scholarly journals Force–velocity profile during vertical jump cannot be assessed using only bodyweight jump and isometric maximal voluntary contraction tasks

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Nejc Šarabon ◽  
Žiga Kozinc ◽  
Goran Marković
Keyword(s):  
Maximal Voluntary Contraction ◽  
Vertical Jump ◽  
Voluntary Contraction ◽  
Point Method ◽  
Multiple Point ◽  
Systematic Bias ◽  
The Novel ◽  
Isometric Maximal Voluntary Contraction ◽  
Human Movements ◽  
Force Velocity

Abstract Recently, the two-point method of force–velocity (F–V) profiling of multi-joint human movements has been introduced and validated. In this study, we investigated the validity of estimating the jumping F–V profile using only bodyweight jump and isometric maximal voluntary contraction (MVC) task. Participants (n = 30) performed 3 repetitions of squat (SJ) and counter-movement jumps (CMJ), each at loads that were progressively increased by 10 kg increments, with the number of loads depending on the individual’s ability. Then, 3 isometric MVC trials were performed in 3 knee angles (30°, 60° and 90°). F–V profiling of SJ and CMJ were performed using the multiple-point method, the two-point method, and the novel Jump-MVC method. The results showed poor to fair validity of the novel Jump-MVC method for assessing jumping F–V profile (most ICC < 0.5, most CV > 10%, significant systematic bias present, and the presence of proportional bias). The exception was the estimation of theoretical maximal power, which was highly valid for both SJ and CMJ (ICC = 0.91–0.95; CV = 5.0–6.3%). In contrast, validity of the two-point method was excellent (all ICC > 0.90; CV = 2–6%). Although additional studies are needed, present results suggest that the F–V profiling of vertical jumps should be performed using the two-point method with distal loads.

scholarly journals Potentiation Increases Peak Twitch Torque by Enhancing Rates of Torque Development and Relaxation

2013 ◽  
Vol 38 ◽  
pp. 83-94 ◽  
Author(s):  
Christian Froyd ◽  
Fernando Gabe Beltrami ◽  
Jørgen Jensen ◽  
Timothy David Noakes
Keyword(s):  
Electrical Stimulation ◽  
Maximal Voluntary Contraction ◽  
Femoral Nerve ◽  
Voluntary Contraction ◽  
Physically Active ◽  
Isometric Maximal Voluntary Contraction ◽  
Rate Of Torque Development ◽  
Voluntary Contractions ◽  
Torque Development ◽  
Similar Peak

Abstract The aim of this study was to measure the extent to which potentiation changes in response to an isometric maximal voluntary contraction. Eleven physically active subjects participated in two separate studies. Single stimulus of electrical stimulation of the femoral nerve was used to measure torque at rest in unpotentiated quadriceps muscles (study 1 and 2), and potentiated quadriceps muscles torque in a 10 min period after a 5 s isometric maximal voluntary contraction of the quadriceps muscles (study 1). Additionally, potentiated quadriceps muscles torque was measured every min after a further 10 maximal voluntary contractions repeated every min (study 2). Electrical stimulation repeated several times without previous maximal voluntary contraction showed similar peak twitch torque. Peak twitch torque 4 s after a 5 s maximal voluntary contraction increased by 45±13% (study 1) and by 56±10% (study 2), the rate of torque development by 53±13% and 82±29%, and the rate of relaxation by 50±17% and 59±22%, respectively, but potentiation was lost already two min after a 5 s maximal voluntary contraction. There was a tendency for peak twitch torque to increase for the first five repeated maximal voluntary contractions, suggesting increased potentiation with additional maximal voluntary contractions. Correlations for peak twitch torque vs the rate of torque development and for the rate of relaxation were r2= 0.94 and r2=0.97. The correlation between peak twitch torque, the rate of torque development and the rate of relaxation suggests that potentiation is due to instantaneous changes in skeletal muscle contractility and relaxation.

scholarly journals Using Drop Jumps and Jump Squats to Assess Eccentric and Concentric Force-Velocity Characteristics

Sports ◽  
2018 ◽  
Vol 6 (4) ◽  
pp. 125 ◽  
Author(s):  
Gavin Moir ◽  
Brandon Snyder ◽  
Chris Connaboy ◽  
Hugh Lamont ◽  
Shala Davis
Keyword(s):  
Point Method ◽  
Multiple Point ◽  
Regression Equations ◽  
Average Force ◽  
Concentric Force ◽  
Absorption Phase ◽  
Drop Jumps ◽  
Force Velocity ◽  
Analysis System ◽  
Propulsion Phase

