scholarly journals Modeling the Stability of Severe Acute Respiratory Syndrome Coronavirus 2 (SARS-CoV-2) on Skin, Currency, and Clothing

Author(s):  
David E. Harbourt ◽  
Andrew D. Haddow ◽  
Ashley E. Piper ◽  
Holly Bloomfield ◽  
Brian J. Kearney ◽  
...  

AbstractA new coronavirus (SARS-CoV-2) emerged in the winter of 2019 in Wuhan, China, and rapidly spread around the world. The extent and efficiency of SARS-CoV-2 pandemic is far greater than previous coronaviruses that emerged in the 21st Century. Here, we modeled stability of SARS-CoV-2 on skin, paper currency, and clothing to determine if these surfaces may factor in the fomite transmission dynamics of SARS-CoV-2. Skin, currency, and clothing samples were exposed to SARS-CoV-2 under laboratory conditions and incubated at three different temperatures (4°C± 2°C, 22°C± 2°C, and 37°C ± 2°C). Stability was evaluated at 0 hours (h), 4 h, 8 h, 24 h, 72 h, 96 h, 7 days, and 14 days post-exposure. SARS-CoV-2 was shown to be stable on skin through the duration of the experiment at 4°C (14 days). Virus remained stable on skin for at least 96 h at 22°C and for at least 8h at 37°C. There were minimal differences between the tested currency samples. The virus remained stable on the $1 U.S.A. Bank Note for at least 96 h at 4°C while viable virus was not detected on the $20 U.S.A. Bank Note samples beyond 72 h. The virus remained stable on both Bank Notes for at least 8 h at 22°C and 4 h at 37°C. Clothing samples were similar in stability to the currency with the virus being detected for at least 96 h at 4°C and at least 4 h at 22°C. No viable virus was detected on clothing samples at 37°C after initial exposure. This study confirms the inverse relationship between virus stability and temperature. Furthermore, virus stability on skin demonstrates the need for continued hand hygiene practices to minimize fomite transmission both in the general population as well as workplaces where close contact is common.

2020 ◽  
Vol 14 (11) ◽  
pp. e0008831 ◽  
Author(s):  
David E. Harbourt ◽  
Andrew D. Haddow ◽  
Ashley E. Piper ◽  
Holly Bloomfield ◽  
Brian J. Kearney ◽  
...  

A new coronavirus (SARS-CoV-2) emerged in the winter of 2019 in Wuhan, China, and rapidly spread around the world. The extent and efficiency of SARS-CoV-2 pandemic is far greater than previous coronaviruses that emerged in the 21st Century. Here, we modeled stability of SARS-CoV-2 on skin, paper currency, and clothing to determine if these surfaces may factor in the fomite transmission dynamics of SARS-CoV-2. Skin, currency, and clothing samples were exposed to SARS-CoV-2 under laboratory conditions and incubated at three different temperatures (4°C± 2°C, 22°C± 2°C, and 37°C ± 2°C). We evaluated stability at 0 hours (h), 4 h, 8 h, 24 h, 72 h, 96 h, 7 days, and 14 days post-exposure. SARS-CoV-2 was stable on skin through the duration of the experiment at 4°C (14 days). Virus remained stable on skin for at least 96 h at 22°C and for at least 8h at 37°C. There were minimal differences between the tested currency samples. The virus remained stable on the $1 U.S.A. Bank Note for at least 96 h at 4°C while we did not detect viable virus on the $20 U.S.A. Bank Note samples beyond 72 h. The virus remained stable on both Bank Notes for at least 8 h at 22°C and 4 h at 37°C. Clothing samples were similar in stability to the currency. Viable virus remained for at least 96 h at 4°C and at least 4 h at 22°C. We did not detect viable virus on clothing samples at 37°C after initial exposure. This study confirms the inverse relationship between virus stability and temperature. Furthermore, virus stability on skin demonstrates the need for continued hand hygiene practices to minimize fomite transmission both in the general population as well as in workplaces where close contact is common.


