Limitations of aperture antenna theory for accurate transient field calculation in the time domain

Author(s):  
Nikolay A. Lysenko ◽  
Grigory K. Uskov ◽  
Anatoly M. Bobreshov ◽  
Sergey P. Skulkin
2011 ◽  
Vol 110-116 ◽  
pp. 971-976
Author(s):  
Hong You Wang ◽  
Jin Guang Li

Micro-strip line is a kind of transmission line that is the most widely used in microwave integrated circuit. With the development of microwave integrated circuits and the increasing work frequency of the micro-strip line, a higher requirement for its electromagnetic compatibility has been raised. Finite-Difference Time-Domain (FDTD) method has characteristics of good adaptability in the analysis of electromagnetic compatibility issues and superiority in complexity of the structure modeling. For these reasons, this Article uses FDTD method which is widely used in electromagnetic field calculation to analyze the time-domain of micro-strip line, calculates its current and voltage induced in ports and discuss the response feature under different radiation conditions.


2015 ◽  
Vol 2015 ◽  
pp. 1-7 ◽  
Author(s):  
D. Cheng ◽  
T. T. Gu ◽  
P. Cao ◽  
T. He ◽  
K. Li

Approximate formulas are obtained for the electromagnetic pulses due to a delta-function current in a vertical electric dipole on the planar surface of a perfect conductor coated by a dielectric layer. The new approximated formulas for the electromagnetic field in time domain are retreated analytically and some new results are obtained. Computations and discussions are carried out for the time-domain field components radiated by a vertical electric dipole in the presence of three-layered region. It is shown that the trapped-surface-wave terms should be included in the total transient field when both the vertical electric dipole and the observation point are on or near the planar surface of the dielectric-coated earth.


1969 ◽  
Vol 47 (12) ◽  
pp. 1327-1330 ◽  
Author(s):  
James R. Wait

The time domain response of the fields in the vicinity of an axial caustic is calculated. The idealized model is a spherical concentric cavity with perfectly conducting walls. It is shown that the transient field, in the vicinity of the antipode of a dipole source, exhibits a strong distortion in the pulse shape.


2020 ◽  
Vol 18 ◽  
pp. 53-73
Author(s):  
Konstantin Pasche ◽  
Fabian Ossevorth ◽  
Ralf T. Jacobs

Abstract. Reverberation chambers show transient behaviour when excited with a pulsed signal. The field intensities can in this case be significantly higher than in steady state, which implies that a transient field can exceed predefined limits and render test results uncertain. Effects of excessive field intensities of short duration may get covered and not be observable in a statistical analysis of the field characteristics. In order to ensure that the signal reaches steady state, the duration of the pulse used to excite the chamber needs to be longer than the time constant of the chamber. Initial computations have shown that the pulse width should be about twice as long as the time constant of the chamber to ensure that steady state is reached. The signal is sampled in the time domain with a sampling frequency according to the Nyquist theorem. The bandwidth of the input signal is determined using spectral analysis. For a fixed stirrer position, the reverberation chamber, wires, connectors, and antennas can jointly be considered as a linear time-invariant system. In this article, a procedure will be presented to extract characteristic signal properties such as rise-time, transient overshoot and the mean value in steady state from the system response. The signal properties are determined by first computing the envelope of the sampled data using a Hilbert transform. Subsequent noise reduction is achieved applying a Savitzky–Golay filter. The point where steady state is reached is then computed from the slope of the envelope by utilising a cumulative histogram. The spectral analysis is not suitable to examine the transient behaviour and determine the time constants of the system. These constants are computed applying the method of Prony, which is based on the estimation of a number of parameters in a sum of exponential functions. An alternative to the Prony Method is the Time-Domain Vector-Fit method. In contrast to the first mentioned variant, it is now also possible to determine the transfer function of the overall RC system. Differences and advantages of the methods will be discussed.


2021 ◽  
Vol 51 (3) ◽  
Author(s):  
Xin Yang

The extrapolation of the electric field is studied theoretically both in frequency domain and time domain. Combining Gauss’s law with the approximation method in engineering, two new formulas for the scattering field calculation are derived from different logical ideas based on Stratton–Chu formula. The consistency property of the derived formulas is investigated, and the third formula for the scattering field calculation is further obtained. Finally, the time-domain extrapolation is discussed based on the formulas, followed by a simple numerical example. The results obtained are characterized by a simple form and intuitive physical meaning, and are helpful to calculate certain engineering problems.


1992 ◽  
Vol 2 (4) ◽  
pp. 615-620
Author(s):  
G. W. Series
Keyword(s):  

2018 ◽  
Vol 12 (7-8) ◽  
pp. 76-83
Author(s):  
E. V. KARSHAKOV ◽  
J. MOILANEN

Тhe advantage of combine processing of frequency domain and time domain data provided by the EQUATOR system is discussed. The heliborne complex has a towed transmitter, and, raised above it on the same cable a towed receiver. The excitation signal contains both pulsed and harmonic components. In fact, there are two independent transmitters operate in the system: one of them is a normal pulsed domain transmitter, with a half-sinusoidal pulse and a small "cut" on the falling edge, and the other one is a classical frequency domain transmitter at several specially selected frequencies. The received signal is first processed to a direct Fourier transform with high Q-factor detection at all significant frequencies. After that, in the spectral region, operations of converting the spectra of two sounding signals to a single spectrum of an ideal transmitter are performed. Than we do an inverse Fourier transform and return to the time domain. The detection of spectral components is done at a frequency band of several Hz, the receiver has the ability to perfectly suppress all sorts of extra-band noise. The detection bandwidth is several dozen times less the frequency interval between the harmonics, it turns out thatto achieve the same measurement quality of ground response without using out-of-band suppression you need several dozen times higher moment of airborne transmitting system. The data obtained from the model of a homogeneous half-space, a two-layered model, and a model of a horizontally layered medium is considered. A time-domain data makes it easier to detect a conductor in a relative insulator at greater depths. The data in the frequency domain gives more detailed information about subsurface. These conclusions are illustrated by the example of processing the survey data of the Republic of Rwanda in 2017. The simultaneous inversion of data in frequency domain and time domain can significantly improve the quality of interpretation.


Sign in / Sign up

Export Citation Format

Share Document