Virtual Array Plane Wave Imaging

Author(s):  
Guillermo Cosarinsky ◽  
Jorge Cruza ◽  
Jose Brizuela ◽  
Juan M. Iriarte ◽  
Jorge Camacho
Sensors ◽  
2021 ◽  
Vol 21 (15) ◽  
pp. 4967
Author(s):  
Guillermo Cosarinsky ◽  
Jorge F. Cruza ◽  
Jorge Camacho

Plane Wave Imaging (PWI) has been recently proposed for fast ultrasound inspections in the Non-Destructive-Testing (NDT) field. By using a single (or a reduced number) of plane wave emissions and parallel beamforming in reception, frame rates of hundreds to thousands of images per second can be achieved without significant image quality losses with regard to the Total Focusing Method (TFM) or Phased Array (PA). This work addresses the problem of applying PWI in the presence of arbitrarily shaped interfaces, which is a common problem in NDT. First, the mathematical formulation for generating a plane wave inside a component of arbitrary geometry is given, and the characteristics of the resultant acoustic field are analyzed by simulation, showing plane wavefronts with non-uniform amplitude. Then, an imaging strategy is proposed, accounting for this amplitude effect. Finally, the proposed method is experimentally validated, and its application limits are discussed.


Sensors ◽  
2021 ◽  
Vol 21 (2) ◽  
pp. 640
Author(s):  
Yujia Tang ◽  
Zhangjian Li ◽  
Yaoyao Cui ◽  
Chen Yang ◽  
Jiabing Lv ◽  
...  

Ultrasound plane wave imaging technology has been applied to more clinical situations than ever before because of its rapid imaging speed and stable imaging quality. Most transducers used in plane wave imaging are linear arrays, but their structures limit the application of plane wave imaging technology in some special clinical situations, especially in the endoscopic environment. In the endoscopic environment, the size of the linear array transducer is strictly miniaturized, and the imaging range is also limited to the near field. Meanwhile, the near field of a micro linear array has serious mutual interferences between elements, which is against the imaging quality of near field. Therefore, we propose a new structure of a micro ultrasound linear array for plane wave imaging. In this paper, a theoretical comparison is given through sound field and imaging simulations. On the basis of primary work and laboratory technology, micro uniform and non-uniform linear arrays were made and experimented with the phantom setting. We selected appropriate evaluation parameters to verify the imaging results. Finally, we concluded that the micro non-uniform linear array eliminated the artifacts better than the micro uniform linear array without the additional use of signal processing methods, especially for target points in the near-field. We believe this study provides a possible solution for plane wave imaging in cramped environments like endoscopy.


Sensors ◽  
2021 ◽  
Vol 21 (14) ◽  
pp. 4856
Author(s):  
Che-Chou Shen ◽  
Yen-Chen Chu

Conventional ultrasonic coherent plane-wave (PW) compounding corresponds to Delay-and-Sum (DAS) beamforming of low-resolution images from distinct PW transmit angles. Nonetheless, the trade-off between the level of clutter artifacts and the number of PW transmit angle may compromise the image quality in ultrafast acquisition. Delay-Multiply-and-Sum (DMAS) beamforming in the dimension of PW transmit angle is capable of suppressing clutter interference and is readily compatible with the conventional method. In DMAS, a tunable p value is used to modulate the signal coherence estimated from the low-resolution images to produce the final high-resolution output and does not require huge memory allocation to record all the received channel data in multi-angle PW imaging. In this study, DMAS beamforming is used to construct a novel coherence-based power Doppler detection together with the complementary subset transmit (CST) technique to further reduce the noise level. For p = 2.0 as an example, simulation results indicate that the DMAS beamforming alone can improve the Doppler SNR by 8.2 dB compared to DAS counterpart. Another 6-dB increase in Doppler SNR can be further obtained when the CST technique is combined with DMAS beamforming with sufficient ensemble averaging. The CST technique can also be performed with DAS beamforming, though the improvement in Doppler SNR and CNR is relatively minor. Experimental results also agree with the simulations. Nonetheless, since the DMAS beamforming involves multiplicative operation, clutter filtering in the ensemble direction has to be performed on the low-resolution images before DMAS to remove the stationary tissue without coupling from the flow signal.


Author(s):  
Bruno-Felix Osmanski ◽  
Gabriel Montaldo ◽  
Jeremy Bercoff ◽  
Thanasis Loupas ◽  
Mathias Fink ◽  
...  

Author(s):  
Kazuhiro Tochigi ◽  
Ryo Nagaoka ◽  
Jens Erik Wilhjelm ◽  
Hideyuki Hasegawa

Abstract In the early stage of atherosclerosis, the luminal surface of the arterial wall becomes rough. Methods for distinguishing between the reflected and backscattered components in the ultrasonic echo from the arterial wall has the potential to be used as a method for assessment of the roughness of the arterial wall. In this study, we proposed a method to distinguish between the reflected and backscattered components using a technique based on plane wave compounding. This method was evaluated by experiments using planar phantoms with rough surfaces made of polyurethane rubber. The coefficient of variation calculated from the mean value of the reflection component and the standard deviation of the backscattering component was proportional to the roughness of the rubber phantom. This result shows the potential usefulness of this method for analyzing surface roughness of the arterial wall.


Author(s):  
Luzhen Nie ◽  
James R. McLaughlan ◽  
David M.J. Cowell ◽  
Thomas M. Carpenter ◽  
Steven Freear
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document