Author(s):  
Ebiringa, O.T ◽  
Emeh Yadirichukwu

As a fiscal instrument, direct taxes are used to adjust people’s disposable income and to reduce the parameter of unearned incomes.  At the macroeconomic level, taxes are used to redistribute income and therefore contribute to the economic growth of the country. This paper examines the empirical forms of tax on the economic growth in Nigeria. Secondary data were sourced within the periods of 1985-2011 and Model was specified and estimated using some econometric. The result showed that the determinant factor of economic growth in the country through tax, only custom and exercise duties is capable of influencing but has an inverse relationship and significant to the GDP. It is observed that economic instability were experienced between 1986-1987 and 1993 to 1995 but evident in the stability in the economic growth from the graph in the rest of the years of the study around bench mark value of zero line of the GDP predicted graph based on tax generations in Nigeria. The study therefore recommended that the company income tax system should be generally restructured to bring about more yielded revenue results capable of contributing more significantly to the Nigerian economic as it is done in the advanced countries of the world. Custom service operations and revenue generations in the border is not practically reflected in the economy due to no accountability, transparency and leakages in the system.


2019 ◽  
Vol 10 (1) ◽  
pp. 119-124
Author(s):  
Olatunji Abdul Shobande ◽  
Kingsley Chinonso Mark

Abstract The quest for urgent solution to resolve the world liquidity problem has continued to generate enthusiastic debates among political economists, policy makers and the academia. The argument has focused on whether the World Bank Group was established to enhance the stability of international financial system or meant to enrich the developed nations. This study argues that the existing political interest of the World Bank Group in Africa may serve as lesson learned to other ambitious African Monetary Union.


Nanomaterials ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 1885
Author(s):  
Xinyu Wu ◽  
Feng Yang ◽  
Jian Gan ◽  
Zhangqian Kong ◽  
Yan Wu

The silver particles were grown in situ on the surface of wood by the silver mirror method and modified with stearic acid to acquire a surface with superhydrophobic and antibacterial properties. Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), and X-ray energy spectroscopy (XPS) were used to analyze the reaction mechanism of the modification process. Scanning electron microscopy (SEM) and contact angle tests were used to characterize the wettability and surface morphology. A coating with a micro rough structure was successfully constructed by the modification of stearic acid, which imparted superhydrophobicity and antibacterial activity to poplar wood. The stability tests were performed to discuss the stability of its hydrophobic performance. The results showed that it has good mechanical properties, acid and alkali resistance, and UV stability. The durability tests demonstrated that the coating has the function of water resistance and fouling resistance and can maintain the stability of its hydrophobic properties under different temperatures of heat treatment.


1971 ◽  
Vol 125 (4) ◽  
pp. 1009-1018 ◽  
Author(s):  
R. E. Chambers ◽  
J. R. Clamp

The stability of monosaccharides in methanolic hydrochloric acid of different strengths and at different temperatures was determined. They are generally stable for 24h in methanolic 1m- and 2m-hydrochloric acid at both 85°C and 100°C, but undergo considerable destruction in methanolic 4m- and 6m-hydrochloric acid at 100°C. Analysis of glycopeptides and oligosaccharides of known composition showed that release of carbohydrate was complete within 3h in methanolic 1m-hydrochloric acid at 85°C. Removal of methanolic hydrochloric acid by rotary evaporation resulted in considerable losses of monosaccharides, which could be prevented by prior neutralization. Methanolysis caused extensive de-N-acetylation of acetamidohexoses, so that a re-N-acetylation step is necessary in the analytical procedure. The addition of acetic anhydride for this purpose also prevented loss of internal standard by adsorption on the insoluble silver salts used in neutralization. Several trimethylsilylating agents were studied and suitable conditions are recommended. The effects on the analytical system of water and some common organic and inorganic contaminants are assessed.


Author(s):  
Josep Miquel Bauça ◽  
Andrea Caballero ◽  
Carolina Gómez ◽  
Débora Martínez-Espartosa ◽  
Isabel García del Pino ◽  
...  

