Fault detection of waste water heat recovery systems for combined heat and power plant using SPC

1997 ◽  
Author(s):  
null
2019 ◽  
Vol 4 (4) ◽  
pp. 17-23
Author(s):  
Barikuura Gbonee ◽  
Barinyima Nkoi ◽  
John Sodiki

This research presents the performance assessment of a combined heat and power plant operating in the Niger Delta region of Nigeria. The main focus is to evaluate the performance parameters of the gas turbine unit and the waste heat recovery generator section of the combined-heat-and-power plant. Data were gathered from the manufacturer’s manual, field and panel operator’s log sheets and the human machine interface (HMI) monitoring screen. The standard thermodynamic equations were used to determine the appropriate parameters of the various components of the gas turbine power plant as well as that of the heat exchangers of the heat recovery steam generator (HRSG). The outcome of all analysis indicated that for every 10C rise in ambient temperature of the compressor air intake there is an average of 0.146MW drop in the gas turbine power output, a fall of about 0.176% in the thermal efficiency of the plant, a decrease of about 2.46% in the combined-cycle thermal efficiency and an increase of about 0.0323 Kg/Kwh in specific fuel consumption of the plant. In evaluating the performance of the Waste Heat Boiler (WHB), the principle of heat balance above pinch was applied to a single steam pressure HRSG exhaust gas/steam temperature profile versus exhaust heat flow. Hence, the evaporative capacity (steam flow) of the HRSG was computed from the total heat transfer in the super-heaters and evaporator tubes using heat balance above pinch. The analysis revealed that the equivalent evaporation, evaporative capacity (steam flow) and the HRSG thermal efficiency depends on the heat exchanger’s heat load and its effective maintenance.


2020 ◽  
Vol 278 ◽  
pp. 115690 ◽  
Author(s):  
Youjun Zhang ◽  
Nian Xiong ◽  
Zhihua Ge ◽  
Yichen Zhang ◽  
Junhong Hao ◽  
...  

2017 ◽  
Vol 141 ◽  
pp. 01029
Author(s):  
Olga Romashova ◽  
Alexander Tubolev ◽  
Anastasia Matveeva ◽  
Andrey Zenkov ◽  
Valentin Asmolovsky

Vestnik MEI ◽  
2020 ◽  
Vol 4 (4) ◽  
pp. 89-97
Author(s):  
Yuriy V. Yavorovsky ◽  
◽  
I′ldar A. Sultanguzin ◽  
Aleksey I. Bartenev ◽  
Stanislava A. Prishchepova ◽  
...  

2012 ◽  
Vol 9 (2) ◽  
pp. 65
Author(s):  
Alhassan Salami Tijani ◽  
Nazri Mohammed ◽  
Werner Witt

Industrial heat pumps are heat-recovery systems that allow the temperature ofwaste-heat stream to be increased to a higher, more efficient temperature. Consequently, heat pumps can improve energy efficiency in industrial processes as well as energy savings when conventional passive-heat recovery is not possible. In this paper, possible ways of saving energy in the chemical industry are considered, the objective is to reduce the primary energy (such as coal) consumption of power plant. Particularly the thermodynamic analyses ofintegrating backpressure turbine ofa power plant with distillation units have been considered. Some practical examples such as conventional distillation unit and heat pump are used as a means of reducing primary energy consumption with tangible indications of energy savings. The heat pump distillation is operated via electrical power from the power plant. The exergy efficiency ofthe primary fuel is calculated for different operating range ofthe heat pump distillation. This is then compared with a conventional distillation unit that depends on saturated steam from a power plant as the source of energy. The results obtained show that heat pump distillation is an economic way to save energy if the temperaturedifference between the overhead and the bottom is small. Based on the result, the energy saved by the application of a heat pump distillation is improved compared to conventional distillation unit.


Sign in / Sign up

Export Citation Format

Share Document