scholarly journals Influence of Soil Structure on the Mechanical Response of Soft Soil

2018 ◽  
Vol 38 ◽  
pp. 03027
Author(s):  
Bin Bin Xu

Usually the natural sedimentary soils possess structure more or less, which makes their mechanical response much different from the fully remolded soils. In this paper, the influence of soil structure on the mechanical response such as compressibility, shear, permeability is literately reviewed. It is found that the compressibility and consolidation behavior of structured and remolded soils can be divided clearly before or after the structural yield stress. The stress-strain relationship can be divided into two segments before and after the structural yield stress. Before the yield stress, the curve is elevating and after the yield stress the curve is decreasing. The increasing rate of pore water pressure increases after the soil reached yield stress.

Author(s):  
Chao-Lung Yeh ◽  
Wei-Cheng Lo ◽  
Cheng-Wei Lin ◽  
Chung-Feng Ding

Abstract. There are many factors causing land subsidence, and groundwater extraction is one of the most important causes of subsidence. A set of coupled partial differential equations are derived in this study by using the poro-elasticity theory and linear stress-strain constitutive relation to describe the one-dimensional consolidation in a saturated porous medium subjected to pore water pressure change due to groundwater table depression. Simultaneously, the closed-form analytical solutions for excess pore water pressure and total settlement are obtained. To illustrate the consolidation behavior of the poroelastic medium, the saturated layer of clay sandwiched between two sand layers is simulated, and the dimensionless pore water pressure changes with depths and the dimensionless total settlement as function of time in the clay layer are examined. The results show that the greater the water level change in the upper and lower sand layers, the greater the pore water pressure change and the total settlement of the clay layer, and the more time it takes to reach the steady state. If the amount of groundwater replenishment is increased, the soil layer will rebound.


2018 ◽  
Vol 55 (12) ◽  
pp. 1756-1768
Author(s):  
Jahanzaib Israr ◽  
Buddhima Indraratna

This paper presents results from a series of piping tests carried out on a selected range of granular filters under static and cyclic loading conditions. The mechanical response of filters subjected to cyclic loading could be characterized in three distinct phases; namely, (I) pre-shakedown, (II) post-shakedown, and (III) post-critical (i.e., the occurrence of internal erosion). All the permanent geomechanical changes such, as erosion, permeability variations, and axial strain developments, took place during phases I and III, while the specimen response remained purely elastic during phase II. The post-critical occurrence of erosion incurred significant settlement that may not be tolerable for high-speed railway substructures. The analysis revealed that a cyclic load would induce excess pore-water pressure, which, in corroboration with steady seepage forces and agitation due to dynamic loading, could then cause internal erosion of fines from the specimens. The resulting excess pore pressure is a direct function of the axial strain due to cyclic densification, as well as the loading frequency and reduction in permeability. A model based on strain energy is proposed to quantify the excess pore-water pressure, and subsequently validated using current and existing test results from published studies.


2020 ◽  
Vol 2020 ◽  
pp. 1-11
Author(s):  
Qizhi Hu ◽  
Qiang Zou ◽  
Zhigang Ding ◽  
Zhaodong Xu

The excavation unloading of deep foundation pits in soft soil areas often produces negative excess pore water pressure. The rebound deformation of soil on the excavation surface of the foundation pit can be predicted reliably through the accurate expression of relevant variation laws. In combination with the principle of effective stress and the general equation of unidirectional seepage consolidation, an equation for calculating the rebound deformation from the bottom in the process of foundation pit excavation unloading was obtained. Additionally, a triaxial unloading test was adopted to simulate the excavation unloading processes for actual foundation pit engineering. After studying the variation law of the excess pore water pressure generated by excavation unloading, it was found that the negative excess pore water pressure increased with increasing unloading rate, while the corresponding peak value decreased with increasing confining pressure. The equation for rebound calculation was verified through a comparison with relevant measured data from actual engineering. Therefore, it is considered that the equation can reliably describe the rebound deformation law of the base. This paper aims to guide the design and construction of deep foundation pits in soft soil areas.