The purpose of this study was to investigate the eccentric and concentric force-velocity (Fv) characteristics recorded during drop jumps (DJ) from different heights and loaded jump squats (JS) and to determine the number of jumps required to accurately model the eccentric and concentric Fv relationships. Fourteen resistance-trained men (age: 21.9 ± 1.8 years) performed a countermovement jump (CMJ) and DJ from heights of 0.40, 0.60, and 0.80 m. JS with loads equivalent to 0%, 27%, 56%, and 85% 1-repetition maximum were performed in a separate session. Force platforms and a 3-D motion analysis system were used to record the average force ( F ¯ ) and velocity ( v ¯ ) during the absorption (CMJ, DJ40, DJ60, DJ80) and propulsion (JS0, JS27, JS56, JS85) phases of the jumps. Eccentric (absorption phase) and concentric (propulsion phase) Fv characteristics were then calculated and linear regression equations were determined when the number of jumps included was varied. F ¯ during the absorption phase significantly increased from CMJ to DJ60 while v ¯ increased significantly from CMJ to DJ80. The two-point method (CMJ, DJ80) resulted in a significantly lower y-intercept (mean difference [MD]: 0.7 N/kg) and a greater slope (MD: 0.7 Ns/m) for the eccentric Fv characteristics compared to the multiple-point method. F ¯ increased significantly and v ¯ decreased significantly with increasing external load in the JS conditions. The two-point method (JS0, JS85) resulted in a significantly greater y-intercept (MD: 1.1 N/kg) compared to the multiple-point method for the concentric Fv characteristics. Both DJ and loaded JS may provide means of assessing the eccentric and concentric Fv characteristics with only two jumps being required.

scholarly journals Corticospinal excitability of the biceps brachii is shoulder position dependent

2017 ◽  
Vol 118 (6) ◽  
pp. 3242-3251 ◽  
Author(s):  
Brandon Wayne Collins ◽  
Edward W. J. Cadigan ◽  
Lucas Stefanelli ◽  
Duane C. Button
Keyword(s):  
Evoked Potentials ◽  
Maximal Voluntary Contraction ◽  
Biceps Brachii ◽  
Motor Evoked Potentials ◽  
Voluntary Contraction ◽  
Corticospinal Excitability ◽  
State Dependent ◽  
Shoulder Flexion ◽  
Erb’S Point ◽  
Shoulder Position

The purpose of this study was to examine the effect of shoulder position on corticospinal excitability (CSE) of the biceps brachii during rest and a 10% maximal voluntary contraction (MVC). Participants ( n = 9) completed two experimental sessions with four conditions: 1) rest, 0° shoulder flexion; 2) 10% MVC, 0° shoulder flexion; 3) rest, 90° shoulder flexion; and 4) 10% MVC, 90° shoulder flexion. Transcranial magnetic, transmastoid electrical, and Erb’s point stimulation were used to induce motor-evoked potentials (MEPs), cervicomedullary MEPs (CMEPs), and maximal muscle compound potentials (Mmax), respectively, in the biceps brachii in each condition. At rest, MEP, CMEP, and Mmax amplitudes increased ( P < 0.01) by 509.7 ± 118.3%, 113.3 ± 28.3%, and 155.1 ± 47.9%, respectively, at 90° compared with 0°. At 10% MVC, MEP amplitudes did not differ ( P = 0.08), but CMEP and Mmax amplitudes increased ( P < 0.05) by 32.3 ± 10.5% and 127.9 ± 26.1%, respectively, at 90° compared with 0°. MEP/Mmax increased ( P < 0.01) by 224.0 ± 99.1% at rest and decreased ( P < 0.05) by 51.3 ± 6.7% at 10% MVC at 90° compared with 0°. CMEP/Mmax was not different ( P = 0.22) at rest but decreased ( P < 0.01) at 10% MVC by 33.6 ± 6.1% at 90° compared with 0°. EMG increased ( P < 0.001) by 8.3 ± 2.0% at rest and decreased ( P < 0.001) by 21.4 ± 4.4% at 10% MVC at 90° compared with 0°. In conclusion, CSE of the biceps brachii was dependent on shoulder position, and the pattern of change was altered within the state in which it was measured. The position-dependent changes in Mmax amplitude, EMG, and CSE itself all contribute to the overall change in CSE of the biceps brachii. NEW & NOTEWORTHY We demonstrate that when the shoulder is placed into two common positions for determining elbow flexor force and activation, corticospinal excitability (CSE) of the biceps brachii is both shoulder position and state dependent. At rest, when the shoulder is flexed from 0° to 90°, supraspinal factors predominantly alter CSE, whereas during a slight contraction, spinal factors predominantly alter CSE. Finally, the normalization techniques frequently used by researchers to investigate CSE may under- and overestimate CSE when shoulder position is changed.

