scholarly journals An attempt to determine the adiabatic relations of ethyl oxide

1897 ◽  
Vol 60 (359-367) ◽  
pp. 336-337 ◽  
Keyword(s):  
Wave Length ◽  
Experimental Results ◽  
Mathematical Discussion ◽  
Series Of Experiments

The wave-length of sound in gaseous and in liquid ethyl oxide (sulphuric ether) has been determined by the two first-mentioned of the authors, by means of Kundt’s method, between limits of temperature ranging from 100° C. to 200° C., and of pressure ranging from 4000 mm. to 31,000 mm. of mercury, and of volume ranging from 2·6 c. c, per gram to 71 c. c. per gram. Making use of the same apparatus throughout, the results obtained are to be regarded as comparative, and, by careful determination of the pitch of the tone transmitted through the gas, it is probable they are approximately absolute. The sections of the complete memoir deal with (I) a description of the apparatus employed, (II) the method of ascertaining the weights of ether used in each series of experiments, (III) determinations of the frequency of the vibrating rod, (IV) the calculations of the adiabatic elasticity and tables of the experimental results, and (V) a mathematical discussion of the results. The last section is due to Mr. Rose-Innes.

The Effect of Stress and Warfarin on the Adrenal Gland in Relation to Spontaneous Hemorrhage, as Judged by Measurement of Adrenal Ascorbic Acid and Serum Corticosterone

1971 ◽  
Vol 26 (02) ◽  
pp. 275-288 ◽  
Author(s):  
S Chattopadhyay ◽  
D. D Johnson ◽  
G. J Millar ◽  
L. B Jaques
Keyword(s):  
Ascorbic Acid ◽  
Acid Concentration ◽  
Ascorbic Acid Concentration ◽  
Corticosterone Concentration ◽  
Serum Corticosterone ◽  
Spontaneous Hemorrhage ◽  
Combined Action ◽  
Series Of Experiments ◽  
Pituitary Adrenal Axis

SummaryRats were subjected to the following procedures: No treatment, Stressor (10% NaCl i.p.), Warfarin for 7 days, Stressor followed by Warfarin; and groups were sacrificed at intervals for assessment of spontaneous hemorrhage and of adrenal ascorbic acid concentration. There was no hemorrhage in the no treatment and stressor groups; some hemorrhage in the warfarin group; profound hemorrhage with Warfarin + Stressor. The adrenal ascorbic acid concentration was found to be lower, 8 h and again 5 days after stress, and remained lower in the warfarin + stress animals. Warfarin had no effect on adrenal ascorbic acid level.In another series of experiments in which the stress consisted of an electric current to the cage floor for 6 sec over 15 min, rats were sacrificed daily for determination of serum corticosterone concentration and occurrence of spontaneous hemorrhage. There was a statistically significant increase of serum corticosterone concentration with stress, warfarin and combined warfarin and stress treatments (P< 0.001 for all three variables). There was a significant correlation (r = 0.96 and 0.89, P< 0.01) for serum corticosterone concentration with hemorrhage score and incidence of hemorrhage in stressed rats receiving warfarin, but not in those receiving only warfarin. The results indicate an activation, rather than an exhaustion, of the pituitary-adrenal axis during the combined action of anticoagulant and stress, which results in the development of spontaneous hemorrhage.

Buckling Behavior of Tire Breaker Structure

1983 ◽  
Vol 11 (1) ◽  
pp. 3-19
Author(s):  
T. Akasaka ◽  
S. Yamazaki ◽  
K. Asano
Keyword(s):  
Elastic Foundation ◽  
Elastic Moduli ◽  
Wave Length ◽  
Bending Moment ◽  
Experimental Results ◽  
Automobile Tire ◽  
Buckling Behavior ◽  
Post Buckling ◽  
Steel Cord ◽  
Interlaminar Shear

Abstract The buckled wave length and the critical in-plane bending moment of laminated long composite strips of cord-reinforced rubber sheets on an elastic foundation is analyzed by Galerkin's method, with consideration of interlaminar shear deformation. An approximate formula for the wave length is given in terms of cord angle, elastic moduli of the constituent rubber and steel cord, and several structural dimensions. The calculated wave length for a 165SR13 automobile tire with steel breakers (belts) was very close to experimental results. An additional study was then conducted on the post-buckling behavior of a laminated biased composite beam on an elastic foundation. This beam is subjected to axial compression. The calculated relationship between the buckled wave rise and the compressive membrane force also agreed well with experimental results.

