Chiral tridentate bis(oxazol-2-ylimino) isoindoline-based pincer ligands: isolation and characterization via deligation from in situ prepared Cd-ligand complexes

2021 ◽  
Author(s):  
Kristina Zivkovic ◽  
Lilia M. Baldauf ◽  
Jessica L. Cryder ◽  
Alexa Villaseñor ◽  
Valeria Reyes ◽  
...  

Two-step synthesis of new chiral, bis(oxazol-2-ylimino) isodinoline-based pincer ligands for potential use in metal-mediated enantioselective catalysis reactions.

Author(s):  
Z. Liliental-Weber ◽  
C. Nelson ◽  
R. Ludeke ◽  
R. Gronsky ◽  
J. Washburn

The properties of metal/semiconductor interfaces have received considerable attention over the past few years, and the Al/GaAs system is of special interest because of its potential use in high-speed logic integrated optics, and microwave applications. For such materials a detailed knowledge of the geometric and electronic structure of the interface is fundamental to an understanding of the electrical properties of the contact. It is well known that the properties of Schottky contacts are established within a few atomic layers of the deposited metal. Therefore surface contamination can play a significant role. A method for fabricating contamination-free interfaces is absolutely necessary for reproducible properties, and molecularbeam epitaxy (MBE) offers such advantages for in-situ metal deposition under UHV conditions


Water ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 1409
Author(s):  
Hamdhani Hamdhani ◽  
Drew E. Eppehimer ◽  
David Walker ◽  
Michael T. Bogan

Chlorophyll-a measurements are an important factor in the water quality monitoring of surface waters, especially for determining the trophic status and ecosystem management. However, a collection of field samples for extractive analysis in a laboratory may not fully represent the field conditions. Handheld fluorometers that can measure chlorophyll-a in situ are available, but their performance in waters with a variety of potential light-interfering substances has not yet been tested. We tested a handheld fluorometer for sensitivity to ambient light and turbidity and compared these findings with EPA Method 445.0 using water samples obtained from two urban lakes in Tucson, Arizona, USA. Our results suggested that the probe was not sensitive to ambient light and performed well at low chlorophyll-a concentrations (<25 µg/L) across a range of turbidity levels (50–70 NTU). However, the performance was lower when the chlorophyll-a concentrations were >25 µg/L and turbidity levels were <50 NTU. To account for this discrepancy, we developed a calibration equation to use for this handheld fluorometer when field monitoring for potential harmful algal blooms in water bodies.


1985 ◽  
Vol 40 (10) ◽  
pp. 1243-1249 ◽  
Author(s):  
Henri Brunner ◽  
Alfons Knott

The chelate phosphanes Diphos, Diop, and Norphos were reacted with C5H5Mn(CO)2THF and CH3C5H4Mn(CO)2THF to give mononuclear complexes, containing the phosphanes as unidentate or as bidentate ligands, and dinuclear complexes, containing bridging phosphane ligands. In C5H5Mn(CO)2Diop one of the two P(C6H5)2 groups of Diop is coordinated to the C5H5Mn(CO)2 fragment; the uncoordinated P(C6H5)2 group makes it a monodentate ligand. C5H5Mn(CO)2Diop together with [Rh(cod)Cl]2 was used as an in situ catalyst in the enantioselective hydrogenation of (Z)-a-[N -acetam ino]cinnamic acid (78.4% ee) and in the enantioselective hydrosilylation of acetophenone with diphenylsilane (6.7% ee).


