scholarly journals Performance Ratio Analysis based on Energy Production for Large-Scale Solar Plant

IEEE Access ◽  
2022 ◽  
pp. 1-1
Author(s):  
Irfan Jamil ◽  
Hong Lucheng ◽  
Salman Habib ◽  
Muhammad Aurangzeb ◽  
Abdar Ali ◽  
...  
Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2741 ◽  
Author(s):  
George Lavidas ◽  
Vengatesan Venugopal

At autonomous electricity grids Renewable Energy (RE) contributes significantly to energy production. Offshore resources benefit from higher energy density, smaller visual impacts, and higher availability levels. Offshore locations at the West of Crete obtain wind availability ≈80%, combining this with the installation potential for large scale modern wind turbines (rated power) then expected annual benefits are immense. Temporal variability of production is a limiting factor for wider adaptation of large offshore farms. To this end multi-generation with wave energy can alleviate issues of non-generation for wind. Spatio-temporal correlation of wind and wave energy production exhibit that wind and wave hybrid stations can contribute significant amounts of clean energy, while at the same time reducing spatial constrains and public acceptance issues. Offshore technologies can be combined as co-located or not, altering contribution profiles of wave energy to non-operating wind turbine production. In this study a co-located option contributes up to 626 h per annum, while a non co-located solution is found to complement over 4000 h of a non-operative wind turbine. Findings indicate the opportunities associated not only in terms of capital expenditure reduction, but also in the ever important issue of renewable variability and grid stability.


The main objective of this research is analysed and compared the performance of two solar power plants to identify the possible operational problems in the tropical region. The grid connected PV power plants considered in the present study, Ten Merina and Senergy, were installed in the region of Thies (Senegal). Solar power plants have the same installed capacity 29.491 MWp. A period of one operation year of the solar power plants is considered, starting from January 2018 to December 2018. The performance parameters developed by the International Energy Agency (IEA) are used to analyse the performances of solar power plants. The results show that the plane of array irradiance at the sites is identical with an annual average of 6.2 kWh/m2/d. The annual average performance ratio and final yield of solar power plants are respectively 74.3 %; 4.61 kWh/kWp to Ten Merina and 75.9 %; 4.66 kWh/kWp to Senergy. These results are compared to other solar power plants installed in different locations around the world.


2019 ◽  
Vol 9 (1) ◽  
pp. 141 ◽  
Author(s):  
Slawomir Gulkowski ◽  
Agata Zdyb ◽  
Piotr Dragan

This study presents a comparative analysis of energy production over the year 2015 by the grid connected experimental photovoltaic (PV) system composed by different technology modules, which operates under temperate climate meteorological conditions of Eastern Poland. Two thin film technologies have been taken into account: cadmium telluride (CdTe) and copper indium gallium diselenide (CIGS). Rated power of each system is approximately equal to 3.5 kWp. In addition, the performance of a polycrystalline silicon technology system has been analyzed in order to provide comprehensive comparison of the efficiency of thin film and crystalline technologies in the same environmental conditions. The total size of the pc-Si system is equal to 17 kWp. Adequate sensors have been installed at the location of the PV system to measure solar irradiance and temperature of the modules. In real external conditions all kinds of modules exhibit lower efficiency than the values provided by manufacturers. The study reveals that CIGS technology is characterized by the highest energy production and performance ratio. The observed temperature related losses are of the lowest degree in case of CIGS modules.


2019 ◽  
Vol 14 (4) ◽  
pp. 991-1000 ◽  
Author(s):  
Martin David ◽  
Matthias Gross

Abstract The German energy transition towards more sustainable forms of energy production has been characterized as a large-scale or real-world experiment. Whereas experiments are open-ended processes set up explicitly to allow (or even generate) surprises, by contrast sustainability implies the pursuit of clearly defined, normative ends. Whereas much of the literature on system transformation builds on the concept of innovation, our hypothesis is that focusing on the “natural” flipside of innovation—called here “exnovation,” i.e., departing from unsustainable pathways—should also be seen as a valuable conceptual strategy for coping with the tension between the unavoidable indeterminacy resulting from unknown risks and the necessary amendment and redefinition of goals and rules. In this paper the German energy transition (Energiewende) is used to exemplify the recursive processes of experimentation that make it possible to accommodate surprise, and, thus, to conceptualize the unavoidable tension between innovation and the maintenance of older, unsustainable structures.


2019 ◽  
Vol 13 (3) ◽  
pp. 590-596
Author(s):  
Olivia Rossi ◽  
Arvind Chandrasekaran

Purpose The purpose of this paper is to answer this question by discussing the practicality of implementing microreactor technology towards large-scale renewable energy generation, as well as provide an incentive for future researchers to utilize microreactors as a useful alternative tool for green energy production. However, can microreactors present a viable solution for the generation of renewable energy to tackle the on-going global energy crisis? Design/methodology/approach In this paper, the practicality of implementing microreactor technology toward large-scale renewable energy generation is discussed. Specific areas of interest that elucidate considerable returns of microreactors toward renewable energy production are biofuel synthesis, hydrogen conversion and solar energy harvesting. Findings It is believed that sustained research on microreactors can significantly accelerate the development of new energy production methods through renewable sources, which will undoubtedly aid in the quest for a greener future. Originality/value This work aims to provide a sound judgement on the importance of research on renewable energy production and alternative energy management methods through microreactor technology, and why future studies on this topic should be highly encouraged. The relevance of this opinion paper lies in the idea that microreactors are an innovative concept currently used in engineering to significantly accelerate chemical reactions on microscale volumes; with the feasibility of high throughput to convert energy at larger scales with much greater efficiency than existing energy production methods.