Determination of Charge Coefficient of Piezoelectric Films Using a Combined Finite Element Model and Dynamic Loading Technique

2020 ◽  
Vol 835 ◽  
pp. 229-242
Author(s):  
Oboso P. Bernard ◽  
Nagih M. Shaalan ◽  
Mohab Hossam ◽  
Mohsen A. Hassan
Keyword(s):  
Finite Element ◽  
Dynamic Loading ◽  
Material Properties ◽  
Accurate Determination ◽  
Substrate Material ◽  
Experimental Results ◽  
Piezoelectric Composite ◽  
Piezoelectric Film ◽  
Piezoelectric Charge

Accurate determination of piezoelectric properties such as piezoelectric charge coefficients (d33) is an essential step in the design process of sensors and actuators using piezoelectric effect. In this study, a cost-effective and accurate method based on dynamic loading technique was proposed to determine the piezoelectric charge coefficient d33. Finite element analysis (FEA) model was developed in order to estimate d33 and validate the obtained values with experimental results. The experiment was conducted on a piezoelectric disc with a known d33 value. The effect of measuring boundary conditions, substrate material properties and specimen geometry on measured d33 value were conducted. The experimental results reveal that the determined d33 coefficient by this technique is accurate as it falls within the manufactures tolerance specifications of PZT-5A piezoelectric film d33. Further, obtained simulation results on fibre reinforced and particle reinforced piezoelectric composite were found to be similar to those that have been obtained using more advanced techniques. FE-results showed that the measured d33 coefficients depend on measuring boundary condition, piezoelectric film thickness, and substrate material properties. This method was proved to be suitable for determination of d33 coefficient effectively for piezoelectric samples of any arbitrary geometry without compromising on the accuracy of measured d33.

scholarly journals A parametric prediction of the Young’s modulus of polymers enhanced with ΜWCNTs

2018 ◽  
Vol 233 ◽  
pp. 00025
Author(s):  
P.V. Polydoropoulou ◽  
K.I. Tserpes ◽  
Sp.G. Pantelakis ◽  
Ch.V. Katsiropoulos
Keyword(s):  
Young’S Modulus ◽  
Elastic Properties ◽  
Young's Modulus ◽  
Experimental Results ◽  
Scale Model ◽  
Fe Model ◽  
Multi Scale ◽  
Unit Cells ◽  
Random Dispersion

In this work a multi-scale model simulating the effect of the dispersion, the waviness as well as the agglomerations of MWCNTs on the Young’s modulus of a polymer enhanced with 0.4% MWCNTs (v/v) has been developed. Representative Unit Cells (RUCs) have been employed for the determination of the homogenized elastic properties of the MWCNT/polymer. The elastic properties computed by the RUCs were assigned to the Finite Element (FE) model of a tension specimen which was used to predict the Young’s modulus of the enhanced material. Furthermore, a comparison with experimental results obtained by tensile testing according to ASTM 638 has been made. The results show a remarkable decrease of the Young’s modulus for the polymer enhanced with aligned MWCNTs due to the increase of the CNT agglomerations. On the other hand, slight differences on the Young’s modulus have been observed for the material enhanced with randomly-oriented MWCNTs by the increase of the MWCNTs agglomerations, which might be attributed to the low concentration of the MWCNTs into the polymer. Moreover, the increase of the MWCNTs waviness led to a significant decrease of the Young’s modulus of the polymer enhanced with aligned MWCNTs. The experimental results in terms of the Young’s modulus are predicted well by assuming a random dispersion of MWCNTs into the polymer.

A Technique for the Laboratory Determination of Recirculation in Single Needle Dialysis

1993 ◽  
Vol 16 (2) ◽  
pp. 63-70 ◽  
Author(s):  
N.A. Hoenich ◽  
P.T. Smirthwaite ◽  
C. Woffindin ◽  
P. Lancaster ◽  
T.H. Frost ◽  
...  
Keyword(s):  
Experimental Data ◽  
Flow Rate ◽  
Experimental Results ◽  
New Technique ◽  
Treatment Efficiency ◽  
Single Lumen ◽  
Theoretical Predictions ◽  
Lumen Catheter ◽  
A New Technique

Recirculation is an important factor in single needle dialysis and, if high, can compromise treatment efficiency. To provide information regarding recirculation characteristics of access devices used in single needle dialysis, we have developed a new technique to characterise recirculation and have used this to measure the recirculation of a Terumo 15G fistula needle and a VasCath SC2300 single lumen catheter. The experimentally obtained results agreed well with those established clinically (8.5 ± 2.4% and 18.4 ± 3.4%). The experimental results have also demonstrated a dependence on access type, pump speeds and fistula flow rate. A comparison of experimental data with theoretical predictions showed that the latter exceeded those measured with the largest contribution being due to the experimental fistula.

