Comparative figures show METHYL ETHYL PYRIDINE saves you money

1955 ◽  
Vol 33 (50) ◽  
pp. 5342
Keyword(s):  
Methyl Ethyl

The Use of Styrenes as Embedding Media for Electron Microscopy

1971 ◽  
Vol 29 ◽  
pp. 488-489
Author(s):  
Edward D. De-Lamater ◽  
Eric Johnson ◽  
Thad Schoen ◽  
Cecil Whitaker
Keyword(s):  
Electron Microscopy ◽  
Surface Tension ◽  
Ultraviolet Light ◽  
Methyl Ethyl Ketone Peroxide ◽  
Methyl Ethyl ◽  
Styrene Polymerization ◽  
Radical Initiation ◽  
Tertiary Butyl ◽  
Low Viscosity ◽  
Free Radical Initiation

Monomeric styrenes are demonstrated as excellent embedding media for electron microscopy. Monomeric styrene has extremely low viscosity and low surface tension (less than 1) affording extremely rapid penetration into the specimen. Spurr's Medium based on ERL-4206 (J.Ultra. Research 26, 31-43, 1969) is viscous, requiring gradual infiltration with increasing concentrations. Styrenes are soluble in alcohol and acetone thus fitting well into the usual dehydration procedures. Infiltration with styrene may be done directly following complete dehydration without dilution.Monomeric styrenes are usually inhibited from polymerization by a catechol, in this case, tertiary butyl catechol. Styrene polymerization is activated by Methyl Ethyl Ketone peroxide, a liquid, and probably acts by overcoming the inhibition of the catechol, acting as a source of free radical initiation.Polymerization is carried out either by a temperature of 60°C. or under ultraviolet light with wave lengths of 3400-4000 Engstroms; polymerization stops on removal from the ultraviolet light or heat and is therefore controlled by the length of exposure.

Oxydation de la méthyl éthyl cétone comparaison avec l'acétone et la diéthylcétone

1988 ◽  
Vol 85 ◽  
pp. 209-222 ◽  
Author(s):  
E. Le Roux ◽  
F. Baronnet ◽  
G. Schacchi
Keyword(s):  
Methyl Ethyl

Highly efficient synthesis of methyl ethyl ketone oxime through ammoximation over Ti-MOR catalyst

2014 ◽  
Vol 34 (1) ◽  
pp. 243-250
Author(s):  
Jianghong DING ◽  
Le XU ◽  
Hao XU ◽  
Haihong WU ◽  
Yueming LIU ◽  
...  
Keyword(s):  
Methyl Ethyl Ketone ◽  
Methyl Ethyl ◽  
Efficient Synthesis ◽  
Highly Efficient

The Possible Utilization of Waste Sludge as an Adsorbent for Removal of Organic Vapor

1986 ◽  
Vol 18 (7-8) ◽  
pp. 413-420 ◽  
Author(s):  
P. C. Chiang ◽  
J. H. You
Keyword(s):  
Sewage Treatment ◽  
Sewage Treatment Plant ◽  
Treatment Plant ◽  
Municipal Sewage ◽  
Methyl Ethyl ◽  
Organic Vapor ◽  
Waste Sludge ◽  
Catalyst Temperature ◽  
Major Factors ◽  
Municipal Sewage Treatment Plant

In this investigation it was found that the waste sludge obtained from a municipal sewage treatment plant could be reclaimed as an adsorbent for removal of organic vapours, i.e. toluene, methyl-ethyl-ketone and 1-1-2-trichloroethylene, through use of a pyrolysis technique. In order to find the optimum manufacturing process, several tests were performed under various conditions in which the addition of a catalyst, temperature control, and residence time in the furnace, were considered as the three major factors. Both the reclaimed adsorbent and commercially available activated carbon were evaluated to determine their adsorption capacity at various influent concentrations of organic vapours.

Enrichment and characterization of an anaerobic methyl ethyl ketoxime degrading culture from an anoxic/anaerobic/aerobic activated sludge sequencing batch reactor

1998 ◽  
Vol 37 (4-5) ◽  
pp. 95-98 ◽  
Author(s):  
Nancy G. Love ◽  
Mary E. Rust ◽  
Kathy C. Terlesky
Keyword(s):  
Energy Source ◽  
Activated Sludge ◽  
Electron Acceptor ◽  
Sequencing Batch Reactor ◽  
Enrichment Culture ◽  
Batch Reactor ◽  
Nitrification Inhibitor ◽  
Time Frame ◽  
Methyl Ethyl

