Determination of the Entropy of Ion Transfer between Two Immiscible Liquids Using the Water|Oil|Water Thermocouple

2003 ◽  
Vol 107 (36) ◽  
pp. 9829-9836 ◽  
Author(s):  
Toshiyuki Osakai ◽  
Hajime Ogawa ◽  
Toru Ozeki ◽  
Hubert H. Girault
1991 ◽  
Vol 56 (1) ◽  
pp. 112-129 ◽  
Author(s):  
Takashi Kakiuchi ◽  
Mitsugi Senda

We have estimated the degree of polarizability of a polarized oil-water interface used as a working interface and that of the nonpolarizability of a nonpolarized interface used as a reference oil-water interface from the numerical calculation of dc and ac current vs potential behavior at both interfaces. Theoretical equations of dc and ac currents for simultaneous cation and anion transfer of supporting electrolytes have been derived for the planar stationary interface for reversible and quasi-reversible cases. In the derivation, the migration effect and the coupling of the cation and anion transfer have been incorporated. The transfer of ions constituting a supporting electrolyte contributes to the total admittance of the interface even in the region where the interface may be considered as polarized in dc sense, as pointed out first by Samec et al. (J. Electroanal. Chem. 126, 121 (1981)). Moreover, the reference oil-water interface is not ideally reversible, so that the contribution from this interface to the measured admittance cannot be negligible, unless the area of the reference oil-water interface is much larger than that of the working oil-water interface. The effect of non-ideality of the reference oil-water interface on the determination of double layer capacitances and kinetic parameters of charge transfer at the working oil-water interface has been estimated.


1998 ◽  
Vol 451 (1-2) ◽  
pp. 59-76 ◽  
Author(s):  
Frédéric Reymond ◽  
Gregoire Lagger ◽  
Pierre-Alain Carrupt ◽  
Hubert H. Girault

1975 ◽  
Vol 145 (3) ◽  
pp. 417-429 ◽  
Author(s):  
J E Barnett ◽  
G D Holman ◽  
R A Chalkley ◽  
K A Munday

6-O-methyl-, 6-O-propyl-, 6-O-pentyl- and 6-O-benzyl-D-galactose, and 6-O-methyl-, 6-O-propyl- and 6-O-pentyl-D-glucose inhibit the glucose-transport system of the human erythrocyte when added to the external medium. Penetration of 6-O-methyl-D-galactose is inhibited by D-glucose, suggesting that it is transported by the glucose-transport system, but the longer-chain 6-O-alkyl-D-galactoses penetrate by a slower D-glucose-insensitive route at rates proportional to their olive oil/water partition coefficients. 6-O-n-Propyl-D-glucose and 6-O-n-propyl-D-galactose do not significantly inhibit L-sorbose entry or D-glucose exit when present only on the inside of the cells whereas propyl-beta-D-glucopyranoside, which also penetrates the membrane slowly by a glucose-insensitive route, only inhibits L-sorbose entry or D-glucose exit when present inside the cells, and not when on the outside. The 6-O-alkyl-D-galactoses, like the other nontransported C-4 and C-6 derivatives, maltose and 4,6-O-ethylidene-D-glucose, protect against fluorodinitrobenzene inactivation, whereas propyl beta-D-glucopyranoside stimulates the inactivation. Of the transported sugars tested, those modified at C-1, C-2 and C-3 enhance fluorodinitrobenzene inactivation, where those modified at C-4 and C-6 do not, but are inert or protect against inactivation. An asymmetric mechanism is proposed with two conformational states in which the sugar binds to the transport system so that C-4 and C-6 are in contact with the solvent on the outside and C-1 is in contact with the solvent on the inside of the cell. It is suggested that fluorodinitrobenzene reacts with the form of the transport system that binds sugars at the inner side of the membrane. An Appendix describes the theoretical basis of the experimental methods used for the determination of kinetic constants for non-permeating inhibitors.


2018 ◽  
pp. 28-37
Author(s):  
Piotr Pacholski ◽  
Jerzy Sęk

The wastewater produced by the metal industry is often present in the form of oil-in-water (O/W) or water-in- oil (W/O) emulsions. These fluids contain a certain amount of valuable oil that can be recovered in the recycling process. Therefore, the development of novel, efficient, and low cost processes for the treatment of metalworking fluid is necessary. Demulsification to separate oil/water mixtures is a very interesting option because it allows the recovery and reuse of the lubricant oil and effects in cleaner, easily treatablemwastewater.Chemical destabilization is the most common way of demulsification of metalworking fluids. As an example, inorganic salts can be used as demulsifiers. In the presented work the efficiency of treatment of cutting emulsions with chemical demulsification with usage of aluminum sulfate (IV) is described. The emulsion was prepared with Emulgol-ES12 self-emulsyfing oil delivered by Orlen S.A. In the research the feasibility of the demulsifier was checked.The novel in this paper is determination of the optimal dosage of emulsifier using the TurbiscanLab® apparatus. It is relatively quick and precise method that can be applied in the industry.


Author(s):  
Heba S. Elsewedy ◽  
Bandar E. Al-Dhubiab ◽  
Mahmoud A. Mahdy ◽  
Hanan M. Elnahas

One of the widely efficient and noteworthy nanocarriers that could draw a great attention toward pharmaceutical fields is nanoemulsions (NEs). NEs are thermodynamically stable colloidal dispersions composed of two immiscible liquids, oil and water that mixed together using emulsifying agent (surfactant and co-surfactant). It regarded as pharmaceutical dosage form having droplet size within a nanometer range, hence it has extensively considered as carrier for delivering active agents. Such carrier is fabricated in order to overcome some obstacles associated with conventional drug delivery systems especially low bioavailability. The objective of this review is to present an overview about NE and its latest applications in diverse areas such as drug delivery, cosmeceutical and nutraceutical. Clarifications about different mechanisms of NEs development that are frequently used were provided. Correspondingly, popular characterization techniques for NEs such as determination of particle size, polydispersity index (PDI), zeta potential and viscosity were reviewed. Eventually, summary of physical and chemical instability in addition to the regulatory aspects of NE were provided.


Sign in / Sign up

Export Citation Format

Share Document