Real Time Full States Integrated Low Cost Navigation System for Autonomous Vehicles

2020 ◽  
Author(s):  
Ahmed H. Hassaballa ◽  
Ahmed M. Kamel ◽  
I Arafa ◽  
Yehia Z. Elhalwagy
Keyword(s):  
Real Time ◽  
Navigation System ◽  
Autonomous Vehicles ◽  
Low Cost

Low-Cost Receiver and Network Real-Time Kinematic Positioning for use in Connected and Autonomous Vehicles

2019 ◽  
Vol 72 (04) ◽  
pp. 917-930
Author(s):  
Fang-Shii Ning ◽  
Xiaolin Meng ◽  
Yi-Ting Wang
Keyword(s):  
Real Time ◽  
Autonomous Vehicles ◽  
High Performance ◽  
Low Cost ◽  
Satellite System ◽  
High Accuracy ◽  
Future Trend ◽  
Intelligent Transport System ◽  
Positioning System ◽  
Gnss Receiver

Connected and Autonomous Vehicles (CAVs) have been researched extensively for solving traffic issues and for realising the concept of an intelligent transport system. A well-developed positioning system is critical for CAVs to achieve these aims. The system should provide high accuracy, mobility, continuity, flexibility and scalability. However, high-performance equipment is too expensive for the commercial use of CAVs; therefore, the use of a low-cost Global Navigation Satellite System (GNSS) receiver to achieve real-time, high-accuracy and ubiquitous positioning performance will be a future trend. This research used RTKLIB software to develop a low-cost GNSS receiver positioning system and assessed the developed positioning system according to the requirements of CAV applications. Kinematic tests were conducted to evaluate the positioning performance of the low-cost receiver in a CAV driving environment based on the accuracy requirements of CAVs. The results showed that the low-cost receiver satisfied the “Where in Lane” accuracy level (0·5 m) and achieved a similar positioning performance in rural, interurban, urban and motorway areas.

scholarly journals Processor-in-the-Loop Architecture Design and Experimental Validation for an Autonomous Racing Vehicle

2021 ◽  
Vol 11 (16) ◽  
pp. 7225
Author(s):  
Eugenio Tramacere ◽  
Sara Luciani ◽  
Stefano Feraco ◽  
Angelo Bonfitto ◽  
Nicola Amati
Keyword(s):  
Real Time ◽  
Personal Computer ◽  
Trajectory Planning ◽  
Autonomous Vehicles ◽  
High Performance ◽  
Experimental Validation ◽  
Low Cost ◽  
Autonomous Driving ◽  
Obstacle Detection ◽  
System Level

Self-driving vehicles have experienced an increase in research interest in the last decades. Nevertheless, fully autonomous vehicles are still far from being a common means of transport. This paper presents the design and experimental validation of a processor-in-the-loop (PIL) architecture for an autonomous sports car. The considered vehicle is an all-wheel drive full-electric single-seater prototype. The retained PIL architecture includes all the modules required for autonomous driving at system level: environment perception, trajectory planning, and control. Specifically, the perception pipeline exploits obstacle detection algorithms based on Artificial Intelligence (AI), and the trajectory planning is based on a modified Rapidly-exploring Random Tree (RRT) algorithm based on Dubins curves, while the vehicle is controlled via a Model Predictive Control (MPC) strategy. The considered PIL layout is implemented firstly using a low-cost card-sized computer for fast code verification purposes. Furthermore, the proposed PIL architecture is compared in terms of performance to an alternative PIL using high-performance real-time target computing machine. Both PIL architectures exploit User Datagram Protocol (UDP) protocol to properly communicate with a personal computer. The latter PIL architecture is validated in real-time using experimental data. Moreover, they are also validated with respect to the general autonomous pipeline that runs in parallel on the personal computer during numerical simulation.

scholarly journals Real time localization solution for land vehicle application using low-cost integrated sensors with GPS

