A facile approach for the synthesis of Z-scheme photocatalyst ZIF-8/g-C3N4 with highly enhanced photocatalytic activity under simulated sunlight

2018 ◽  
Vol 42 (14) ◽  
pp. 12180-12187 ◽  
Author(s):  
Xiang Liu ◽  
Jing Zhang ◽  
Yuming Dong ◽  
Hexing Li ◽  
Yongmei Xia ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Interfacial Interaction ◽  
Simulated Sunlight ◽  
Electron Hole ◽  
Strong Interfacial Interaction

The enhanced photocatalytic activity of ZIF-8/g-C3N4 composites can be attributed to strong interfacial interaction, which promoted the photo-generated electron–hole separation.

scholarly journals Growth Process and CQDs-modified Bi4Ti3O12 Square Plates with Enhanced Photocatalytic Performance

Micromachines ◽  
2019 ◽  
Vol 10 (1) ◽  
pp. 66 ◽  
Author(s):  
Xinxin Zhao ◽  
Hua Yang ◽  
Ziming Cui ◽  
Xiangxian Wang ◽  
Zao Yi
Keyword(s):  
Electron Microscopy ◽  
Photocatalytic Activity ◽  
Visible Light ◽  
Growth Process ◽  
Photocatalytic Performance ◽  
Simulated Sunlight ◽  
Hydrothermal Route ◽  
Electron Hole ◽  
X Ray ◽  
Photocurrent Spectroscopy

Bi4Ti3O12 square plates were synthesized via a hydrothermal route, and their growth process was systematically investigated. Carbon quantum dots (CQDs) were prepared using glucose as the carbon source, which were then assembled on the surface of Bi4Ti3O12 square plates via a hydrothermal route with the aim of enhancing the photocatalytic performance. XRD (X-ray powder diffraction), SEM (scanning electron microscopy), TEM (transmission electron microscopy), UV-vis DRS (diffuse reflectance spectroscopy), XPS (X-ray photoelectron spectroscopy), FTIR (Fourier transform infrared spectroscopy), PL (photoluminescence) spectroscopy, EIS (electrochemical impedance spectroscopy) and photocurrent spectroscopy were used to systematically characterize the as-prepared samples. It is demonstrated that the decoration of CQDs on Bi4Ti3O12 plates leads to an increased visible light absorption, slightly increased bandgap, increased photocurrent density, decreased charge-transfer resistance, and decreased PL intensity. Simulated sunlight and visible light were separately used as a light source to evaluate the photocatalytic activity of the samples toward the degradation of RhB in aqueous solution. Under both simulated sunlight and visible light irradiation, CQDs@Bi4Ti3O12 composites with an appropriate amount of CQDs exhibit obviously enhanced photocatalytic performance. However, the decoration of excessive CQDs gives rise to a decrease in the photocatalytic activity. The enhanced photocatalytic activity of CQDs-modified Bi4Ti3O12 can be attributed to the following reasons: (1) The electron transfer between Bi4Ti3O12 and CQDs promotes an efficient separation of photogenerated electron/hole pairs in Bi4Ti3O12; (2) the up-conversion photoluminescence emitted from CQDs could induce the generation of additional electron/hole pairs in Bi4Ti3O12; and (3) the photoexcited electrons in CQDs could participate in the photocatalytic reactions.

Strong interfacial interaction and enhanced optical absorption in graphene/InAs and MoS2/InAs heterostructures

2017 ◽  
Vol 5 (36) ◽  
pp. 9429-9438 ◽  
Author(s):  
Feng Ning ◽  
Dan Wang ◽  
Ye-Xin Feng ◽  
Li-Ming Tang ◽  
Yong Zhang ◽  
...  
Keyword(s):  
Optical Absorption ◽  
Interfacial Interaction ◽  
Hole Pair ◽  
Electron Hole ◽  
Strong Interfacial Interaction ◽  
Electron Hole Pair

Strong interfacial interaction, remarkable electron–hole pair distribution, and obviously enhanced optical absorption in graphene/InAs and MoS2/InAs heterostructures.

scholarly journals Enhanced Visible-Light Photocatalytic Performance of SAPO-5-Based g-C3N4 Composite for Rhodamine B (RhB) Degradation

Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3948
Author(s):  
Lingfang Qiu ◽  
Zhiwei Zhou ◽  
Mengfan Ma ◽  
Ping Li ◽  
Jinyong Lu ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Visible Light ◽  
Redox Reactions ◽  
Photocatalytic Performance ◽  
Dye Degradation ◽  
Thermal Polymerization ◽  
Light Illumination ◽  
Electron Hole ◽  
Visible Light Illumination ◽  
Visible Light Photocatalytic

Novel visible-light responded aluminosilicophosphate-5 (SAPO-5)/g-C3N4 composite has been easily constructed by thermal polymerization for the mixture of SAPO-5, NH4Cl, and dicyandiamide. The photocatalytic activity of SAPO-5/g-C3N4 is evaluated by degrading RhB (30 mg/L) under visible light illumination (λ > 420 nm). The effects of SAPO-5 incorporation proportion and initial RhB concentration on the photocatalytic performance have been discussed in detail. The optimized SAPO-5/g-C3N4 composite shows promising degradation efficiency which is 40.6% higher than that of pure g-C3N4. The degradation rate improves from 0.007 min−1 to 0.022 min−1, which is a comparable photocatalytic performance compared with other g-C3N4-based heterojunctions for dye degradation. The migration of photo-induced electrons from g-C3N4 to the Al site of SAPO-5 should promote the photo-induced electron-hole pairs separation rate of g-C3N4 efficiently. Furthermore, the redox reactions for RhB degradation occur on the photo-induced holes in the g-C3N4 and Al sites in SAPO-5, respectively. This achievement not only improves the photocatalytic activity of g-C3N4 efficiently, but also broadens the application of SAPOs in the photocatalytic field.

Few-Layered MoS2 Nanostructures for Highly Efficient Visible Light Photocatalysis

NANO ◽  
2016 ◽  
Vol 11 (10) ◽  
pp. 1650114 ◽  
Author(s):  
Dan Li ◽  
Jianwei Li ◽  
Caiqin Han ◽  
Xinsheng Zhao ◽  
Haipeng Chu ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Photocatalytic Activity ◽  
Visible Light ◽  
Electrochemical Impedance ◽  
X Ray Diffraction ◽  
Electron Hole ◽  
Electrochemical Impedance Spectra ◽  
X Ray ◽  
Transmission Electron ◽  
Electron Hole Pair

Few-layered MoS2 nanostructures were successfully synthesized by a simple hydrothermal method without the addition of any catalysts or surfactants. Their morphology, structure and photocatalytic activity were characterized by X-ray diffraction, scanning electron microscopy, energy dispersive X-ray spectroscopy, transmission electron microscopy, electrochemical impedance spectra and UV-Vis absorption spectroscopy, respectively. These results show that the MoS2 nanostructures synthesized at 180[Formula: see text]C exhibit an optimal visible light photocatalytic activity (99%) in the degradation of Rhodamine B owing to the relatively easier adsorption of pollutants, higher visible light absorption and lower electron–hole pair recombination.

Enhanced visible-active photocatalytic behaviors observed in Mn-doped BiFeO3

2018 ◽  
Vol 32 (17) ◽  
pp. 1850185 ◽  
Author(s):  
Yun-Hui Si ◽  
Yu Xia ◽  
Ya-Yun Li ◽  
Shao-Ke Shang ◽  
Xin-Bo Xiong ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Visible Light ◽  
Band Gap ◽  
Diffuse Reflectance Spectroscopy ◽  
X Ray Diffraction ◽  
Electron Hole ◽  
X Ray ◽  
Mn Doped ◽  
Hole Recombination ◽  
Narrow Band Gap Semiconductors

A series of BiFeO3 and BiFe[Formula: see text]Mn[Formula: see text]O3 (x = 0, 0.02, 0.04, 0.06, 0.08, 0.10) were synthesized by a hydrothermal method. The samples were characterized by X-ray diffraction, scanning electron microscopy, energy dispersive spectroscopy (EDS) and UV–Vis diffuse reflectance spectroscopy, and their photocatalytic activity was studied by photocatalytic degradation of methylene blue in aqueous solution under visible light irradiation. The band gap of BiFeO3 was significantly decreased from 2.26 eV to 1.90 eV with the doping of Mn. Furthermore, the 6% Mn-doped BiFeO3 photocatalyst exhibited the best activity with a degradation rate of 94% after irradiation for 100 min. The enhanced photocatalytic activity with Mn doping could be attributed to the enhanced optical absorption, increment of surface reactive sites and reduction of electron–hole recombination. Our results may be conducive to design more efficient photocatalysts responsive to visible light among narrow band gap semiconductors.

