Nitrogen Induced Localised-State Ensemble Effect on Multi Quantum Wells GaInNAs with Low Indium Concentration

Author(s):  
Mohammad Syahmi Nordin ◽  
Muhammad Samad ◽  
Fahrettin Sarcan ◽  
Khairul Anuar Mohamad ◽  
Afishah Alias ◽  
...  
2019 ◽  
Vol 34 (8) ◽  
pp. 1718-1723 ◽  
Author(s):  
Paweł Piotr Michałowski ◽  
Ewa Grzanka ◽  
Szymon Grzanka ◽  
Artur Lachowski ◽  
Grzegorz Staszczak ◽  
...  

Secondary ion mass spectrometry measurements can provide specific information on In fluctuations in InGaN quantum wells.


Author(s):  
N. A. Shapiro ◽  
Piotr Perlin ◽  
Christian Kisielowski ◽  
L. S. Mattos ◽  
J. W. Yang ◽  
...  

A correlation of the local indium concentration measured on an atomic scale with luminescence properties of InxGa1−xN quantum wells reveals two different types of recombination mechanisms. A piezoelectric-field based mechanism is shown to dominate in samples with thick wells (L > 3 nm) of low indium concentration (x < 0.15−0.20). Spatial indium concentration fluctuations dominate luminescence properties in samples of higher indium concentrations in thinner wells. Quantum confinement is shown to have a major effect on the radiative recombination energy. A model is presented that relates the experimentally measured nano scale structural and chemical properties of quantum wells to the characteristics of the luminescence.


2011 ◽  
Vol 208 (7) ◽  
pp. 1529-1531 ◽  
Author(s):  
T. J. Badcock ◽  
R. Hao ◽  
M. A. Moram ◽  
P. Dawson ◽  
M. J. Kappers ◽  
...  

2001 ◽  
Vol 667 ◽  
Author(s):  
N Sharma ◽  
H K Cho ◽  
J Y Lee ◽  
C J Humphreys

ABSTRACTIndium clustering in InGaN/GaN multiple quantum wells (MQWs) is believed to be responsible for the high luminescent efficiency of GaN based light emitting diodes. In this paper we show that substantial clustering can be induced by reducing to zero the interruption time between growth of the GaN barrier layer on the InGaN quantum well. Photoluminescence (PL) shows that this has the effect of increasing the luminescence intensity and decreasing the band gap energy (higher indium concentration). The clusters or quantum dots were examined and quantified by energy filtered transmission electron microscopy (EFTEM), which was used to form chemical distribution maps of indium, gallium and nitrogen. In this paper we will show that this technique can accurately calculate the indium concentration and distribution in the quantum wells. The calculations show that InxGa1−xN quantum dots (width = 1.3nm) exhibit an In concentration of up to x = 0.5, which are embedded in a quantum well matrix with x = 0.05.


Author(s):  
A. Carlsson ◽  
J.-O. Malm ◽  
A. Gustafsson

In this study a quantum well/quantum wire (QW/QWR) structure grown on a grating of V-grooves has been characterized by a technique related to chemical lattice imaging. This technique makes it possible to extract quantitative information from high resolution images.The QW/QWR structure was grown on a GaAs substrate patterned with a grating of V-grooves. The growth rate was approximately three monolayers per second without growth interruption at the interfaces. On this substrate a barrier of nominally Al0.35 Ga0.65 As was deposited to a thickness of approximately 300 nm using metalorganic vapour phase epitaxy . On top of the Al0.35Ga0.65As barrier a 3.5 nm GaAs quantum well was deposited and to conclude the structure an additional approximate 300 nm Al0.35Ga0.65 As was deposited. The GaAs QW deposited in this manner turns out to be significantly thicker at the bottom of the grooves giving a QWR running along the grooves. During the growth of the barriers an approximately 30 nm wide Ga-rich region is formed at the bottom of the grooves giving a Ga-rich stripe extending from the bottom of each groove to the surface.


Author(s):  
RAD Mackenzie ◽  
G D W Smith ◽  
A. Cerezo ◽  
J A Liddle ◽  
CRM Grovenor ◽  
...  

The position sensitive atom probe (POSAP), described briefly elsewhere in these proceedings, permits both chemical and spatial information in three dimensions to be recorded from a small volume of material. This technique is particularly applicable to situations where there are fine scale variations in composition present in the material under investigation. We report the application of the POSAP to the characterisation of semiconductor multiple quantum wells and metallic multilayers.The application of devices prepared from quantum well materials depends on the ability to accurately control both the quantum well composition and the quality of the interfaces between the well and barrier layers. A series of metal organic chemical vapour deposition (MOCVD) grown GaInAs-InP quantum wells were examined after being prepared under three different growth conditions. These samples were observed using the POSAP in order to study both the composition of the wells and the interface morphology. The first set of wells examined were prepared in a conventional reactor to which a quartz wool baffle had been added to promote gas intermixing. The effect of this was to hold a volume of gas within the chamber between growth stages, leading to a structure where the wells had a composition of GalnAsP lattice matched to the InP barriers, and where the interfaces were very indistinct. A POSAP image showing a well in this sample is shown in figure 1. The second set of wells were grown in the same reactor but with the quartz wool baffle removed. This set of wells were much better defined, as can be seen in figure 2, and the wells were much closer to the intended composition, but still with measurable levels of phosphorus. The final set of wells examined were prepared in a reactor where the design had the effect of minimizing the recirculating volume of gas. In this case there was again further improvement in the well quality. It also appears that the left hand side of the well in figure 2 is more abrupt than the right hand side, indicating that the switchover at this interface from barrier to well growth is more abrupt than the switchover at the other interface.


Sign in / Sign up

Export Citation Format

Share Document