scholarly journals Screening factors affecting chitosan extraction from mud crab (Scylla sp.) shell using microwave irradiation for the Response Surface Approach

2022 ◽  
Vol 951 (1) ◽  
pp. 012102
Author(s):  
N Arpi ◽  
Fahrizal ◽  
Y M Lubis ◽  
Asmawati ◽  
M T Fayyadh ◽  
...  

Abstract Extracting chitosan from crab shell using conventional method requires processing in strong acid and alkali conditions under high temperature with long reaction time. Microwave-based extraction proposes shorter processing time, and hence energy and cost efficient. This study intended to screen factors affecting the extraction of chitosan from mud crab shell using microwave irradiation. The factors would be used in Response Surface Methodology (RSM) approach to obtain the optimum conditions for chitosan extraction. Microwave irradiation was employed in all of the three steps of chitosan extraction, the demineralization, deproteination, and deacetylation processes. A fractional factorial design was used to screen eight independent factors to determine the most significant ones to be optimized to determine the maximum value of four responses, which were yield, mineral removal, degree of deacetylation and moisture content. The results show that all of the main independent variables were significant in affecting minimal one of the 4 responses (P < 0.05). Mud crab chitosan had the degree of deacetylation of 87.72 – 95.13 %. Results of the screening analysis concluded, the main independent factors that are going to be applied in the optimization study are NaOH concentration, microwave oven power, and reaction time in deacetylation process.

2011 ◽  
Vol 366 ◽  
pp. 366-369
Author(s):  
Feng Gao ◽  
Rong Fu ◽  
Ming Yang Qian ◽  
Zhu Min Wang ◽  
Xiang Zhang

Response surface methodology was used to optimize the soaking Mg leaching ratio from the boron slurry screened by 25 fractional factorial design. Five effective factors such as H2SO4 concentrations, reaction time, reaction temperature and stir velocity were tested by using 25 fractional factorial design criterion and three effective factors H2SO4 concentrations, reaction time and reaction temperature showed significant effect(P2SO4 concentrations of 0.29mol/l, reaction time of 90 min and reaction temperature of 50°C. Three runs of additional confirmation experiments were conducted. The mixture magnesium leaching value was 58.20%.


2021 ◽  
Vol 934 (1) ◽  
pp. 012092
Author(s):  
R Karnila ◽  
S Loekman ◽  
S Humairah

Abstract This research aims to determine the chemical composition (proximate) of chitosan and chitin, The best deacetylation temperature for obtaining chitosan, and the yield of chitosan and chitin from mud crab. This research was conducted in two stages, that is: 1) Preparation of mud crab flour and 2) Extraction and analysis of chitin and chitosan. The experimental design used for chitosan isolation was Completely Randomized Design (CRD). The process of deacetylation chitin becomes chitosan by using 50% NaOH with varying heating temperatures (120, 130, and 140°C). Parameters observed were yield, moisture content, ash content, and degrees of deacetylation. The result showed that the best chitosan was obtained by chitin deacetylation process into chitosan using a temperature of 130°C (KO2). Characteristics quality of the chitosan mud crab shell produced are KO1: yield 61.00%, moisture content 6.47%, ash content 17.18% (db), and degree of deacetylation 49.63%. KO2: yield 59.94%, moisture content 6.48%, ash content 14.85% (db) with degree of deacetylation 51.13%. KO3: yield 53,97, moisture content 6.54%, ash content 14.66% (db) and degree of deacetylation 52.63%. Characteristic quality of chitin included yield was 27.81%, moisture content 7.29%, ash 44.05%, and degree of deacetylation 33.09%.


2018 ◽  
Vol 53 ◽  
pp. 03050 ◽  
Author(s):  
Jiabin Wang ◽  
Xiaoyu Wang ◽  
Liping Qiu ◽  
Tianhang Li ◽  
Cong Yu

Excessive phosphorus emission is one of the important reasons for the eutrophication of water. At the same time, phosphorus is a significant mineral resource. In this paper, the response surface method is used to study the key influencing factors of phosphorus removal by steel slag filter and its action. Four factors affecting the dosage, initial pH, reaction time and calcium-phosphorus molar ratio were selected. The phosphorus removal was used as the response value. The interaction between various factors was established by Box-Behnken response surface analysis. The optimal conditions were determined by equation regression analysis: dosage = 2 cm3; initial pH = 7; molar ratio of calcium to phosphorus was 2:1; reaction time = 2 h.


2013 ◽  
Vol 859 ◽  
pp. 337-340
Author(s):  
Qiang Wang ◽  
Guo Dong Liu ◽  
Shan Shan Gong ◽  
Qi Sun

Treatment of protected furanoses with FeCl3·6H2O in acetonitrile with microwave irradiation provides an efficient and mild protocol for regioselective removal of anomeric O-acetyl group. This method features cost efficient reagents, simple procedures, and high yields. The experimental results proved that microwave irradiation could notably shorten the reaction time and increase the product yield compared to the conventional thermal heating condition.


Molecules ◽  
2020 ◽  
Vol 25 (11) ◽  
pp. 2501 ◽  
Author(s):  
Tarek S. Ibrahim ◽  
Israa A. Seliem ◽  
Siva S. Panda ◽  
Amany M. M. Al-Mahmoudy ◽  
Zakaria K. M. Abdel-Samii ◽  
...  

A straightforward, mild and cost-efficient synthesis of various arylamides in water was accomplished using versatile benzotriazole chemistry. Acylation of various amines was achieved in water at room temperature as well as under microwave irradiation. The developed protocol unfolds the synthesis of amino acid aryl amides, drug conjugates and benzimidazoles. The environmentally friendly synthesis, short reaction time, simple workup, high yields, mild conditions and free of racemization are the key advantages of this protocol.