First-Principles Study on Electronic and Optical Properties in Pr-Doped Anatase TiO2

2014 ◽  
Vol 924 ◽  
pp. 260-268 ◽  
Author(s):  
Hao Chen ◽  
Lan Fang Yao ◽  
Song Lin Yang ◽  
Ya Qin Wang ◽  
Xing Liang ◽  
...  
Keyword(s):  
Optical Properties ◽  
Photocatalytic Activity ◽  
First Principles ◽  
Energy Gap ◽  
Impurity Band ◽  
Anatase Tio2 ◽  
Electron Hole ◽  
Light Region ◽  
Overlap Population ◽  
Calculation Results

The crystal structures, band structures, density of states, charge density, overlap population and optical properties of pure anatase TiO2 and Pr-doped anatase TiO2 were studied by using the plane-wave pseudopotential method based on the first-principles. After Pr doping, the valence band and the conduction band moved down and became dense, energy gap became narrow and a impurity band which consists of Pr 4f states appeared. And the dipole moment got improved, which is good for the separate of the electron-hole pairs. These effectively overcome two huge shortcomings of TiO2. Besides, Pr-doped anatase TiO2 produced more carriers which have good transport properties and the absorption spectra of Pr-O bond appear in the region that the wavelength is longer. The calculation results of optical properties show that the absorption edge occured red shift, which means the photocatalytic activity of anatase TiO2 got remarkable improved during visible-light region. This conforms to the previous analysis. So the photocatalytic activity of anatase TiO2 got remarkable improved after Pr doping.

The Effect of Chromium on the Optical Properties and Photoactivity of Nano-Particulate Rutile

2012 ◽  
Vol 554-556 ◽  
pp. 502-506 ◽  
Author(s):  
Li Wei Wang ◽  
Terry A. Egerton
Keyword(s):  
Optical Properties ◽  
Photocatalytic Activity ◽  
Reflectance Spectroscopy ◽  
Electron Trapping ◽  
Electron Hole ◽  
High Chromium ◽  
Chromium Doping ◽  
Chromium Addition ◽  
Co Precipitation ◽  
Hole Recombination

Chromium doped rutile TiO2was synthesized by either co-precipitation or impregnation (surface-doping) and characterized by XRD and reflectance spectroscopy. Chromium addition did not change the TiO2structure nor did the structure of the co-precipitated products differ from that of the impregnated samples. However, chromium doping moved the absorption of both sets of products into the visible and significantly affected the TiO2photocatalytic activity for isopropanol (IPA) oxidation. At high chromium concentrations the photoactivity of the co-precipitated samples was reduced by a larger amount than that of the impregnated samples; this was attributed to a higher concentration of Cr3+ions in the rutile lattice. Unexpectedly, increased photoactivity was measured for low Cr levels of surface-doped rutile. This may be caused by increased electron-trapping, at surface Cr6+ions, and correspondingly reduced, electron-hole recombination.

Influence of Ag Doping on the Crystal Structure and Photocatalytic Activity of FeVO4

2011 ◽  
Vol 197-198 ◽  
pp. 919-925 ◽  
Author(s):  
Min Wang ◽  
Qiong Liu
Keyword(s):  
Photocatalytic Activity ◽  
Methyl Orange ◽  
Photoelectron Spectroscopy ◽  
Methyl Orange Solution ◽  
Precipitation Method ◽  
X Ray Diffraction ◽  
Electron Hole ◽  
X Ray ◽  
Orange Solution ◽  
Decoloration Rate

Silver (Ag+) doped iron (III) vanadate (FeVO4) samples are prepared by the precipitation method and then characterized by X-ray diffraction (XRD), scanning electron microscope (SEM), and X-ray photoelectron spectroscopy(XPS). The photocatalytic activity under visible light is evaluated by photocatalytic degradation of methyl orange (MO) in the solution. The results show that both FeVO4 and Ag+ doped FeVO4 samples are triclinic, the later have different surface morphology, and some needle-shaped materials appear in the later. From XPS, there are more Fe2+ ions in Ag+ doped FeVO4 sample than that in FeVO4 one without Ag+. It indicates that Ag+ doping can increase the density of the surface oxygen vacancies of catalysts, which can act as electron traps promoting the electron-hole separation and then increase the photo-activity. The decoloration rate after Ag+ doping against methyl orange solution can reach about 81%, and be more about 20％ than that of pure FeVO4.

Sign in / Sign up

Export Citation Format

Share Document