High-density stacking faults in a supersaturated nitrided layer on austenitic stainless steel

2016 ◽  
Vol 49 (6) ◽  
pp. 1967-1971 ◽  
Author(s):  
Ke Tong ◽  
Fei Ye ◽  
Honglong Che ◽  
Ming Kai Lei ◽  
Shu Miao ◽  
...  

The nitrogen-supersaturated phase produced by low-temperature plasma-assisted nitriding of austenitic stainless steel usually contains a high density of stacking faults. However, the stacking fault density observed in previous studies was considerably lower than that determined by fitting the X-ray diffraction pattern. In this work, it has been confirmed by high-resolution transmission electron microscopy that the strip-shaped regions of about 3–25 nm in width observed at relatively low magnification essentially consist of a series of stacking faults on every second {111} atomic plane. A microstructure model of the clustered stacking faults embedded in a face-centred cubic structure was built for these regions. The simulated X-ray diffraction and transmission electron microscopy results based on this model are consistent with the observations.

2010 ◽  
Vol 146-147 ◽  
pp. 26-33 ◽  
Author(s):  
Ming Zhou Xu ◽  
Jian Jun Wang ◽  
Li Jun Wang ◽  
Wen Fang Cui ◽  
Chun Ming Liu

Microstructural evolution of a metastable 18Cr12Mn0.55N austenitic stainless steel during compression deformation was investigated by transmission electron microscopy (TEM) and X-ray diffraction (XRD). TEM observation showed the occurrence of deformation-induced phase transformation and atypical deformation twin, the deformation-induced phase cannot be identified as austenite or martensite. XRD test showed that the amount of deformation-induced phase is less than the detectable limit of XRD.


2013 ◽  
Vol 331 ◽  
pp. 522-526
Author(s):  
Jiang Wang ◽  
Jian Li ◽  
You Wen Wang

When the self-made with Teflon lined with stainless steel reaction kettle is used to produce PbTiO3 nanowires with the adoption of hydrothermal reaction , PbTiO3 nanowires with new structure can be made when Pb/Ti equals 2.2. Observed through the Transmission Electron Microscopy (TEM), the bending feature of the PbTiO3 nanowires can be observed for several times when X-ray diffraction (XRD) and Electron Backscattered Diffraction (EBSD) are used to analyse and test the crystal structure of the nanowires. The result of the study shows that the degree of the bending of the PbTiO3 nanowires varies with the intensity of the electron beam from the Transmission Electron Microscopy, and its process can be reversible.


2010 ◽  
Vol 650 ◽  
pp. 193-198 ◽  
Author(s):  
Yuan Yuan Song ◽  
Xiu Yan Li ◽  
Fu Xing Yin ◽  
De Hai Ping ◽  
Li Jian Rong ◽  
...  

Tempering temperature dependence of the amount of the reversed austenite in the range of 570 oC to 680 oC was investigated by means of X-ray diffraction (XRD) measurements and transmission electron microscopy (TEM) in a low carbon Fe-13%Cr-4%Ni-Mo (wt.%) martensitic stainless steel. It was found that the reversed austenite began to form at the tempered temperature slightly above the As temperature. As the tempered temperature increased, the amount of the reversed austenite changed little in the temperature range of 580-595 oC. Then, the amount of the reversed austenite increased sharply with the increased tempered temperature. When the tempered temperature increased to about 620 oC, the amount of the reversed austenite exhibited a peak. Afterward, it decreased quickly at the elevated tempered temperature. The microstructural evolvement of the reversed austenite at different tempering temperature was also observed by TEM.