2013 ◽  
Vol 33 (2) ◽  
pp. 295-303 ◽  
Author(s):  
Cintia Anabela Mazzucotelli ◽  
Alejandra Graciela Ponce ◽  
Catalina Elena Kotlar ◽  
María del Rosario Moreira

Author(s):  
Zatty Zawani Zaidi ◽  
Fahrul Huyop

Halogenated compound such as 2,2-dichloropropionic acid is known for its toxicity and polluted many areas especially with agricultural activities. This study focused on the isolation and characterization of the bacterium that can utilise 2,2-dichloropropionic acid from palm oil plantation in Lenga, Johor and in silico analysis of putative dehalogenase obtained from NCBI database of the same genus and species. The bacterium was isolated using an enrichment culture media supplemented with 20 mM 2,2-dicholoropropionic acid as a carbon source.  The cells were grown at 30˚C with cells doubling time of 2.00±0.005 hours with the maximum growth at A680nm of 1.047 overnight. The partial biochemical tests and morphological examination concluded that the bacterium belongs to the genus Staphylococcus sp.. This is the first reported studies of  Staphylococcus sp. with the ability to grow on 2,2-dichloropropionic acid. The genomic DNA from NCBI database of the same species was analysed assuming the same genus and has identical genomic sequence.  The full genome of Staphylococcus sp. was screened for dehalogenase gene and  haloacid dehalogenase gene was detected in the mobile genetic element of the species revealed that the dehalogenase sequence has little identities to the previously reported dehalogenases.The main outcome of the studies suggesting an in situ bioremediation can be regarded as a natural process to detoxify the contaminated sites provided that the microorganisms contained a specialised gene sequence within its genome that served the nature for many long years. Whether microorganisms will be successful in destroying man-made contaminants entirely rely on what types of organisms play a role in in situ bioremediation and which contaminants are most susceptible to bioremediation. 


2012 ◽  
Vol 4 (4) ◽  
pp. 951-954 ◽  
Author(s):  
Yoshimi Shinmura ◽  
Alison K. S. Wee ◽  
Koji Takayama ◽  
Sankararamasubramanian Halasya Meenakshisundaram ◽  
Takeshi Asakawa ◽  
...  

1991 ◽  
Vol 98 (3) ◽  
pp. 281-291
Author(s):  
P. Belgrader ◽  
A.J. Siegel ◽  
R. Berezney

Different agents have been employed to extract the histones and other soluble components from isolated HeLa S3 nuclei during nuclear matrix isolation. We report that 0.2M (NH4)2SO4 is a milder extracting agent than NaCl and LIS (lithium 3,5-diiodosalicylate), on the basis of the apparent preservation of the elaborate fibrogranular network and the residual nucleolus that resemble the in situ structures in whole cells and nuclei, minimal aggregation, and sufficient solubilization of DNA and histones. The importance of intermolecular disulfide bonds, RNA and 37 degrees C stabilization on the structural integrity of the nuclear matrix was examined in detail using sulfydryl alkylating, reducing and oxidizing agents, and RNase A. The data suggest that any disulfides formed during the isolation are not essential for maintaining the structural integrity of the in vitro matrix. However, structural integrity of the matrix is dependent upon RNA and to some degree on disulfides that presumably existed in situ. Sodium tetrathionate and 37 degrees C stabilization of isolated nuclei resulted in nuclear matrices containing an approximately twofold greater amount of protein, RNA and DNA than control preparations. The 37 degrees C incubation, unlike the sodium tetrathionate stabilization, does not appear to induce intermolecular disulfide bond formation. Neither stabilizations resulted in significant differences of the major matrix polypeptide pattern on two-dimensional (2-D) gels stained with Coomassie Blue as compared to that of unstabilized matrix. The major nuclear matrix proteins, other than the lamins, did not react to the Pruss murine monoclonal antibody (IFA) that recognizes all known intermediate filament proteins, suggesting that the internal matrix proteins are not related to the lamins in intermediate filament-like quality.


Nanomaterials ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 1316 ◽  
Author(s):  
Martínez ◽  
Inostroza-Rivera ◽  
Durán ◽  
Molero ◽  
Bonardd ◽  
...  