2020 ◽  
Vol 18 (4) ◽  
pp. 214-228
Author(s):  
Abdalla Eldesoky ◽  
Ahmed M. Kamel ◽  
M. Elhabiby ◽  
Hadia Elhennawy
Keyword(s):  
Data Fusion ◽  
Real Time ◽  
Navigation System ◽  
Unscented Kalman Filter ◽  
Low Cost ◽  
Sensor Data ◽  
Observation Angle ◽  
Integrated Sensors ◽  
Land Vehicle ◽  
Position Errors

The technique proposed in this research demonstrates a real time nonlinear data fusion solution based on extremely low-cost and grade inertial sensors for land vehicle navigation. Here, the utilized nonlinear multi-sensor data fusion (MSDF) is based on the combination between extremely low-cost micro electrical mechanical systems (MEMS) inertial, heading, pressure, and speed sensors in addition to satellite-based navigation system. The integrated navigation system fuses position and velocity states from the Global Positioning System (GPS), the velocity measurements from an odometer, heading angle observation from a magnetometer and navigation states from an inertial navigation system (INS). The implemented system performance is assessed through the post-processing of collected raw measurements and real time experimental work. The system that runs the real-time experiments is established on three connected platforms, two of them are based on a 32-bit ARMTM core and the third one is based 16-bit AVR ATMEL microcontroller. This microcontroller is connected to an on-board diagnostics (OBD) shield to collect the vehicle speed measurements. The raw data obtained from the integrated sensors is saved and post processed in MATLAB®. In normal conditions, the estimated position errors are reduced through the usage of INS/GPS integration with heading observation angle from a magnetometer. In GPS-denied environments, the integrated system uses the observations from INS, magnetometer in addition to the velocity from odometer to ensure a continuous and accurate navigation solution. A complementary filter (CF) is implemented to estimate and improve the pitch and roll angles calculations. In addition to that, an unscented Kalman filter (UKF) is used cascaded with the designed CF to complete the designed sensors fusion algorithm. Experimental results show that the designed MSDF can achieve a good level of accuracy and a continuous localization solution of a land vehicle in different GPS availability cases and can be implemented on the available in the market processors to be run in real time.

Static and kinematic positioning performance of a low-cost real-time kinematic navigation system module

2019 ◽  
Vol 63 (9) ◽  
pp. 3029-3042 ◽  
Author(s):  
Yun Zhang ◽  
Wenhao Yu ◽  
Yanling Han ◽  
Zhonghua Hong ◽  
Siming Shen ◽  
...  
Keyword(s):  
Real Time ◽  
Navigation System ◽  
Low Cost ◽  
Kinematic Positioning ◽  
Real Time Kinematic ◽  
System Module ◽  
Kinematic Navigation System

scholarly journals Robust Lane-Detection Method for Low-Speed Environments

Sensors ◽  
2018 ◽  
Vol 18 (12) ◽  
pp. 4274 ◽  
Author(s):  
Qingquan Li ◽  
Jian Zhou ◽  
Bijun Li ◽  
Yuan Guo ◽  
Jinsheng Xiao
Keyword(s):  
Real Time ◽  
Autonomous Vehicles ◽  
Low Cost ◽  
Lane Detection ◽  
Detection Methods ◽  
Low Speed ◽  
Geometric Fitting ◽  
The Road ◽  
Edge Points ◽  
Time Requirements

Vision-based lane-detection methods provide low-cost density information about roads for autonomous vehicles. In this paper, we propose a robust and efficient method to expand the application of these methods to cover low-speed environments. First, the reliable region near the vehicle is initialized and a series of rectangular detection regions are dynamically constructed along the road. Then, an improved symmetrical local threshold edge extraction is introduced to extract the edge points of the lane markings based on accurate marking width limitations. In order to meet real-time requirements, a novel Bresenham line voting space is proposed to improve the process of line segment detection. Combined with straight lines, polylines, and curves, the proposed geometric fitting method has the ability to adapt to various road shapes. Finally, different status vectors and Kalman filter transfer matrices are used to track the key points of the linear and nonlinear parts of the lane. The proposed method was tested on a public database and our autonomous platform. The experimental results show that the method is robust and efficient and can meet the real-time requirements of autonomous vehicles.

Sign in / Sign up

Export Citation Format

Share Document