scholarly journals A Low Cost and Portable Microwave Imaging System for Breast Tumor Detection Using UWB Directional Antenna array

2019 ◽  
Vol 9 (1) ◽  
Author(s):  
M. T. Islam ◽  
M. Z. Mahmud ◽  
M. Tarikul Islam ◽  
S. Kibria ◽  
M. Samsuzzaman

Abstract Globally, breast cancer is a major reason for female mortality. Due to the limitations of current clinical imaging, the researchers are encouraged to explore alternative and complementary tools to available techniques to detect the breast tumor in an earlier stage. This article outlines a new, portable, and low-cost microwave imaging (MWI) system using an iterative enhancing technique for breast imaging. A compact side slotted tapered slot antenna is designed for microwave imaging. The radiating fins of tapered slot antenna are modified by etching nine rectangular side slots. The irregular slots on the radiating fins enhance the electrical length as well as produce strong directive radiation due to the suppression of induced surface currents that radiate vertically at the outer edges of the radiating arms with end-fire direction. It has remarkable effects on efficiency and gain. With the addition of slots, the side-lobe levels are reduced, the gain of the main-lobe is increased and corrects the squint effects simultaneously, thus improving the characteristics of the radiation. For experimental validation, a heterogeneous breast phantom was developed that contains dielectric properties identical to real breast tissues with the inclusion of tumors. An alternative PC controlled and microcontroller-based mechanical MWI system is designed and developed to collect the antenna scattering signal. The radiated backscattered signals from the targeted area of the human body are analyzed to reveal the changes in dielectric properties in tissues. The dielectric constants of tumorous cells are higher than that of normal tissues due to their higher water content. The remarkable deviation of the scattered field is processed by using newly proposed Iteratively Corrected Delay and Sum (IC-DAS) algorithm and the reconstruction of the image of the phantom interior is done. The developed UWB (Ultra-Wideband) antenna based MWI has been able to perform the detection of tumorous cells in breast phantom that can pave the way to saving lives.

2006 ◽  
Vol 48 (11) ◽  
pp. 2212-2216 ◽  
Author(s):  
A. M. Abbosh ◽  
H. K. Kan ◽  
M. E. Bialkowski

Sensors ◽  
2018 ◽  
Vol 18 (9) ◽  
pp. 2951 ◽  
Author(s):  
Md. Mahmud ◽  
Mohammad Islam ◽  
Norbahiah Misran ◽  
Ali Almutairi ◽  
Mengu Cho

Globally, breast cancer is reported as a primary cause of death in women. More than 1.8 million new breast cancer cases are diagnosed every year. Because of the current limitations on clinical imaging, researchers are motivated to investigate complementary tools and alternatives to available techniques for detecting breast cancer in earlier stages. This article presents a review of concepts and electromagnetic techniques for microwave breast imaging. More specifically, this work reviews ultra-wideband (UWB) antenna sensors and their current applications in medical imaging, leading to breast imaging. We review the use of UWB sensor based microwave energy in various imaging applications for breast tumor related diseases, tumor detection, and breast tumor detection. In microwave imaging, the back-scattered signals radiating by sensors from a human body are analyzed for changes in the electrical properties of tissues. Tumorous cells exhibit higher dielectric constants because of their high water content. The goal of this article is to provide microwave researchers with in-depth information on electromagnetic techniques for microwave imaging sensors and describe recent developments in these techniques.


Sensors ◽  
2018 ◽  
Vol 18 (9) ◽  
pp. 2962 ◽  
Author(s):  
Mohammad Tariqul Islam ◽  
Md. Samsuzzaman ◽  
Md. Tarikul Islam ◽  
Salehin Kibria ◽  
Mandeep Jit Singh