An anaerobic enrichment culture was developed from an anoxic/anaerobic/aerobic activated sludge sequencing batch reactor using methyl ethyl ketoxime (MEKO), a potent nitrification inhibitor, as the sole carbon and energy source in the absence of molecular oxygen and nitrate. The enrichment culture was gradually fed decreasing amounts of biogenic organic compounds and increasing concentrations of MEKO over 23 days until the cultures metabolized the oxime as the sole carbon source; the cultures were maintained for an additional 41 days on MEKO alone. Turbidity stabilized at approximately 100 mg/l total suspended solids. Growth on selective media plates confirmed that the microorganisms were utilizing the MEKO as the sole carbon and energy source. The time frame required for growth indicated that the kinetics for MEKO degradation are slow. A batch test indicated that dissolved organic carbon decreased at a rate comparable to MEKO consumption, while sulfate was not consumed. The nature of the electron acceptor in anaerobic MEKO metabolism is unclear, but it is hypothesized that the MEKO is hydrolyzed intracellularly to form methyl ethyl ketone and hydroxylamine which serve as electron donor and electron acceptor, respectively.

SiO2-POCl2 nano-particles promoted the synthesis of novel structure of alkyl 2-oxo-3,4-diaryloxazolidine-5-carboxylate derivatives

2020 ◽  
Vol 17 ◽  
Author(s):  
Mehdi Abaszadeh ◽  
Seyyed Jalal Roudbaraki ◽  
Hossein Yarahmadi ◽  
Majid Ghashang
Keyword(s):  
Nano Particles ◽  
Methyl Ethyl ◽  
Aniline Derivatives ◽  
Ethyl Methyl ◽  
Novel Structure ◽  
Three Component Reaction ◽  
High Yields

: Silica-POCl2 was used as the promoter for the three-component reaction of ethyl/methyl 3-phenyl glycidate, aniline derivatives, and dimethylcarbonate, leads to the synthesis of methyl/ethyl 2-oxo-4-phenyl-3-aryloxazolidine-5-carboxylate derivatives. The desired product was obtained in high yields.

Activity Coefficients and Gibbs Energies of Transfer of Tetraalkylammonium Dianilinetetraisothiocyanatochromates(III)

1994 ◽  
Vol 59 (8) ◽  
pp. 1738-1744
Author(s):  
Vladislav Holba
Keyword(s):  
Activity Coefficients ◽  
Transfer Functions ◽  
Butyl Alcohol ◽  
Methyl Ethyl ◽  
Tetraalkylammonium Ions ◽  
Ionic Transfer ◽  
Gibbs Energies ◽  
Gibbs Energies Of Transfer ◽  
Acetonitrile Solutions ◽  
Mixed Systems

The solubilities of tetraalkylammonium dianilinetetraisothiocyanatochromates(III) (alkyl = methyl, ethyl, 1-propyl, and 1-butyl) in water, water - methanol, water - tert-butyl alcohol and water - acetonitrile solutions were measured at 25 °C. The results were used to evaluate the activity coefficients and Gibbs energies of transfer of the saturating salts from water to the mixed systems. The Gibbs energies of transfer of the [Cr(C6H5NH2)2(NCS)4]- ion were obtained by means of known ionic transfer functions for the tetraalkylammonium ions based on the TATB assumption.

Di- and tripeptide N-alkyl- and N-aralkyl amides as chymotrypsin inhibitors

1988 ◽  
Vol 53 (11) ◽  
pp. 2877-2883 ◽  
Author(s):  
Evžen Kasafírek ◽  
Irena Šutiaková ◽  
Michal Bartík ◽  
Antonín Šturc
Keyword(s):  
Methyl Ethyl ◽  
Competitive Inhibitors ◽  
Inhibition Constants ◽  
Chymotrypsin Inhibitors

Two competitive inhibitors of chymotrypsin, Glt-Ala-Ala-Leu-EtPh and Glt-Ala-Ala-Pro-NH-EtPh, were synthesized and their inhibition constants Ki were determined. The Ki-determination was carried also with a set of peptides of type X-(Ala)nNH-Y, where X is 3-carboxypropionyl- or 4-carboxybutyryl-, n is 2 or 3 and Y is methyl, ethyl, diethyl, isopropyl, propyl, butyl, isobutyl and 2-phenylethyl. Chymotrypsin inhibition was observed only with peptides containing an aralkyl residue whereas peptides with an alkyl are without any effect. Glt-Ala-Ala-Leu-NH-EtPh shows the highest Ki-value (80 μmol l-1).

Electroinduced oxidative copolymerization ofN-vinyl carbazole with methyl ethyl ketone formaldehyde resin

2004 ◽  
Vol 15 (7) ◽  
pp. 365-369 ◽  
Author(s):  
Belkıs Ustamehmetoğlu ◽  
A. Sezai Saraç ◽  
Nilgün Kızılcan ◽  
Ahmet Akar
Keyword(s):  
Methyl Ethyl Ketone ◽  
Formaldehyde Resin ◽  
Methyl Ethyl ◽  
Oxidative Copolymerization
Sign in / Sign up

Export Citation Format

Share Document