2019 ◽  
Vol 2019 ◽  
pp. 1-9 ◽  
Author(s):  
Wei Huang ◽  
Kejun Wen ◽  
Dongsheng Li ◽  
Xiaojia Deng ◽  
Lin Li ◽  
...  

The unloading creep behavior of soft soil under lateral unloading stress path and excess pore water pressure is the core problem of time-dependent analysis of surrounding rock deformation under excavation of soft soil. The soft soil in Shenzhen, China, was selected in this study. The triaxial unloading creep tests of soft soil under different initial excess pore water pressures (0, 20, 40, and 60 kPa) were conducted with the K0 consolidation and lateral unloading stress paths. The results show that the unloading creep of soft soil was divided into three stages: attenuation creep, constant velocity creep, and accelerated creep. The duration of creep failure is approximately 5 to 30 mins. The unloading creep behavior of soft soil is significantly affected by the deviatoric stress and time. The nonlinearity of unloading creep of soft soil is gradually enhanced with the increase of the deviatoric stress and time. The initial excess pore water pressure has an obvious weakening effect on the unloading creep of soft soil. Under the same deviatoric stress, the unloading creep of soft soil is more significant with the increase of initial excess pore water pressure. Under undrained conditions, the excess pore water pressure generally decreases during the lateral unloading process and drops sharply at the moment of unloading creep damage. The pore water pressure coefficients during the unloading process were 0.73–1.16, 0.26–1.08, and 0.35–0.96, respectively, corresponding to the initial excess pore water pressures of 20, 40, and 60 kPa.


2020 ◽  
Vol 2020 ◽  
pp. 1-13
Author(s):  
Wei Huang ◽  
Kejun Wen ◽  
Xiaojia Deng ◽  
Junjie Li ◽  
Zhijian Jiang ◽  
...  

Presented in this paper is a study on the lateral unloading creep tests under different excess pore water pressures. The marine sedimentary soft soil in Shenzhen, China, was selected in this study. The results show that the excess pore water pressure plays a significant role in enhancing the unloading creep of soft soil. Higher excess pore water pressure brings more obvious creep deformation of soft soil and lower ultimate failure load. Meanwhile, the viscoelastic and the viscoplastic modulus of soft soil were found to exponentially decline with creep time. A modified merchant model and a combined model of the modified merchant model and plastic elements are used to simulate the viscoelastic and the viscoplastic deformation, respectively. Therefore, a lateral unloading creep model of soft soil is developed based on the modified merchant model. The accuracy and applicability of this model were verified through identifying the parameters in the model. Research results are of particular significance to the numerical simulation of underground space excavation in soft soil areas which considers the effects of excess pore water pressure.


2011 ◽  
Vol 415-417 ◽  
pp. 869-874
Author(s):  
Yun Cao

Dynamic compaction is a widely used method for subgrade treatment due to its merit. This article presented example of dynamic compaction test in a liquid foundation project and investigated the relationship between settlement, ground heave and drop counts, the relationship between horizontal displacement and depth of soil, the relationship between drop counts, depth, horizontal displacement and pore water pressure, and the relation curve of pore water pressure and time during single point impact test. According to the conclusion before and after the testing, some appropriate engineering parameters were obtained and some advices were put forward.


2011 ◽  
Vol 250-253 ◽  
pp. 1889-1892
Author(s):  
Yong Mou Zhang ◽  
Jian Chang Zhao

Consolidation coefficient and percent consolidation of soft clay were calculated according to the measured pore water pressure of a project in Pudong Shanghai. Calculated coefficient of consolidation was one magnitude larger than the experimental one. This was in conformity with the actual consolidation process of dynamically-consolidated soft soil.