AbstractObjectivesThe stability of the analytes most commonly used in routine clinical practice has been the subject of intensive research, with varying and even conflicting results. Such is the case of alanine aminotransferase (ALT). The purpose of this study was to determine the stability of serum ALT according to different variables.MethodsA multicentric study was conducted in eight laboratories using serum samples with known initial catalytic concentrations of ALT within four different ranges, namely: <50 U/L (<0.83 μkat/L), 50–200 U/L (0.83–3.33 μkat/L), 200–400 U/L (3.33–6.67 μkat/L) and >400 U/L (>6.67 μkat/L). Samples were stored for seven days at two different temperatures using four experimental models and four laboratory analytical platforms. The respective stability equations were calculated by linear regression. A multivariate model was used to assess the influence of different variables.ResultsCatalytic concentrations of ALT decreased gradually over time. Temperature (−4%/day at room temperature vs. −1%/day under refrigeration) and the analytical platform had a significant impact, with Architect (Abbott) showing the greatest instability. Initial catalytic concentrations of ALT only had a slight impact on stability, whereas the experimental model had no impact at all.ConclusionsThe constant decrease in serum ALT is reduced when refrigerated. Scarcely studied variables were found to have a significant impact on ALT stability. This observation, added to a considerable inter-individual variability, makes larger studies necessary for the definition of stability equations.


2012 ◽  
Vol 239-240 ◽  
pp. 1573-1576
Author(s):  
Zhu Qing Gao ◽  
Xiao Dong Cai ◽  
Kai Cheng Ling

At different temperatures, the protonation constants of tannic acid and the complex apparent stability constants between tannic acid and VO2+ were determined by using pH potentimetric method. The results showed that the protonation constants and the complex apparent stability constants slightly decreased with the raising temperature. In accordance with the pH value in the tannin extract technology, the conditional stability constants of the complex were calculated on the basis of the acid effect of tannic acid and the hydrolysis effect of VO2+. It was found that pH greatly affected the stability constants of the complex , so pH must be strictly controlled in the tannin extract technology.


2021 ◽  
pp. 1-25
Author(s):  
Jorg Kustermans ◽  
Rikkert Horemans

Abstract There is increasing agreement that states and other political actors on the world stage sometimes achieve international authority. However, there is less agreement about the nature and functioning of international authority relations. What determines whether an actor will be recognized as an authoritative actor? And what are the effects thereof? In this essay, we identify four distinct conceptions of authority in the study of international relations: authority as contract, authority as domination, authority as impression, and authority as consecration. Consideration of the typology leads to two important insights. First, the phenomenon of authority has an essentially experiential dimension. Subordinate actors’ emotional experience of authority determines their response to authority and thus also has a fundamental impact on the stability of authority. Second, the emergence of forms of international authority does not entail, at least not necessarily, the weakening of the sovereignty of states, but can equally be argued to strengthen it.


2012 ◽  
Vol 75 (3) ◽  
pp. 585-590 ◽  
Author(s):  
CAIXIA GUO ◽  
TIANLI YUE ◽  
SHAIMAA HATAB ◽  
YAHONG YUAN

This study aimed to investigate the adsorption of patulin from apple juice, using two types of inactivated yeast powder: laboratory-prepared yeast powder (LYP) and commercial yeast powder (CYP). The effects of incubation time, pH, incubation temperature, adsorbent amount, and initial concentration of patulin and the stability of the yeast-mycotoxin complex were assessed. The results showed that the efficiencies of the two yeast types in adsorbing patulin were similar. The ability of the powders to remove patulin increased with longer incubation times, and patulin concentration was below detectable levels with LYP and CYP at approximately 36 and 30 h, respectively. The highest removal of patulin was achieved at pH 5.0 for both powder types, and there were no significant differences in patulin decrease at different temperatures (4, 29, and 37°C). Additionally, the adsorption percentage of patulin increased significantly with the increase of absorbent amount and decrease of initial concentration of patulin. Stability of the yeast-patulin complex was assessed, and patulin was more stable when washed in phosphate-buffered saline (pH 4.0) than in absolute ethyl alcohol. These results suggest that inactivated yeast powder has potential as a novel and promising adsorbent to bind patulin effectively.


Sign in / Sign up

Export Citation Format

Share Document