Nonuniform strain of human soleus aponeurosis-tendon complex during submaximal voluntary contractions in vivo

2003 ◽  
Vol 95 (2) ◽  
pp. 829-837 ◽  
Author(s):  
Taija Finni ◽  
John A. Hodgson ◽  
Alex M. Lai ◽  
V. Reggie Edgerton ◽  
Shantanu Sinha
Keyword(s):  
Achilles Tendon ◽  
Maximal Voluntary Contraction ◽  
Three Dimensional ◽  
Motor Units ◽  
Magnetic Resonance Images ◽  
Voluntary Contraction ◽  
Force Transmission ◽  
Voluntary Contractions ◽  
Nonuniform Strain

The distribution of strain along the soleus aponeurosis tendon was examined during voluntary contractions in vivo. Eight subjects performed cyclic isometric contractions (20 and 40% of maximal voluntary contraction). Displacement and strain in the apparent Achilles tendon and in the aponeurosis were calculated from cine phase-contrast magnetic resonance images acquired with a field of view of 32 cm. The apparent Achilles tendon lengthened 2.8 and 4.7% in 20 and 40% maximal voluntary contraction, respectively. The midregion of the aponeurosis, below the gastrocnemius insertion, lengthened 1.2 and 2.2%, but the distal aponeurosis shortened 2.1 and 2.5%, respectively. There was considerable variation in the three-dimensional anatomy of the aponeurosis and muscle-tendon junction. We suggest that the nonuniformity in aponeurosis strain within an individual was due to the presence of active and passive motor units along the length of the muscle, causing variable force along the measurement site. Force transmission along intrasoleus connective tissue may also be a significant source of nonuniform strain in the aponeurosis.

scholarly journals Exercise tolerance during muscle contractions below and above the critical torque in different muscle groups

2018 ◽  
Vol 43 (2) ◽  
pp. 174-179 ◽  
Author(s):  
Leonardo Henrique Perinotto Abdalla ◽  
Benedito Sérgio Denadai ◽  
Natália Menezes Bassan ◽  
Camila Coelho Greco
Keyword(s):  
Exercise Intensity ◽  
Maximal Voluntary Contraction ◽  
Exercise Tolerance ◽  
Voluntary Contraction ◽  
Knee Extensors ◽  
Isometric Contractions ◽  
Plantar Flexors ◽  
Significant Difference ◽  
Muscle Groups

The objective of this study was to test the hypotheses that end-test torque (ET) (expressed as % maximal voluntary contraction; MVC) is higher for plantar flexors (PF) than knee extensors (KE) muscles, whereas impulse above ET (IET) is higher for KE than PF. Thus, we expected that exercise tolerance would be longer for KE than PF only during the exercise performed above ET. After the determination of MVC, 40 men performed two 5-min all-out tests to determine ET and IET. Eleven participants performed a further 4 intermittent isometric tests, to exhaustion, at ET + 5% and ET – 5%, and 1 test for KE at the exercise intensity (%MVC) corresponding to ET + 5% of PF. The IET (7243.2 ± 1942.9 vs. 3357.4 ± 1132.3 N·m·s) and ET (84.4 ± 24.8 vs. 73.9 ± 19.5 N·m) were significantly lower in PF compared with KE. The exercise tolerance was significantly longer for PF (300.7 ± 156.7 s) than KE (156.7 ± 104.3 s) at similar %MVC (∼60%), and significantly shorter for PF (300.7 ± 156.7 s) than KE (697.0 ± 243.7 s) at ET + 5% condition. However, no significant difference was observed for ET – 5% condition (KE = 1030.2 ± 495.4 s vs. PF = 1028.3 ± 514.4 s). Thus, the limit of tolerance during submaximal isometric contractions is influenced by absolute MVC only during exercise performed above ET, which seems to be explained by differences on both ET (expressed as %MVC) and IET values.

Sign in / Sign up

Export Citation Format

Share Document