Microwave breast imaging has been reported as having the most potential to become an alternative or additional tool to the existing X-ray mammography technique for detecting breast tumors. Microwave antenna sensor performance plays a significant role in microwave imaging system applications because the image quality is mostly affected by the microwave antenna sensor array properties like the number of antenna sensors in the array and the size of the antenna sensors. In this paper, a new system for successful early detection of a breast tumor using a balanced slotted antipodal Vivaldi Antenna (BSAVA) sensor is presented. The designed antenna sensor has an overall dimension of 0.401λ × 0.401λ × 0.016λ at the first resonant frequency and operates between 3.01 to 11 GHz under 10 dB. The radiating fins are modified by etching three slots on both fins which increases the operating bandwidth, directionality of radiation pattern, gain and efficiency. The antenna sensor performance of both the frequency domain and time domain scenarios and high-fidelity factor with NFD is also investigated. The antenna sensor can send and receive short electromagnetic pulses in the near field with low loss, little distortion and highly directionality. A realistic homogenous breast phantom is fabricated, and a breast phantom measurement system is developed where a two antennas sensor is placed on the breast model rotated by a mechanical scanner. The tumor response was investigated by analyzing the backscattering signals and successful image construction proves that the proposed microwave antenna sensor can be a suitable candidate for a high-resolution microwave breast imaging system.


Sensors ◽  
2018 ◽  
Vol 18 (12) ◽  
pp. 4427 ◽  
Author(s):  
Mohammad Islam ◽  
Md Samsuzzaman ◽  
Md Islam ◽  
Salehin Kibria

An experimental system for early screening of a breast tumor is presented in this article. The proposed microwave imaging (MI) system consists of a moveable array of nine improved negative-index metamaterial (MTM)-loaded ultrawideband (UWB) antenna sensor with incorporation of a corresponding SRR (split-ring resonator) and CLS (capacitively loaded strip) structure, in a circular array, the stepper motor-based array-mounting stand, the adjustable phantom hanging platform, an RF switching system to control the receivers, and a personal computer-based signal processing and image reconstruction unit using MATLAB. The improved antenna comprises of four-unit cells along one axis, where an individual unit cell integrates a balancing SRR and CLS pair, which makes the antenna radiation omnidirectional over the operating frequencies. The electrical dimensions of this proposed antenna are 0.28λ × 0.20λ × 0.016λ, measured at the lowest operating frequency of 2.97 GHz as the operating bandwidth of this is in between 2.97–15 GHz (134.82% bandwidth), with stable directional radiation pattern. SP8T 8 port switch is used to enable the eight receiver antennas to sequentially send a 3–8.0 GHz microwave signal to capture the backscattered signal by MATLAB software. A low-cost realistic homogeneous breast phantom with tumor material is developed and measured to test the capability of the imaging system to detect the breast tumors. A post-processing delay-multiply-and-sum (DMAS) algorithm is used to process the recorded backscatter signal to get an image of the breast phantom, and to accurately identify the existence and located area of multiple breast tumor tissues.


2021 ◽  
Vol 11 (8) ◽  
pp. 3606
Author(s):  
Seonho Lim ◽  
Young Joong Yoon

In this paper, a wideband-narrowband switchable tapered slot antenna (TSA) with a compact meander line resonator for an integrated microwave imaging and hyperthermia system was proposed. A compact meander line resonator, which exhibited band-pass characteristics and provided narrowband characteristics by using one PIN diode, was fabricated beneath the tapered slot of the wideband TSA to minimize the degradation of the wideband characteristics. Moreover, the electromagnetic energy was transferred to the meander line resonator with a coupling effect to ensure effective frequency switching. By adapting a PIN diode on the meander line resonator, frequency switching could be achieved. In this way, the proposed antenna could operate in a real-time frequency switching mode between the ultra-wideband (UWB; 3.1~10 GHz), which is used for microwave imaging, and the 2.45 GHz band (industrial, scientific, and medical, ISM band), which is used for microwave hyperthermia. Frequency and time-domain results proved the applicability of the proposed antenna to an integrated breast cancer detection and treatment system.


Micromachines ◽  
2021 ◽  
Vol 12 (6) ◽  
pp. 647
Author(s):  
Sameer Alani ◽  
Zahriladha Zakaria ◽  
Tale Saeidi ◽  
Asmala Ahmad ◽  
Muhammad Ali Imran ◽  
...  

