger ◽  
Michael Kappl ◽  
Hans-Jürgen Butt
2008 ◽  
Vol 8 (23) ◽  
pp. 7087-7099 ◽  
Author(s):  
W. Liao ◽  
D. Tan

Abstract. A 1-D air-snowpack model of HONO has been developed and constrained by observed chemistry and meteorology data. The 1-D model includes molecular diffusion and mechanical dispersion, windpumping in snow, gas phase to quasi-liquid layer phase HONO transfer and quasi-liquid layer nitrate and interstitial air HONO photolysis. Photolysis of nitrate is important as a dominant HONO source inside the snowpack, however, the observed HONO emission from the snowpack was triggered mainly by the equilibrium between quasi liquid layer nitrite and firn air HONO deep down the snow surface (i.e. 30 cm below snow surface). The high concentration of HONO in the firn air is subsequently transported above the snowpack by diffusion and windpumping. The model uncertainties come mainly from lack of measurements and the interpretation of the QLL properties based on the bulk snow measurements. One critical factor is the ionic strength of QLL nitrite, which is estimated here by the bulk snow pH, nitrite concentration, and QLL to bulk snow volume ratio.


2008 ◽  
Vol 8 (16) ◽  
pp. 4855-4864 ◽  
Author(s):  
C. S. Boxe ◽  
A. Saiz-Lopez

Abstract. We utilize a multiphase model, CON-AIR (Condensed Phase to Air Transfer Model), to show that the photochemistry of nitrate (NO3−) in and on ice and snow surfaces, specifically the quasi-liquid layer (QLL), can account for NOx volume fluxes, concentrations, and [NO]/[NO2] (γ=[NO]/[NO2]) measured just above the Arctic and coastal Antarctic snowpack. Maximum gas phase NOx volume fluxes, concentrations and γ simulated for spring and summer range from 5.0×104 to 6.4×105 molecules cm−3 s−1, 5.7×108 to 4.8×109 molecules cm−3, and ~0.8 to 2.2, respectively, which are comparable to gas phase NOx volume fluxes, concentrations and γ measured in the field. The model incorporates the appropriate actinic solar spectrum, thereby properly weighting the different rates of photolysis of NO3− and NO2−. This is important since the immediate precursor for NO, for example, NO2−, absorbs at wavelengths longer than nitrate itself. Finally, one-dimensional model simulations indicate that both gas phase boundary layer NO and NO2 exhibit a negative concentration gradient as a function of height although [NO]/[NO2] are approximately constant. This gradient is primarily attributed to gas phase reactions of NOx with halogens oxides (i.e. as BrO and IO), HOx, and hydrocarbons, such as CH3O2.


2008 ◽  
Vol 8 (3) ◽  
pp. 9731-9759
Author(s):  
◽  
D. Tan

Abstract. A 1-D air-snowpack model of HONO has been developed and constrained by observed chemistry and meteorology data. The 1-D model includes molecular diffusion and mechanical dispersion, windpumping in snow, gas phase to quasi-liquid layer phase HONO transfer and quasi-liquid layer nitrate and interstitial air HONO photolysis. Photolysis of nitrate is important as a dominant HONO source inside the snowpack, however, the observed HONO emission from the snowpack was triggered mainly by the equilibrium between quasi liquid layer nitrite and firn air HONO deep down the snow surface (i.e. 30 cm below snow surface). The high concentration of HONO in the firn air is subsequently transported above the snowpack by diffusion and windpumping. The model uncertainties come mainly from lack of measurements and the interpretation of the QLL properties based on the bulk snow measurements. One critical factor is the ionic strength of QLL nitrite, which is estimated here by the bulk snow pH, nitrite concentration, and QLL to bulk snow volume ratio.


Nanomaterials ◽  
2020 ◽  
Vol 10 (9) ◽  
pp. 1881
Author(s):  
Jiunn-Woei Liaw ◽  
Guanting Liu ◽  
Yun-Cheng Ku ◽  
Mao-Kuen Kuo

Plasmon-enhanced photothermal and optomechanical effects on deforming and reshaping a gold nanoparticle (NP) are studied theoretically. A previous paper (Wang and Ding, ACS Nano 13, 32–37, 2019) has shown that a spherical gold nanoparticle (NP) irradiated by a tightly focused laser beam can be deformed into an elongated nanorod (NR) and even chopped in half (a dimer). The mechanism is supposed to be caused by photothermal heating for softening NP associated with optical traction for follow-up deformation. In this paper, our study focuses on deformation induced by Maxwell’s stress provided by a linearly polarized Gaussian beam upon the surface of a thermal-softened NP/NR. We use an elastic model to numerically calculate deformation according to optical traction and a viscoelastic model to theoretically estimate the following creep (elongation) as temperature nears the melting point. Our results indicate that a stretching traction at the two ends of the NP/NR causes elongation and a pinching traction at the middle causes a dent. Hence, a bigger NP can be elongated and then cut into two pieces (a dimer) at the dent due to the optomechanical effect. As the continuous heating process induces premelting of NPs, a quasi-liquid layer is formed first and then an outer liquid layer is induced due to reduction of surface energy, which was predicted by previous works of molecular dynamics simulation. Subsequently, we use the Young–Laplace model to investigate the surface tension effect on the following deformation. This study may provide an insight into utilizing the photothermal effect associated with optomechanical manipulation to tailor gold nanostructures.


1998 ◽  
Vol 507 ◽  
Author(s):  
H.-L. Hsiao ◽  
A.-B. Yang ◽  
H.-L. Hwang

ABSTRACTThe polycrystalline silicon films with grain size of 1 μ m have been successful deposited on glass substrates using ECR-CVD with hydrogen dilution method at 250°C and without any thermal annealing. The deposited poly-Si films exhibit severe “hill and valley” surface roughness and facets structures. The X-ray diffraction spectra show that the dominant crystal textures are <220> and <111> orientations. The leaf-like two-fold symmetrical grain shape and the corresponding crystallography diffraction pattern indicate the orientation of largest grain is <110>. The dark field TEM image also shows the upside octahedral facets shape. Considering the effect of orientation on deposition rate and symmetry, the possible facets orientation should be <311>. Moreover, the grain sizes of poly-Si thin films deposited on bare Si wafer and on oxidized Si substrates or glass are almost the same. The facetting and textural structures can be attributed to the surface free energy change induced by the adatom quasi-liquid layer which is composed by the radicals and energetic atomic hydrogen. This adatom quasi-liquid layer would dramatically change the surface diffusion processes of adsorbed precursors and surface free energy of low index planes. Therefore, the SiHn radicals and SinHm molecular precursors with enhanced surface mobility would relax to their stable sites and form the crystalline silicon clusters.


1994 ◽  
Vol 314 (3) ◽  
pp. 341-352 ◽  
Author(s):  
A. Pavlovska ◽  
D. Dobrev ◽  
E. Bauer

2020 ◽  
Vol 11 (1) ◽  
pp. 51
Author(s):  
Alexey V. Melkikh

It has been shown that the contact melting rate for metals is determined by the fact that at least one of them has a quasi-liquid layer on the surface. As a result, the diffusion of metal atoms occurs in the liquid phase, and not in the solid phase, which determines the characteristic contact melting time (seconds and minutes).


2014 ◽  
Vol 83 (8) ◽  
pp. 083601 ◽  
Author(s):  
Yasuhiro Kajima ◽  
Shuji Ogata ◽  
Ryo Kobayashi ◽  
Miyabi Hiyama ◽  
Tomoyuki Tamura

Sign in / Sign up

Export Citation Format

Share Document