Wave loads on monopile-supported offshore wind turbines: current methods and future challenges

2018 ◽  
pp. 9-44
Author(s):  
Enzo Marino ◽  
Agota Mockute ◽  
Claudio Borri ◽  
Claudio Lugni
Keyword(s):  
Wind Turbines ◽  
Offshore Wind ◽  
Wave Loads ◽  
Offshore Wind Turbines ◽  
Future Challenges

scholarly journals The Effect of the Second-Order Wave Loads on Drift Motion of a Semi-Submersible Floating Offshore Wind Turbine

2020 ◽  
Vol 8 (11) ◽  
pp. 859
Author(s):  
Thanh-Dam Pham ◽  
Hyunkyoung Shin
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Second Order ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Wave Loads ◽  
Hydrodynamic Loads ◽  
Drift Motion ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines

Floating offshore wind turbines (FOWTs) have been installed in Europe and Japan with relatively modern technology. The installation of floating wind farms in deep water is recommended because the wind speed is stronger and more stable. The design of the FOWT must ensure it is able to withstand complex environmental conditions including wind, wave, current, and performance of the wind turbine. It needs simulation tools with fully integrated hydrodynamic-servo-elastic modeling capabilities for the floating offshore wind turbines. Most of the numerical simulation approaches consider only first-order hydrodynamic loads; however, the second-order hydrodynamic loads have an effect on a floating platform which is moored by a catenary mooring system. At the difference-frequencies of the incident wave components, the drift motion of a FOWT system is able to have large oscillation around its natural frequency. This paper presents the effects of second-order wave loads to the drift motion of a semi-submersible type. This work also aimed to validate the hydrodynamic model of Ulsan University (UOU) in-house codes through numerical simulations and model tests. The NREL FAST code was used for the fully coupled simulation, and in-house codes of UOU generates hydrodynamic coefficients as the input for the FAST code. The model test was performed in the water tank of UOU.

Analysis of the Fatigue Damage on the Offshore Wind Turbines Exposed to Wind and Wave Loads Within the Typhoon Area

2004 ◽  
Author(s):  
Atsushi Yamashita ◽  
Kinji Sekita
Keyword(s):  
Fatigue Damage ◽  
Wind Turbines ◽  
Offshore Wind ◽  
Wave Loads ◽  
Wave Load ◽  
Offshore Wind Turbines ◽  
Simple Addition ◽  
Recorded Data ◽  
Term Data

For the design of offshore wind turbines exposed to wind and wave loads, the method of combining the wind load and the wave load is significantly important to properly calculate the maximum stresses and deflections of the towers and the foundations1). Similarly, for the analysis of the fatigue damage critical to the structural life, the influences of combined wind and wave loads have not been clearly verified. In this paper fatigue damage at the time of typhoon passing is analyzed using actually recorded data, though intrinsically long-term data more than 10years should be used to properly evaluate the fatigue damage. This paper concludes that the fatigue damage of the tower caused by the wave load is not substantial and, thus, the fatigue damage by the combined wind and wave load is only 2–3% larger than the simple addition of the independent fatigue damages by the wind and the wave loads. The fatigue damage of the tower top, which is required to reduce the diameter in order to minimize the aerodynamic confliction with blades, is larger than that of the tower bottom. The fatigue damage at the foundation by the combined wind and wave load is 25% larger than the simple addition of the wind and wave damages, as the foundation is directly exposed to the wave load. For the foundation, the proper structural section can be designed in order to improve the structural performance against fatigue.

scholarly journals Nonlinear Wave Loads on Offshore Wind Turbines: Extreme Statistics and Fatigue

2019 ◽  
Author(s):  
Yu Zhang ◽  
Paul D. Sclavounos
Keyword(s):  
Nonlinear Wave ◽  
Wind Turbines ◽  
Offshore Wind ◽  
Wave Loads ◽  
Extreme Statistics ◽  
Support Structure ◽  
Nonlinear Load ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
The Time Domain

Abstract The development is presented of an analytical model for the prediction of the stochastic nonlinear wave loads on the support structure of bottom mounted and floating offshore wind turbines. Explicit expressions are derived for the time-domain and frequency-domain nonlinear exciting forces in a seastate with significant wave height comparable to the diameter of the support structure based on the fluid impulse theory. The higher order moments of the nonlinear load are evaluated from simulated force records and the derivation of analytical expressions for the nonlinear load statistics for their efficient use in design is addressed.

