scholarly journals Structural and elemental changes in glioblastoma cells in situ: complementary imaging with high resolution visible light- and X-ray microscopy

The Analyst ◽  
2017 ◽  
Vol 142 (2) ◽  
pp. 356-365 ◽  
Author(s):  
Tanja Dučić ◽  
Tatjana Paunesku ◽  
Si Chen ◽  
Milena Ninković ◽  
Swetlana Speling ◽  
...  

The study explores application of X-ray and high resolution visible light microscopy to investigate the elemental and structural changes in cells from 3 patient derived glioblastoma samples.

Author(s):  
R. J. Rosser

Soft x-ray contact microscopy has been pursued for many years because of the potential advantages of 1 to 10 nm electro-magetic radiation for imaging biological materials. These are the lower damage and greater penetration than electrons and considerably higher resolution than visible light microscopy, both possible without exotic optics.The technique is similar to contact printing. The object to be viewed is placed as close as possible to the recording medium which is then exposed to a suitable x-ray source.. The sample is removed from the recording medium which is then chemically developed. The result is map of the x-ray opacity of the original specimen.The high resolution has only become reality in recent years with the use of x-ray photo-resists as the recording material. These were origionally developed for use in the electronics industry but have been used for contact images of biological material.


2014 ◽  
Vol 70 (a1) ◽  
pp. C94-C94
Author(s):  
Pawel Kuczera ◽  
Walter Steurer

The structure of d(ecagonal)-Al-Cu-Rh has been studied as a function of temperature by in-situ single-crystal X-ray diffraction in order to contribute to the discussion on energy or entropy stabilization of quasicrystals (QC) [1]. The experiments were performed at 293 K, 1223 K, 1153 K, 1083 K, and 1013 K. A common subset of 1460 unique reflections was used for the comparative structure refinements at each temperature. The results obtained for the HT structure refinements of d-Al-Cu-Rh QC seem to contradict a pure phasonic-entropy-based stabilization mechanism [2] for this QC. The trends observed for the ln func(I(T1 )/I(T2 )) vs.|k⊥ |^2 plots indicate that the best on-average quasiperiodic order exists between 1083 K and 1153 K, however, what that actually means is unclear. It could indicate towards a small phasonic contribution to entropy, but such contribution is not seen in the structure refinements. A rough estimation of the hypothetic phason instability temperature shows that it would be kinetically inaccessible and thus the phase transition to a 12 Å low T structure (at ~800 K) is most likely not phason-driven. Except for the obvious increase in the amplitude of the thermal motion, no other significant structural changes, in particular no sources of additional phason-related configurational entropy, were found. All structures are refined to very similar R-values, which proves that the quality of the refinement at each temperature is the same. This suggests, that concerning the stability factors, some QCs could be similar to other HT complex intermetallic phases. The experimental results clearly show that at least the ~4 Å structure of d-Al-Cu-Rh is a HT phase therefore entropy plays an important role in its stabilisation mechanism lowering the free energy. However, the main source of this entropy is probably not related to phason flips, but rather to lattice vibrations, occupational disorder unrelated to phason flips like split positions along the periodic axis.


2007 ◽  
Vol 130 ◽  
pp. 7-14 ◽  
Author(s):  
Andrew N. Fitch

The highly-collimated, intense X-rays produced by a synchrotron radiation source can be harnessed to build high-resolution powder diffraction instruments with a wide variety of applications. The general advantages of using synchrotron radiation for powder diffraction are discussed and illustrated with reference to the structural characterisation of crystalline materials, atomic PDF analysis, in-situ and high-throughput studies where the structure is evolving between successive scans, and the measurement of residual strain in engineering components.


2017 ◽  
Vol 19 (31) ◽  
pp. 20867-20880 ◽  
Author(s):  
David C. Bock ◽  
Christopher J. Pelliccione ◽  
Wei Zhang ◽  
Janis Timoshenko ◽  
K. W. Knehr ◽  
...  

Crystal and atomic structural changes of Fe3O4upon electrochemical (de)lithiation were determined.


MRS Bulletin ◽  
1988 ◽  
Vol 13 (1) ◽  
pp. 13-18 ◽  
Author(s):  
J.H. Kinney ◽  
Q.C. Johnson ◽  
U. Bonse ◽  
M.C. Nichols ◽  
R.A. Saroyan ◽  
...  

Imaging is the cornerstone of materials characterization. Until the middle of the present century, visible light imaging provided much of the information about materials. Though visible light imaging still plays an extremely important role in characterization, relatively low spatial resolution and lack of chemical sensitivity and specificity limit its usefulness.The discovery of x-rays and electrons led to a major advance in imaging technology. X-ray diffraction and electron microscopy allowed us to characterize the atomic structure of materials. Many materials vital to our high technology economy and defense owe their existence to the understanding of materials structure brought about with these high-resolution methods.Electron microscopy is an essential tool for materials characterization. Unfortunately, electron imaging is always destructive due to the sample preparation that must be done prior to imaging. Furthermore, electron microscopy only provides information about the surface of a sample. Three dimensional information, of great interest in characterizing many new materials, can be obtained only by time consuming sectioning of an object.The development of intense synchrotron light sources in addition to the improvements in solid state imaging technology is revolutionizing materials characterization. High resolution x-ray imaging is a potentially valuable tool for materials characterization. The large depth of x-ray penetration, as well as the sensitivity of absorption crosssections to atomic chemistry, allows x-ray imaging to characterize the chemistry of internal structures in macroscopic objects with little sample preparation. X-ray imaging complements other imaging modalities, such as electron microscopy, in that it can be performed nondestructively on metals and insulators alike.


2020 ◽  
Vol 22 (34) ◽  
pp. 18964-18975
Author(s):  
Dorota Matras ◽  
Antonis Vamvakeros ◽  
Simon D. M. Jacques ◽  
Vesna Middelkoop ◽  
Gavin Vaughan ◽  
...  

In situ XRD-CT and post-reaction SEM/EDX were used to study the solid-state chemistry and structural changes of Ba0.5Sr0.5Co0.8Fe0.2O3−δ membrane reactors during the oxidative coupling of methane reaction.


Sign in / Sign up

Export Citation Format

Share Document