W. T. Astbury and Ross G. Harrison: the search for the molecular determination of form in the developing embryo

1980 ◽  
Vol 35 (2) ◽  
pp. 195-219 ◽  
Keyword(s):  
Royal Society ◽  
Limb Bud ◽  
Amphibian Embryo ◽  
X Ray ◽  
Biological Phenomena ◽  
Biology I ◽  
Series Of Experiments ◽  
Molecular Patterns ◽  
Molecular Determination

Amongst the Fellows elected to the Royal Society in 1941 were W. T. Astbury for his studies using X-ray analysis to study the structures of natural fibres, and amongst the Foreign Members elected that year was Ross G. Harrison for his contributions to embryology. Astbury and Harrison were very different in temperament, and worked in very different fields on either side of the Atlantic, yet they were united in their approach to the study of biological phenomena. Both Astbury and Harrison believed that the organization and form of biological materials whether wool fibres or the limb-bud in an amphibian embryo depended on molecular structure and pattern. Moreover both were concerned with dynamic aspects of form; Astbury’s greatest achievement was to demonstrate the dynamic, reversible folding and stretching of proteins in the k-m-e-f group, and Harrison looked to changing molecular patterns to account for changing symmetries in the developing embryo. It was this common approach that brought them together and led to Harrison spending a brief month in Leeds where they and K. M. Rudall performed what have been described as ‘truly progressive experiments in molecular biology’. I believe this short series of experiments illuminates the character and work of both Harrison and Astbury and illustrates the difficulties, practical and conceptual, in carrying out ‘progressive experiments’. I shall begin by reviewing briefly the embryological background of the time before going on to discuss in detail the approaches of Harrison and Astbury to their work and the outcome of their collaboration.

Optimization of a Specimen Size for the Determination of the Diffusible Hydrogen Content in Metals

2014 ◽  
Vol 698 ◽  
pp. 466-471
Author(s):  
Oleg V. Panchenko ◽  
Alexey M. Levchenko ◽  
Victor A. Karkhin
Keyword(s):  
Hydrogen Content ◽  
Calculation Method ◽  
Specimen Size ◽  
Experimental Results ◽  
Diffusible Hydrogen ◽  
Measuring Methods ◽  
Deposited Metal ◽  
Calculation Results

Specimens of various sizes are used to determine hydrogen content in deposited metals in such standards as ISO 3690, AWS A 4.3, and GOST 23338 while measuring methods are the same. It causes problems in comparison of experimental results and brings up the following question: what kind of specimen size is optimal to determine hydrogen content? An optimal specimen size was estimated using a calculation method. Experimental and calculation results obtained by using specimens with estimated dimensions were compared to the results obtained by using the specimen with dimensions of 100*25*8 mm to determine hydrogen content in a deposited metal.

IV. On the determination of the scale value of a Thomson’s quadrant electrometer used for registering the variations in atmospheric electricity at the Kew Observatory

1878 ◽  
Vol 27 (185-189) ◽  
pp. 356-361 ◽  
Keyword(s):  
Atmospheric Electricity ◽  
Series Of Experiments

The Meteorological Council, being desirous of discussing the photographic traces produced by their electrograph at the Kew Observatory some time since, requested the Kew Committee to institute a series of experiments, with the view of determining the scale value of the instrument, in order to prepare a suitable scale for measuring the curves. The Kew Committee, at their meeting in November, entrusted the matter to me, and accordingly, having obtained the loan of a battery of 300 Bunsen cells, some preliminary experiments were made, which showed that the greatest potential which could be obtained with them was very inadequate for the purpose.

Spectroscopie par Source Laser. IV. Application de la Théorie d'Anderson au Calcul des Largeurs des Raies de la Transition 10°0–00°1 de N2O. Influence de l'Octupôle sur la Détermination du Moment Quadrupolaire de N2O

1973 ◽  
Vol 51 (6) ◽  
pp. 605-609 ◽  
Author(s):  
C. Boulet ◽  
N. Lacome ◽  
P. Isnard
Keyword(s):  
Quadrupole Moment ◽  
Experimental Results ◽  
Molecular Parameters ◽  
Line Widths

From the analysis of the available experimental results, a vibrational dependence of N2O line widths is shown, which can be explained, applying the Anderson–Tsao–Curnutte theory. But no dependence on ν of any of the molecular parameters can be deduced. In the last part, we have pointed out the effect on the determination of the quadrupole moment of assuming a nonvanishing octupole moment for N2O.

Sign in / Sign up

Export Citation Format

Share Document