Skin cancer is one of the most widespread and fast growing of all kinds of cancer since it affects the human body easily due to exposure to the Sun’s rays. Microwave imaging has shown better outcomes with higher resolution, faster processing time, mobility, and less cutter and artifact effects. A miniaturized elliptical ultra-wideband (UWB) antenna and its semi-spherical array arrangement were used for signal transmission and reception from the defected locations in the breast skin. Several conditions such as various arrays of three, six, and nine antenna elements, smaller tumor, multi-tumors, and skin on a larger breast sample of 30 cm were considered. To assess the ability of the system, a breast shape container with a diameter of 130 mm and height of 60 mm was 3D printed and then filled with fabricated skin and breast fat to perform the experimental investigation. An improved modified time-reversal algorithm (IMTR) was used to recreate 2D images of tumors with the smallest radius of 1.75 mm in any location within the breast skin. The reconstructed images using both simulated and experimental data verified that the system can be a reliable imaging system for skin cancer diagnosis having a high structural similarity index and resolution.


Electronics ◽  
2021 ◽  
Vol 10 (15) ◽  
pp. 1762
Author(s):  
Yuki Gao ◽  
Maryam Ravan ◽  
Reza K. Amineh

The use of non-metallic pipes and composite components that are low-cost, durable, light-weight, and resilient to corrosion is growing rapidly in various industrial sectors such as oil and gas industries in the form of non-metallic composite pipes. While these components are still prone to damages, traditional non-destructive testing (NDT) techniques such as eddy current technique and magnetic flux leakage technique cannot be utilized for inspection of these components. Microwave imaging can fill this gap as a favorable technique to perform inspection of non-metallic pipes. Holographic microwave imaging techniques are fast and robust and have been successfully employed in applications such as airport security screening and underground imaging. Here, we extend the use of holographic microwave imaging to inspection of multiple concentric pipes. To increase the speed of data acquisition, we utilize antenna arrays along the azimuthal direction in a cylindrical setup. A parametric study and demonstration of the performance of the proposed imaging system will be provided.


2020 ◽  
Vol 10 (5) ◽  
pp. 1830
Author(s):  
Yi-Wei Chang ◽  
Yun-Ru Chen ◽  
Chien-Chuan Ko ◽  
Wei-Yang Lin ◽  
Keng-Pei Lin

The breast ultrasound is not only one of major devices for breast tissue imaging, but also one of important methods in breast tumor screening. It is non-radiative, non-invasive, harmless, simple, and low cost screening. The American College of Radiology (ACR) proposed the Breast Imaging Reporting and Data System (BI-RADS) to evaluate far more breast lesion severities compared to traditional diagnoses according to five-criterion categories of masses composition described as follows: shape, orientation, margin, echo pattern, and posterior features. However, there exist some problems, such as intensity differences and different resolutions in image acquisition among different types of ultrasound imaging modalities so that clinicians cannot always identify accurately the BI-RADS categories or disease severities. To this end, this article adopted three different brands of ultrasound scanners to fetch breast images for our experimental samples. The breast lesion was detected on the original image using preprocessing, image segmentation, etc. The breast tumor’s severity was evaluated on the features of the breast lesion via our proposed classifiers according to the BI-RADS standard rather than traditional assessment on the severity; i.e., merely using benign or malignant. In this work, we mainly focused on the BI-RADS categories 2–5 after the stage of segmentation as a result of the clinical practice. Moreover, several features related to lesion severities based on the selected BI-RADS categories were introduced into three machine learning classifiers, including a Support Vector Machine (SVM), Random Forest (RF), and Convolution Neural Network (CNN) combined with feature selection to develop a multi-class assessment of breast tumor severity based on BI-RADS. Experimental results show that the proposed CAD system based on BI-RADS can obtain the identification accuracies with SVM, RF, and CNN reaching 80.00%, 77.78%, and 85.42%, respectively. We also validated the performance and adaptability of the classification using different ultrasound scanners. Results also indicate that the evaluations of F-score based on CNN can obtain measures higher than 75% (i.e., prominent adaptability) when samples were tested on various BI-RADS categories.


Sign in / Sign up

Export Citation Format

Share Document