Soil–Structure–Wave Interaction of Gravity-Based Offshore Wind Turbines: An Analytical Model

2020 ◽  
Vol 143 (3) ◽  
Author(s):  
Dimitrios G. Pavlou
Keyword(s):  
Dynamic Response ◽  
Analytical Model ◽  
Wind Turbines ◽  
Initial Conditions ◽  
Offshore Wind ◽  
Design Parameters ◽  
Wave Loads ◽  
Wave Load ◽  
Offshore Wind Turbines ◽  
Dynamic Phenomena

Abstract The structural design of offshore wind turbines is based on the consideration of coupled dynamic phenomena. Wave loads cause the dynamic oscillation of the monopile, and the dynamic oscillation of the monopile affects the wave loads. The boundary conditions of the gravity-based foundation-monopile-turbine system are mostly affected by the flexural stiffness of the foundation plate, the elastic and creep behavior of the soil, and the inertia (translational and rotational) of the wind turbine mass. The design of the foundation should consider the dynamic response of the soil and the monopile, and the dynamic response of the soil and the monopile is affected by the design parameters of the foundation. The initial conditions of the system yield transient dynamic phenomena. A braking wave at t = 0 causes different dynamic response than the steady-state conditions due to a harmonic wave load. In the present work, an integrated analytical model simulating the above dynamic phenomena is proposed. With the aid of double integral transforms and generalized function properties, a solution of the corresponding differential equations for the monopile-soil-foundation system and the boundary and initial conditions is derived. A parametric study is carried out, and results of the effect of the design parameters and soil properties are presented and discussed.

Comparison of Three Different TLPs for Wind Turbines by Tank Tests and Calculated Results

2015 ◽  
Author(s):  
F. Adam ◽  
T. Myland ◽  
F. Dahlhaus ◽  
J. Großmann
Keyword(s):  
Wind Turbine ◽  
Dynamic Behavior ◽  
Wind Turbines ◽  
Main Part ◽  
Natural Frequencies ◽  
Type Structure ◽  
Offshore Wind ◽  
Wave Loads ◽  
Offshore Wind Turbines ◽  
Short Overview

This paper will give a short overview of the path of development of the so called GICON® - Tension Leg Platform (TLP) for offshore wind turbines. The main part of the paper will provide a summary as well as insights from three different model basin tests. Furthermore, the comparison of a truss like structure (first concept) with a shell type structure (third concept) deduced from the measured results and also by comparison of the natural frequencies will be presented. Both structures were tested in wave tanks in a scale of 1:25. The results also include a focus on the overall dynamic behavior of the structure. In addition to the two 1:25 models, a 1:37 model was also tested at MARIN, utilizing the MARIN stock wind turbine. This model is also included in the comparison. Therefore the different scales are considered but the comparison is presented exclusively for wave loads as only the 1:37 model was tested under wind and wave conditions.

Wind/Wave Misalignment Effects on Mooring Line Tensions for a Spar Buoy Wind Turbine

2018 ◽  
Author(s):  
Luigia Riefolo ◽  
Fernando del Jesus ◽  
Raúl Guanche García ◽  
Giuseppe Roberto Tomasicchio ◽  
Daniela Pantusa
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Wind Wave ◽  
Offshore Wind ◽  
Mooring Line ◽  
Ultimate Limit State ◽  
International Electrotechnical Commission ◽  
Wave Loads ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines

The design methodology for mooring systems for a spar buoy wind turbine considers the influence of extreme events and wind/wave misalignments occurring in its lifetime. Therefore, the variety of wind and wave directions affects over the seakeeping and as a result the evaluation of the maxima loads acting on the spar-buoy wind turbine. In the present paper, the importance of wind/wave misalignments on the dynamic response of spar-type floating wind turbine [1] is investigated. Based on standards, International Electrotechnical Commission IEC and Det Norske Veritas DNV the design of position moorings should be carried out under extreme wind/wave loads, taking into account their misalignments with respect to the structure. In particular, DNV standard, in ‘Position mooring’ recommendations, specifies in the load cases definition, if site specific data is not available, to consider non-collinear environment to have wave towards the unit’s bow (0°) and wind 30° relative to the waves. In IEC standards, the misalignment of the wind and wave directions shall be considered to design offshore wind turbines and calculate the loads acting on the support structure. Ultimate Limit State (ULS) analyses of the OC3-Hywind spar buoy wind turbine are conducted through FAST code, a certified nonlinear aero-hydro-servo-elastic simulation tool by the National Renewable Energy Laboratory’s (NREL’s). This software was developed for use in the International Energy Agency (IEA) Offshore Code Comparison Collaborative (OC3) project, and supports NREL’s offshore 5-MW baseline turbine. In order to assess the effects of misaligned wind and wave, different wind directions are chosen, maintaining the wave loads perpendicular to the structure. Stochastic, full-fields, turbulence simulator Turbsim is used to simulate the 1-h turbulent wind field. The scope of the work is to investigate the effects of wind/wave misalignments on the station-keeping system of spar buoy wind turbine. Results are presented in terms of global maxima determined through mean up-crossing with moving average, which, then, are modelled by a Weibull distribution. Finally, extreme values are estimated depending on global maxima and fitted on Gumbel distribution. The Most Probable Maximum value of mooring line tensions is found to be influenced by the wind/wave misalignments. The present paper is organized as follows. Section ‘Introduction’, based on a literature study, gives useful information on the previous studies conducted on the wind/wave misalignments effects of floating offshore wind turbines. Section ‘Methodology’ describes the applied methodology and presents the spar buoy wind turbine, the used numerical model and the selected environmental conditions. Results and the corresponding discussion are given in Section ‘Results and discussion’ for each load case corresponding to the codirectional and misaligned wind and wave loads. Results are presented and discussed in time and frequency domains. Finally, in Section ‘Conclusion’ some conclusions are drawn.

Using Nonlinear Wave Kinematics to Estimate the Loads on Offshore Wind Turbines in 3-Hour Sea States

2018 ◽  
Author(s):  
Tim Bunnik ◽  
Erik-Jan de Ridder
Keyword(s):  
Wind Turbine ◽  
Nonlinear Wave ◽  
Wind Turbines ◽  
Wave Model ◽  
Breaking Waves ◽  
Model Tests ◽  
Offshore Wind ◽  
Wave Loads ◽  
Offshore Wind Turbines ◽  
Wave Basin

The effects of operational wave loads and wind loads on offshore mono pile wind turbines are well understood. For most sites, however, the water depth is such that breaking or near-breaking waves will occur causing impulsive excitation of the mono pile and consequently considerable stresses, displacements and accelerations in the monopile, tower and turbine. As has been shown in earlier, recent publications, Computational Fluid Dynamics (CFD) can be used to accurately analyze wave impacts on offshore wind turbines. However, it is not yet well suited to study the statistical variability of wave impact loads in long-duration sea states, and thus estimate the ULS and ALS loads for which a wind turbine has to be designed. An alternative, simplified approach, is the use of a Morison model in which the kinematics (water particle velocities and accelerations) from a nonlinear wave model are used. For long-crested waves the nonlinear wave model can be run in a 2D mode and is therefore relatively cheap. In this paper model tests for steep and breaking waves on an offshore wind turbine are compared with results from the Morison model. First, a deterministic comparison is made between the wave loads from the model tests and the simulation model (simulating the same 3-hour wave realization as in the basin), which turns out to be difficult because of differences between wave reflections in the wave basin (a physical beach) and the numerical wave model (absorbing boundary condition). Second, a statistical comparison is made by comparing with different wave realizations measured in the wave basin.

scholarly journals On the Modeling of Spar-Type Floating Offshore Wind Turbines

2013 ◽  
Vol 569-570 ◽  
pp. 636-643 ◽  
Author(s):  
Van Nguyen Dinh ◽  
Biswajit Basu
Keyword(s):  
Wind Turbines ◽  
Operating Conditions ◽  
Offshore Wind ◽  
Wave Loads ◽  
Dynamic Coupling ◽  
Modeling Tools ◽  
Modeling And Analysis ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Floating Platforms

In this paper an overview about floating offshore wind turbines (FOWT) including operating conditions, property and applicability of the barge, tension-leg, and spar floating platforms is described. The spar-floating offshore wind turbines (S-FOWT) have advantages in deepwater and their preliminary design, numerical modeling tools and integrated modeling are reviewed. Important conclusions about the nacelle and blade motions, tower response, effects of wind and wave loads, overall vibration and power production of the S-FOWT are summarized. Computationally-simplified models with acceptable accuracy are necessary for feasibility and pre-engineering studies of the FOWT. The design needs modeling and analysis of aero-hydro-servo dynamic coupling of the entire FOWT. This paper also familiarizes authors with FOWT and its configurations and modeling approaches.

Sign in / Sign up

Export Citation Format

Share Document