1982 ◽  
Vol 45 (337) ◽  
pp. 157-161 ◽  
Author(s):  
L. R. Gellens ◽  
G. D. Price ◽  
J. V. Smith

AbstractSvetlozarite, previously described as a new member of the mordenite group of zeolites, is reinterpreted as a multiply twinned and highly faulted dachiardite. X-ray diffraction study and transmission electron microscopy revealed (001) twins and (100) stacking faults. The former are attributed at least mainly to the insertion of a b glide plane between dachiardite sheets at each twin interface, which preserves the 5-ring linkages between the sheets. The latter are associated with loss of the C face-centring relation, and are attributed to replacement of shared 5-rings by linked 4-rings in the dachiardite sheets. Further study is needed to determine whether the structural faults in the dachiardite structures are chemically controlled.


2006 ◽  
Vol 911 ◽  
Author(s):  
Robert S Okojie ◽  
Xianrong Huang ◽  
Michael Dudley ◽  
Ming Zhang ◽  
Pirouz Pirouz

AbstractWe used Film Stress Measurement (FSM), Transmission Electron Microscopy (TEM), and High-Resolution X-ray Diffraction (HRXRD) techniques to obtain further knowledge with respect to the deformation, warpage, and stacking faults (SF's) that are induced in n-type 4H-SiC wafers and epilayers when subjected to mechanical polishing and high temperature (1150 oC) processing.


Author(s):  
R. Gronsky

The phenomenon of clustering in Al-Ag alloys has been extensively studied since the early work of Guinierl, wherein the pre-precipitation state was characterized as an assembly of spherical, ordered, silver-rich G.P. zones. Subsequent x-ray and TEM investigations yielded results in general agreement with this model. However, serious discrepancies were later revealed by the detailed x-ray diffraction - based computer simulations of Gragg and Cohen, i.e., the silver-rich clusters were instead octahedral in shape and fully disordered, atleast below 170°C. The object of the present investigation is to examine directly the structural characteristics of G.P. zones in Al-Ag by high resolution transmission electron microscopy.


Minerals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 611
Author(s):  
Celia Marcos ◽  
María de Uribe-Zorita ◽  
Pedro Álvarez-Lloret ◽  
Alaa Adawy ◽  
Patricia Fernández ◽  
...  

Chert samples from different coastal and inland outcrops in the Eastern Asturias (Spain) were mineralogically investigated for the first time for archaeological purposes. X-ray diffraction, X-ray fluorescence, transmission electron microscopy, infrared and Raman spectroscopy and total organic carbon techniques were used. The low content of moganite, since its detection by X-ray diffraction is practically imperceptible, and the crystallite size (over 1000 Å) of the quartz in these cherts would be indicative of its maturity and could potentially be used for dating chert-tools recovered from archaeological sites. Also, this information can constitute essential data to differentiate the cherts and compare them with those used in archaeological tools. However, neither composition nor crystallite size would allow distinguishing between coastal and inland chert outcrops belonging to the same geological formations.


Author(s):  
Eric O'Quinn ◽  
Cameron Tracy ◽  
William F. Cureton ◽  
Ritesh Sachan ◽  
Joerg C. Neuefeind ◽  
...  

Er2Sn2O7 pyrochlore was irradiated with swift heavy Au ions (2.2 GeV), and the induced structural modifications were systematically examined using complementary characterization techniques including transmission electron microscopy (TEM), X-ray diffraction...


1995 ◽  
Vol 418 ◽  
Author(s):  
J. Forbes ◽  
J. Davis ◽  
C. Wong

AbstractThe detonation of explosives typically creates 100's of kbar pressures and 1000's K temperatures. These pressures and temperatures last for only a fraction of a microsecond as the products expand. Nucleation and growth of crystalline materials can occur under these conditions. Recovery of these materials is difficult but can occur in some circumstances. This paper describes the detonation synthesis facility, recovery of nano-size diamond, and plans to synthesize other nano-size materials by modifying the chemical composition of explosive compounds. The characterization of nano-size diamonds by transmission electron microscopy and electron diffraction, X-ray diffraction and Raman spectroscopy will also be reported.


Sign in / Sign up

Export Citation Format

Share Document