Fourth generation polyamidoamine dendrimer (PAMAM, G4) modified with fluorescein units (F) at the periphery and Pt nanoparticles stabilized by L-ascorbate were prepared. These dendrimers modified with hydrophobic fluorescein were used to achieve self-assembling structures, giving rise to the formation of nanoaggregates in water. The photoactive fluorescein units were mainly used as photosensitizer units in the process of the catalytic photoreduction of water propitiated by light. Complementarily, Pt-ascorbate nanoparticles acted as the active sites to generate H2. Importantly, the study of the functional, optical, surface potential and morphological properties of the photosensitized dendrimer aggregates at different irradiation times allowed for insights to be gained into the behavior of these systems. Thus, the resultant photosensitized PAMAM-fluorescein (G4-F) nanoaggregates (NG) were conveniently applied to light-driven water photoreduction along with sodium L-ascorbate and methyl viologen as the sacrificial reagent and electron relay agent, respectively. Notably, these aggregates exhibited appropriate stability and catalytic activity over time for hydrogen production. Additionally, in order to propose a potential use of these types of systems, the in situ generated H2 was able to reduce a certain amount of methylene blue (MB). Finally, theoretical electronic analyses provided insights into the possible excited states of the fluorescein molecules that could intervene in the global mechanism of H2 generation.


2016 ◽  
Vol 186 ◽  
pp. 77-93 ◽  
Author(s):  
Yon Ju-Nam ◽  
Wanisa Abdussalam-Mohammed ◽  
Jesus J. Ojeda

In this work, we report the synthesis of novel cationic phosphonium gold nanoparticles dispersible in water and dimethyl sulfoxide (DMSO) for their potential use in biomedical applications. All the cationic-functionalising ligands currently reported in the literature are ammonium-based species. Here, the synthesis and characterisation of an alternative system, based on phosphonioalkylthiosulfate zwitterions and phosphonioalkylthioacetate were carried out. We have also demonstrated that our phosphonioalkylthiosulfate zwitterions readily disproportionate into phosphonioalkylthiolates in situ during the synthesis of gold nanoparticles produced by the borohydride reduction of gold(iii) salts. The synthesis of the cationic gold nanoparticles using these phosphonium ligands was carried out in water and DMSO. UV-visible spectroscopic and TEM studies have shown that the phosphonioalkylthiolates bind to the surface of gold nanoparticles which are typically around 10 nm in diameter. The resulting cationic-functionalised gold nanoparticles are dispersible in aqueous media and in DMSO, which is the only organic solvent approved by the U.S. Food and Drug Administration (FDA) for drug carrier tests. This indicates their potential future use in biological applications. This work shows the synthesis of a new family of phosphonium-based ligands, which behave as cationic masked thiolate ligands in the functionalisation of gold nanoparticles. These highly stable colloidal cationic phosphonium gold nanoparticles dispersed in water and DMSO can offer a great opportunity for the design of novel biorecognition and drug delivery systems.


2014 ◽  
Vol 67 (10) ◽  
pp. 1387 ◽  
Author(s):  
Shi-Qiang Bai ◽  
Lu Jiang ◽  
Sheng-Li Huang ◽  
Ming Lin ◽  
Shuang-Yuan Zhang ◽  
...  

Composite Pd/Fe3O4 (1) was designed and synthesised by immobilization of tridentate pincer ligands with triethoxysilane groups on Fe3O4 nanoparticles, PdII complexation, and in-situ reduction process. The composite was characterised by transmission electron microscopy, scanning electron microscopy energy-dispersive X-ray spectroscopy, powder X-ray diffraction, vibrating sample magnetometer, Fourier transform infrared spectroscopy, thermogravimetric analysis, and Brunauer–Emmett–Teller analysis. The composite featured Pd nanoparticles of ~2–4 nm, exhibited good thermal stability and hydrophilic property as well as excellent catalytic activity towards the reduction of 4-nitrophenol to 4-aminophenol in water.


Sign in / Sign up

Export Citation Format

Share Document