INTRAPARTICLE MASS TRANSFER IN THERMALLY REGENERABLE ION EXCHANGER

1985 ◽  
Vol 34 (1-6) ◽  
pp. 187-204 ◽  
Author(s):  
TAKESHI KATAOKA ◽  
HIROYUKI YOSHIDA
Fermentation ◽  
2019 ◽  
Vol 5 (1) ◽  
pp. 16 ◽  
Author(s):  
Luis Huezo ◽  
Ajay Shah ◽  
Frederick Michel

Previous studies have shown that pretreatment of corn slurries using ultrasound improves starch release and ethanol yield during biofuel production. However, studies on its effects on the mass transfer of substrates and products during fermentation have shown that it can have both beneficial and inhibitory effects. In this study, the effects of ultrasound on mass transfer limitations during fermentation were examined. Calculation of the external and intraparticle observable moduli under a range of conditions indicate that no external or intraparticle mass transfer limitations should exist for the mass transfer of glucose, ethanol, or carbon dioxide. Fermentations of glucose to ethanol using Saccharomyces cerevisiae were conducted at different ultrasound intensities to examine its effects on glucose uptake, ethanol production, and yeast population and viability. Four treatments were compared: direct ultrasound at intensities of 23 and 32 W/L, indirect ultrasound (1.4 W/L), and no-ultrasound. Direct and indirect ultrasound had negative effects on yeast performance and viability, and reduced the rates of glucose uptake and ethanol production. These results indicate that ultrasound during fermentation, at the levels applied, is inhibitory and not expected to improve mass transfer limitations.


2004 ◽  
Vol 50 (4) ◽  
pp. 233-240 ◽  
Author(s):  
Y.L. Ng ◽  
R. Yan ◽  
L.T.S. Tsen ◽  
L.C. Yong ◽  
M. Liu ◽  
...  

Fluidization finds many process applications in the areas of catalytic reactions, drying, coating, combustion, gasification and microbial culturing. This work aims to compare the dynamic adsorption characteristics and adsorption rates in a bubbling fluidized bed and a fixed bed at the same gas flow-rate, gas residence time and bed height. Adsorption with 520 ppm methanol and 489 ppm isobutane by the ZSM-5 zeolite of different particle size in the two beds enabled the differentiation of the adsorption characteristics and rates due to bed type, intraparticle mass transfer and adsorbate-adsorbent interaction. Adsorption of isobutane by the more commonly used activated carbon provided the comparison of adsorption between the two adsorbent types. With the same gas residence time of 0.79 seconds in both the bubbling bed and fixed bed of the same bed size of 40 mm diameter and 48 mm height, the experimental results showed a higher rate of adsorption in the bubbling bed as compared to the fixed bed. Intraparticle mass transfer and adsorbent-adsorbate interaction played significant roles in affecting the rate of adsorption, with intraparticle mass transfer being more dominant. The bubbling bed was observed to have a steeper decline in adsorption rate with respect to increasing outlet concentration compared to the fixed bed. The adsorption capacities of zeolite for the adsorbates studied were comparatively similar in both beds; fluidizing, and using smaller particles in the bubbling bed did not increase the adsorption capacity of the ZSM-5 zeolite. The adsorption capacity of activated carbon for isobutane was much higher than the ZSM-5 zeolite for isobutane, although at a lower adsorption rate. Fourier transform infra-red (FTIR) spectroscopy was used as an analytical tool for the quantification of gas concentration. Calibration was done using a series of standards prepared by in situ dilution with nitrogen gas, based on the ideal gas law and relating partial pressure to gas concentration. Concentrations up to 220 ppm for methanol and 75 ppm for isobutane were prepared using this method.


2008 ◽  
Vol 273-276 ◽  
pp. 776-781 ◽  
Author(s):  
Patricia F. Lito ◽  
Carlos Manuel Silva

Two models comprising external and intraparticle mass transfer resistances developed to describe ion exchange in microporous materials are compared. Maxwell-Stefan and Nernst-Planck equations account for both concentration and electric potential gradients. However, under certain conditions, Maxwell-Stefan approach can be more advantageous particularly due to taking into account ion-ion and ion-solid interactions separately. The models were tested and compared with data available in the literature, namely batch experiments on cadmium (II) removal from aqueous solution using ETS-4 microporous titanosilicate. Calculated results reveal both models provide good and similar representations as well as fine predictive capability. Therefore, under the conditions investigated, both models can be successfully applied to describe intraparticle ionic transport.


Sign in / Sign up

Export Citation Format

Share Document