New self-controlled and self-protected integrated power switch

Author(s):  
F. Capy ◽  
M. Breil ◽  
F. Richardeau ◽  
A. Bourennane ◽  
J.P. Laur ◽  
...  
Keyword(s):  
1994 ◽  
Author(s):  
Jerry Dalton ◽  
Karla Clark ◽  
Dan Karmon

Processes ◽  
2021 ◽  
Vol 9 (7) ◽  
pp. 1112
Author(s):  
Yu-En Wu ◽  
Jyun-Wei Wang

This study developed a novel, high-efficiency, high step-up DC–DC converter for photovoltaic (PV) systems. The converter can step-up the low output voltage of PV modules to the voltage level of the inverter and is used to feed into the grid. The converter can achieve a high step-up voltage through its architecture consisting of a three-winding coupled inductor common iron core on the low-voltage side and a half-wave voltage doubler circuit on the high-voltage side. The leakage inductance energy generated by the coupling inductor during the conversion process can be recovered by the capacitor on the low-voltage side to reduce the voltage surge on the power switch, which gives the power switch of the circuit a soft-switching effect. In addition, the half-wave voltage doubler circuit on the high-voltage side can recover the leakage inductance energy of the tertiary side and increase the output voltage. The advantages of the circuit are low loss, high efficiency, high conversion ratio, and low component voltage stress. Finally, a 500-W high step-up converter was experimentally tested to verify the feasibility and practicability of the proposed architecture. The results revealed that the highest efficiency of the circuit is 98%.


Author(s):  
J. L. Galvez ◽  
X. Jorda ◽  
M. Vellvehi ◽  
J. Millan ◽  
M. A. Jose-Prieto ◽  
...  

2013 ◽  
Vol 706-708 ◽  
pp. 1631-1634
Author(s):  
Nai Gen Li ◽  
Ke Gao Liu ◽  
Yong Xu

A rotary spin-coating technology project is provided by the utility model patent in this work. It includes vacuum pump and chassis, speed display, power switch, suction piece switch, start switch and the speed control switch on the chassis panel, motor and speed controller in the chassis connected to the outside of the chassis bracket, the bracket beams fixed hanging umbrella cover, the ring hood under the umbrella cover on top of the face, the piece prop and tachometer probe in the ring hood, the chip tray fixed extended chassis top surface motor shaft, there is a solution injection tube on the top of the sheet tray in project; it has an annular heater chip at the bottom of the tray within the annular cover sheet around the motor shaft; In addition, there is an ultrasonic humidification pump, the pump output of the ultrasonic humidification communicating through the humidifying tubes with the annular cover. In above mentioned the annular cover connected to the exhaust pipe and the annular cover interior chamber. A temperature sensor is at the inside of the annular cover, and a temperature display panel on the panel of the chassis.


1976 ◽  
Vol IA-12 (2) ◽  
pp. 179-191 ◽  
Author(s):  
Peter P. Balthasar ◽  
Eberhart Reimers
Keyword(s):  

Author(s):  
Tai-Wei Ke ◽  
Yu-Hsuan Cheng ◽  
Yuh-Shyan Hwang ◽  
Jiann-Jong Chen ◽  
Yi-Tsen Ku ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document