2018 ◽  
Vol 4 (8) ◽  
pp. 1809
Author(s):  
Dao Huu Do ◽  
Nguyen Thi Phuong Khue ◽  
Phan Khac Hai

The paper builds a physical model of testing in the laboratory with the parametric tempered glass box 0.5  0.5 1.2 m (length  width  depth) containing saturated clay to study the settlement and consolidation when loading increased gradually over time. The research covers herein to present the monitoring of settlement and pore water pressure, settlement calculation, numerical simulation using PLAXIS software V8.2 based on the results of soil physical and mechanical tests before and after loading in case of having or not prefabricated vertical drain (PVD). In case of no PVD, the calculation and numerical simulation using the soil parameters before loading have the differential settlement from the monitoring data, approximately 3.86 mm (10.45%), 0.41 mm (1.11%) respectively. Meanwhile, the deviation in the case using data after loading is about 2.29 mm (6.20%), 0.21 mm (0.56%) respectively. In case of PVD, the calculation and numerical simulation with the testing result of before loading deviation from the settlement monitoring by subsidence meter is 2.91 mm (7.88%), 44.42 mm (120.28%), calculation and simulation with the testing result of after loading deviation is 0.80 mm (2.17%), 1.26 mm (3.41%). In the case of having PVD, the difference in calculation, subsidence observation, and numerical simulation between the mechanical properties before and after loading is significant, when using the mechanical data after loading then the results are quite close to the subsidence of observation and simulation rather than before loading. 


2020 ◽  
Vol 24 (2) ◽  
pp. 183-190
Author(s):  
Bin Liu ◽  
Xiugen Jiang

The widespread distribution of soft rock and soft soil in hydrological wetland environment is a common geotechnical engineering problem encountered in coastal engineering construction. To solve this problem, a study method for consolidation and deformation characteristics of soft rock and soft soil foundation in hydrological wetland environment is proposed. Taking K9+280-K11+120 section along Fu-Nehe section of National Highway 111 as the research object, the consolidation and deformation characteristics and loading conditions of soft soil foundation under embankment filling load, treatment methods of soft rock foundation, stratum conditions, temperature changes and time effects are analyzed. The results show that although the wetland soft rock and soil layer is not thick, the settlement of soft rock and soil accounts for more than 80% of the total settlement. Negative temperature has a certain influence on the consolidation settlement of soft rock foundation, which is mainly manifested in the difference between the settlement process of the central separation zone and the roadbed soft soil foundation; the pore water pressure of soft rock foundation dissipates to varying degrees. According to the monitoring results of settlement and pore water pressure, bagged sand wells are more suitable for soft rock foundation engineering treatment in hydrological wetland. The research results can provide a reference for the study, calculation and design of consolidation and deformation of soft rock foundation in hydrological wetland.


2020 ◽  
Vol 57 (3) ◽  
pp. 377-390
Author(s):  
Dongli Zhu ◽  
Buddhima Indraratna ◽  
Harry Poulos ◽  
Cholachat Rujikiatkamjorn

Piles and prefabricated vertical drains (PVDs) are two well-established inclusions used by geotechnical practitioners when dealing with soft compressible foundations. Induced movements in highly compressible soil can adversely influence the pile response by inducing additional movements and stresses in the piles. Especially, undesirable soil–pile interaction often leads to the development of excess pore-water pressure during pile installation and negative skin friction caused by the settlement of compressible soil surrounding the piles. Additional drainage by PVDs prior to the installation of a pile could reduce excess pore-water pressure, lateral soil movement, and negative skin friction on the pile. In this paper, full-scale field testing on two trial embankments built on soft soil is reported and the relative behaviour of these two embankments is compared and discussed. Soft soil underneath both embankments was consolidated before one pile was installed at the centre of each embankment. The pore-water pressure, lateral soil movement, surface settlement, and associated strain at the pile shaft were recorded. The pile capacity was tested immediately and 3 h after pile installation. The monitoring and testing results indicated that preconsolidation with PVDs before piling can effectively reduce the excess pore-water pressure, lateral soil movement, and downdrag on the pile.


Sign in / Sign up

Export Citation Format

Share Document