2020 ◽  
Vol 7 (2) ◽  
pp. 145-156
Author(s):  
Pravinkumar Patil ◽  
Gangadhar Bhopalkar ◽  
Sainath Zangade

Background: The various industrial processes have a diverse effect on the environment through pollution. In view of these observations, some environmentally benign synthetically protocols have developed under green chemistry. For rapid and sustainable synthesis, the microwave irradiation (MI) has gained popularity as a powerful tool compared to conventional synthesis. The present study describes the synthesis of novel substituted 1, 3-diaryl-2-propene-1-one derivative using alumina supported K3PO4-MWI combination. Objective: Chalcones are important compounds which are widely spread in nature like in fruits, vegetables, tea, spices, etc. The 2’-hydroxy derivative of chalcones plays an important role in the synthesis of bioactive compounds. The present communication deals with a convenient and rapid synthesis of 1, 3-diaryl-2-propene-1-one under the support of alumina-tripotassium phosphate and microwave irradiation. Our efforts are focused on the introduction of typical and easier route for the synthesis of title compounds using a microwave. All synthesized chalcones have been screened and evaluated for the antioxidant activity by DPPH and nitric oxide radical scavenging. Some of these compounds are found to be more potent scavengers and may lead to the development of a new class of antioxidants. Methods: The α, β-unsaturated carbonyl functionality contains two electrophilic centers allowing them to undergo addition and cyclization reactions with different nucleophiles. In the literature survey, we found that Chalcones were synthesized using tripotassium phosphate catalyst under refluxing by a conventional method. A novel method for the synthesis of 1, 3-diaryl-2-propene-1-one via Claisen Schmidt has been introduced by reacting substituted 2’- hydroxyl acetonaphthones with substituted aromatic aldehydes under the support of basic alumina –tripotassium phosphate via microwave radiations. Formation of corresponding Chalcones was confirmed by spectral studies followed by their screening for antioxidant activity. The scavenging activity is expressed in terms of % inhibition and IC50 value (μg/ml). Results: The structures of newly synthesized Chalcones were confirmed and in good agreement with obtained spectral analysis such as IR, NMR, Mass and elemental analysis. Commercially available basic alumina and tripotassium phosphate in combination of microwave were utilized and found to be effective, convenient route for the synthesis of 1, 3-diaryl-2-propene-1-one derivatives with desirable yields in short reaction time (5-12 min). The results of antioxidant activity revealed that the IC50 value for compounds 3a, 3d, 3e, 3f, 3g, 3h, 3j, 3l and 3n are lower than that of standard ascorbic acid to scavenge DPPH radical. This indicates that these compounds are more significant scavengers in comparison with standard drug. On the other hand, compounds 3a, 3b, 3c, 3d, 3g, 3l and 3n are more potent scavengers for NO free radical. Conclusion: We have introduced an efficient, ecofriendly, simple and fast microwave assisted method using basic alumina-tripotassium phosphate for the synthesis of 1, 3-diaryl-2-propene-1- one derivatives. Microwave irradiation provides an effective way for the preparation of Chalcones in terms of several advantages as a simple procedure, short reaction time, milder reaction condition, cleaner reaction and excellent yield. The scavenging activity of chalcones against DPPH and NO free radicals showed excellent properties of antioxidants.


Author(s):  
Mousumi Chakraborty ◽  
Vaishali Umrigar ◽  
Parimal A. Parikh

The present study aims at assessing the effect of microwave irradiation against thermal heat on the production of N-acetyl-p-anisidine by acetylation of p-anisidine. The acetylation of p-anisidine under microwave irradiation produces N-acetyl-p-anisidine in shorter reaction times, which offers a benefit to the laboratories as well as industries. It also eliminates the use of excess solvent. Effects of operating parameters such as reaction time, feed composition, and microwave energy and reaction temperature on selectivity to the desired product have been investigated. The results indicate as high as a 98% conversion of N-acetyl-p-anisidine can be achieved within 12-15 minutes using acetic acid. The use of acetic acid as an acetylating agent against conventionally used acetic anhydride eliminates the handling of explosive acetic anhydride and also the energy intensive distillation step for separation of acetic acid. Organic solvent like acetic anhydride are not only hazardous to the environment, they are also expensive and flammable.


2015 ◽  
Vol 4 (4) ◽  
Author(s):  
Seyed Mohammad Safieddin Ardebili ◽  
Teymor Tavakoli Hashjin ◽  
Barat Ghobadian ◽  
Gholamhasan Najafi ◽  
Stefano Mantegna ◽  
...  

AbstractThis work investigates the effect of simultaneous ultrasound-microwave irradiation on palm oil transesterification and uncovers optimal operating conditions. Response surface methodology (RSM) has been used to analyze the influence of reaction conditions, including methanol/palm oil molar ratio, catalyst concentration, reaction temperature and irradiation time on biodiesel yield. RSM analyses indicate 136 s and 129 s as the optimal sonication and microwave irradiation times, respectively. Optimized parameters for full conversion (97.53%) are 1.09% catalyst concentration and a 7:3.1 methanol/oil molar ratio at 58.4°C. Simultaneous ultrasound-microwave irradiation dramatically accelerates the palm oil transesterification reaction. Pure biodiesel was obtained after only 2.2 min while the conventional method requires about 1 h.


Sign in / Sign up

Export Citation Format

Share Document