2018 ◽  
Vol 8 (9) ◽  
pp. 1668 ◽  
Author(s):  
Jianghai Wu ◽  
Tongguang Wang ◽  
Long Wang ◽  
Ning Zhao

This article presents a framework to integrate and optimize the design of large-scale wind turbines. Annual energy production, load analysis, the structural design of components and the wind farm operation model are coupled to perform a system-level nonlinear optimization. As well as the commonly used design objective levelized cost of energy (LCoE), key metrics of engineering economics such as net present value (NPV), internal rate of return (IRR) and the discounted payback time (DPT) are calculated and used as design objectives, respectively. The results show that IRR and DPT have the same effect as LCoE since they all lead to minimization of the ratio of the capital expenditure to the energy production. Meanwhile, the optimization for NPV tends to maximize the margin between incomes and costs. These two types of economic metrics provide the minimal blade length and maximal blade length of an optimal blade for a target wind turbine at a given wind farm. The turbine properties with respect to the blade length and tower height are also examined. The blade obtained with economic optimization objectives has a much larger relative thickness and smaller chord distributions than that obtained for high aerodynamic performance design. Furthermore, the use of cost control objectives in optimization is crucial in improving the economic efficiency of wind turbines and sacrificing some aerodynamic performance can bring significant reductions in design loads and turbine costs.


2017 ◽  
Vol 2017 ◽  
pp. 1-18 ◽  
Author(s):  
Irfan Jamil ◽  
Jinquan Zhao ◽  
Li Zhang ◽  
Rehan Jamil ◽  
Syed Furqan Rafique

The installation of 3 × 50 MW (150 MW DC) large utility scale solar power plant is ground based using ventilated polycrystalline module technology with fixed tilt angle of 28° in a 750-acre land, and the site is located about 115 km northeast of Karachi, Pakistan, near the town of ThanoBula Khan, Nooriabad, Sindh. This plant will be connected to the utility distribution system through a national grid of 220 kV outgoing double-loop transmission line. The 3 × 50 MW solar PV will be one of the largest tied grid-connected power projects as the site is receiving a rich average solar radiation of 158.7 kW/h/m2/month and an annual average temperature of about of 27°C. The analysis highlights the preliminary design of the case project such as feasibility study and PV solar design aspects and is based on a simulation study of energy yield assessment which has all been illustrated. The annual energy production and energy yield assessment values of the plant are computed using the PVSYST software. The assumptions and results of energy losses, annual performance ratio (PR) 74.73%, annual capacity factor 17.7%, and annual energy production of the plant at 232,518 MWh/year are recorded accordingly. Bear in mind that reference recorded data indicates a good agreement over the performance of the proposed PV power plant.


2016 ◽  
Vol 138 (2) ◽  
Author(s):  
Marco Binotti ◽  
Paolo De Giorgi ◽  
David Sanchez ◽  
Giampaolo Manzolini

This paper investigates different strategies for the reduction of peak heat fluxes on the receiver of a solar tower plant through the variation of the heliostats aiming points. The analysis is performed for two different solar tower receivers and heliostat field layouts. The innovative aspect of the work is in the methodology proposed: the effect of different aiming points is evaluated at different sun positions, and the yearly optical efficiency is calculated to determine drawbacks in terms of energy production. The optical simulation of the solar plant is performed with delsol through a matlab suite to easily manage the input and output. Preliminary assessments showed that the most important displacement is the vertical one, and the variation of the aiming point is important for the rows that are closer to the tower. With the appropriate strategy, the peak heat flux can be reduced by about 40% with limited spillage increase compared to the reference case. This result is similar for the two investigated plants, and it is confirmed also at different sun positions. The yearly optical efficiency with the optimal aiming strategy is reduced by less than 0.5% points. Future analysis will assess potential cost reductions and thermal efficiency increase brought about by the proposed strategies.


2018 ◽  
Vol 60 (1) ◽  
pp. 104-110
Author(s):  
Marius Paulescu ◽  
Nicoleta Stefu ◽  
Ciprian Dughir ◽  
Robert Blaga ◽  
Andreea Sabadus ◽  
...  

AbstractForecasting the solar energy production is a key issue in the large-scale integration of the photovoltaic plants into the existing electricity grid. This paper reports on the research progress in forecasting the solar energy production at the West University of Timisoara, Romania. Firstly, the experimental facilities commissioned on the Solar Platform for testing the forecasting models are briefly described. Secondly, a new tool for the online forecasting of the solar energy production is introduced. Preliminary tests show that the implemented procedure is a successful trade-off between simplicity and accuracy.


Sign in / Sign up

Export Citation Format

Share Document