scholarly journals Laboratory exploration of mineral precipitates from Europa's subsurface ocean

2021 ◽  
Vol 54 (5) ◽  
Author(s):  
Stephen P. Thompson ◽  
Hilary Kennedy ◽  
Benjamin M. Butler ◽  
Sarah J. Day ◽  
Emmal Safi ◽  
...  

The precipitation of hydrated phases from a chondrite-like Na–Mg–Ca–SO4–Cl solution is studied using in situ synchrotron X-ray powder diffraction, under rapid- (360 K h−1, T = 250–80 K, t = 3 h) and ultra-slow-freezing (0.3 K day−1, T = 273–245 K, t = 242 days) conditions. The precipitation sequence under slow cooling initially follows the predictions of equilibrium thermodynamics models. However, after ∼50 days at 245 K, the formation of the highly hydrated sulfate phase Na2Mg(SO4)2·16H2O, a relatively recent discovery in the Na2Mg(SO4)2–H2O system, was observed. Rapid freezing, on the other hand, produced an assemblage of multiple phases which formed within a very short timescale (≤4 min, ΔT = 2 K) and, although remaining present throughout, varied in their relative proportions with decreasing temperature. Mirabilite and meridianiite were the major phases, with pentahydrite, epsomite, hydrohalite, gypsum, blödite, konyaite and loweite also observed. Na2Mg(SO4)2·16H2O was again found to be present and increased in proportion relative to other phases as the temperature decreased. The results are discussed in relation to possible implications for life on Europa and application to other icy ocean worlds.

2020 ◽  
Author(s):  
Luzia S. Germann ◽  
Sebastian T. Emmerling ◽  
Manuel Wilke ◽  
Robert E. Dinnebier ◽  
Mariarosa Moneghini ◽  
...  

Time-resolved mechanochemical cocrystallisation studies have so-far focused solely on neat and liquid-assisted grinding. Here, we report the monitoring of polymer-assisted grinding reactions using <i>in situ</i> X-ray powder diffraction, revealing that reaction rate is almost double compared to neat grinding and independent of the molecular weight and amount of used polymer additives.<br>


2016 ◽  
Vol 4 (20) ◽  
pp. 7718-7726 ◽  
Author(s):  
Dorsasadat Safanama ◽  
Neeraj Sharma ◽  
Rayavarapu Prasada Rao ◽  
Helen E. A. Brand ◽  
Stefan Adams

In situ synchrotron X-ray diffraction study of the synthesis of solid-electrolyte Li1+xAlxGe2−x(PO4)3 (LAGP) from the precursor glass reveals that an initially crystallized dopant poor phase transforms into the Al-doped LAGP at 800 °C.


2001 ◽  
Vol 15 (18) ◽  
pp. 2491-2497 ◽  
Author(s):  
J. L. ZHU ◽  
L. C. CHEN ◽  
R. C. YU ◽  
F. Y. LI ◽  
J. LIU ◽  
...  

In situ high pressure energy dispersive X-ray diffraction measurements on layered perovskite-like manganate Ca 3 Mn 2 O 7 under pressures up to 35 GPa have been performed by using diamond anvil cell with synchrotron radiation. The results show that the structure of layered perovskite-like manganate Ca 3 Mn 2 O 7 is unstable under pressure due to the easy compression of NaCl-type blocks. The structure of Ca 3 Mn 2 O 7 underwent two phase transitions under pressures in the range of 0~35 GPa. One was at about 1.3 GPa with the crystal structure changing from tetragonal to orthorhombic. The other was at about 9.5 GPa with the crystal structure changing from orthorhombic back to another tetragonal.


2007 ◽  
Vol 130 ◽  
pp. 7-14 ◽  
Author(s):  
Andrew N. Fitch

The highly-collimated, intense X-rays produced by a synchrotron radiation source can be harnessed to build high-resolution powder diffraction instruments with a wide variety of applications. The general advantages of using synchrotron radiation for powder diffraction are discussed and illustrated with reference to the structural characterisation of crystalline materials, atomic PDF analysis, in-situ and high-throughput studies where the structure is evolving between successive scans, and the measurement of residual strain in engineering components.


2018 ◽  
Vol 6 (30) ◽  
pp. 14651-14662 ◽  
Author(s):  
Laura Vitoux ◽  
Marie Guignard ◽  
Jacques Darriet ◽  
Claude Delmas

Phase diagram in the NaxMoO2system (x≤ 0.5) determined using electrochemistry andin situX-ray powder diffraction.


2001 ◽  
Vol 105 (13) ◽  
pp. 2604-2611 ◽  
Author(s):  
Michael F. Ciraolo ◽  
Jonathan C. Hanson ◽  
Poul Norby ◽  
Clare P. Grey

2010 ◽  
Vol 66 (6) ◽  
pp. 579-584 ◽  
Author(s):  
Kevin Robertson ◽  
David Bish

X-ray powder diffraction (XRD) data were used to solve the crystal structures of phases in the magnesium perchlorate hydrate system, Mg(ClO4)2·nH2O (n = 4, 2). A heating stage and humidity generator interfaced to an environmental cell enabled in-situ XRD analyses of dehydration reactions under controlled temperatures and partial pressures of H2O (P_{{\rm H}_2{\rm O}}). The crystal structures were determined using an ab initio charge-flipping method and were refined using fundamental-parameter Rietveld methods. Dehydration of magnesium perchlorate hexahydrate to tetrahydrate (348 K) results in a decrease in symmetry (space group = C2), where isolated Mg2+ cations are equatorially coordinated by four H2O molecules with two [ClO4]− tetrahedra at the apices. Further dehydration to the dihydrate (423 K) leads to bridging of the isolated packets to form double corner-sharing chains of octahedra and polyhedra (space group = C2/m).


Metals ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 873
Author(s):  
Chun-Liang Yeh ◽  
Chih-Yao Ke

The fabrication of intermetallic/ceramic composites by combustion synthesis in the mode of self-propagating high-temperature synthesis (SHS) was investigated in the Al–Ni–Ti system with the addition of B4C. Two reaction systems were employed: one was used to produce the composites of xNiAl–2TiB2–TiC with x = 2–7, and the other was used to synthesize yNi3Al–2TiB2–TiC with y = 2–7. The reaction mechanism of the Al–Ni–Ti system was strongly influenced by the presence of B4C. The reaction of B4C with Ti was highly exothermic, so the reaction temperature and combustion velocity decreased due to increasing levels of Ni and Al in the reactant mixture. The activation energies of Ea = 110.6 and 172.1 kJ/mol were obtained for the fabrication of NiAl- and Ni3Al-based composites, respectively, by the SHS reaction. The XRD (X-ray diffraction) analysis showed an in situ formation of intermetallic (NiAl and Ni3Al) and ceramic phases (TiB2 and TiC) and confirmed no reactions taking place between Ti and Al or Ni. The microstructure of the product revealed large NiAl and Ni3Al grains and small TiB2 and TiC particles. With the addition of TiB2 and TiC, the hardness of NiAl and Ni3Al was considerably increased and the toughness was also improved.


Sign in / Sign up

Export Citation Format

Share Document