Structural evolution of polycrystalline tungsten tips with palladium oxide reservoirs

2018 ◽  
Author(s):  
Hirotaka Asai ◽  
Ryota Kawai ◽  
Fumiya Matsubara ◽  
Hidekazu Murata ◽  
Eiji Rokuta
Keyword(s):  
Structural Evolution ◽  
Palladium Oxide ◽  
Polycrystalline Tungsten

Annealing Of Radiation Damage in Tungsten

1970 ◽  
Vol 28 ◽  
pp. 412-413
Author(s):  
Robert C. Rau ◽  
John Moteff
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Radiation Damage ◽  
Thermal Annealing ◽  
Neutron Fluence ◽  
Dislocation Loops ◽  
Defect Clusters ◽  
Polycrystalline Tungsten ◽  
Transmission Electron ◽  
Radiation Induced

Transmission electron microscopy has been used to study the thermal annealing of radiation induced defect clusters in polycrystalline tungsten. Specimens were taken from cylindrical tensile bars which had been irradiated to a fast (E > 1 MeV) neutron fluence of 4.2 × 1019 n/cm2 at 70°C, annealed for one hour at various temperatures in argon, and tensile tested at 240°C in helium. Foils from both the unstressed button heads and the reduced areas near the fracture were examined.Figure 1 shows typical microstructures in button head foils. In the unannealed condition, Fig. 1(a), a dispersion of fine dot clusters was present. Annealing at 435°C, Fig. 1(b), produced an apparent slight decrease in cluster concentration, but annealing at 740°C, Fig. 1(C), resulted in a noticeable densification of the clusters. Finally, annealing at 900°C and 1040°C, Figs. 1(d) and (e), caused a definite decrease in cluster concentration and led to the formation of resolvable dislocation loops.

Microstructure and reactivity of small metal particles: The role of Ce additives

1992 ◽  
Vol 50 (1) ◽  
pp. 318-319
Author(s):  
L.D. Schmidt ◽  
K. R. Krause ◽  
J. M. Schwartz ◽  
X. Chu
Keyword(s):  
Atmospheric Pressure ◽  
Noble Metals ◽  
Mixed Oxides ◽  
Catalytic Properties ◽  
Chemical Shifts ◽  
Catalytic Converter ◽  
Structural Evolution ◽  
Single Particles ◽  
Small Metal Particles

The evolution of microstructures of 10- to 100-Å diameter particles of Rh and Pt on SiO2 and Al2O3 following treatment in reducing, oxidizing, and reacting conditions have been characterized by TEM. We are able to transfer particles repeatedly between microscope and a reactor furnace so that the structural evolution of single particles can be examined following treatments in gases at atmospheric pressure. We are especially interested in the role of Ce additives on noble metals such as Pt and Rh. These systems are crucial in the automotive catalytic converter, and rare earths can significantly modify catalytic properties in many reactions. In particular, we are concerned with the oxidation state of Ce and its role in formation of mixed oxides with metals or with the support. For this we employ EELS in TEM, a technique uniquely suited to detect chemical shifts with ∼30Å resolution.

Electrodeposition of Strained-Layer Superlattices

1996 ◽  
Vol 451 ◽  
Author(s):  
T. P. Moffat
Keyword(s):  
Charge Transfer ◽  
Mass Transport ◽  
Structural Evolution ◽  
Iron Group ◽  
Morphological Instability ◽  
Group Metal ◽  
Iron Group Metal ◽  
Transport Control ◽  
Strained Layer Superlattices ◽  
Interfacial Charge

ABSTRACTA variety of Cu/(Ni, Co) multilayers have been grown on Cu single crystals by pulse plating from an alloy electroplating bath. Copper is deposited under mass transport control while the iron group metal is deposited under interfacial charge transfer control. The structural evolution of these films is influenced by the morphological instability of the mass transport limited copper deposition reaction and the development of growth twins during iron-group metal deposition. Specular films have been obtained for growth on Cu(100) while rough, defective films were typically obtained for growth on Cu(111) and Cu(110).

Pattern Formation in Thin Polymer Films: A New Morphology

2000 ◽  
Vol 629 ◽  
Author(s):  
Jean-Loup Masson ◽  
Peter F. Green
Keyword(s):  
Growth Rate ◽  
Pattern Formation ◽  
Early Stage ◽  
Structural Evolution ◽  
Distinct Form ◽  
Thin Polymer Films ◽  
Intermediate Morphology ◽  
Thin Polymer ◽  
Nonwetting Liquid ◽  
Cylindrical Holes

ABSTRACTResearchers have shown that thin, nonwetting, liquid homopolymer films dewet substrates, forming patterns that reflect fluctuations in the local film thickness. These patterns have been shown to be either discrete cylindrical holes or bicontinuous “spinodal-like” patterns. In this paper we show the existence of a new morphology. During the early stage of dewetting, discrete highly asymmetric holes appear spontaneously throughout the film. The nucleation rate of these holes is faster than their growth rate. The morphology of the late stage of evolution, after 18 days, is characterized by a bicontinuous pattern, distinct form conventional spinodal dewetting patterns. This morphology has been observed for a range of film thicknesses between 7.5 and 21nm. The structural evolution of this intermediate morphology is discussed.

Tunable Carbon Surface from Mono- to Multi-Metallic Single Atoms

2020 ◽  
Author(s):  
Weihong Lai ◽  
Heng Wang ◽  
Quan jiang ◽  
Zichao Yan ◽  
Hanwen Liu ◽  
...  
Keyword(s):  
Synergistic Effects ◽  
Structural Evolution ◽  
Charge Compensation ◽  
Catalytic Reactions ◽  
Single Atom ◽  
Carbon Surface ◽  
Hydrogen Electrode ◽  
Single Atoms ◽  
Mass Activity ◽  
Co Doped

<p>Herein, we develop a non-selective charge compensation strategy to prepare multi-single-atom doped carbon (MSAC) in which a sodium p-toluenesulfonate (PTS-Na) doped polypyrrole (S-PPy) polymer is designed to anchor discretionary mixtures of multiple metal cations, including iron (Fe<sup>3+</sup>), cobalt (Co<sup>3+</sup>), ruthenium (Ru<sup>3+</sup>), palladium (Pd<sup>2+</sup>), indium (In<sup>3+</sup>), iridium (Ir<sup>2+</sup>), and platinum (Pt<sup>2+</sup>) . As illustrated in Figure 1, the carbon surface can be tuned with different level of compositional complexities, including unary Pt<sub>1</sub>@NC, binary (MSAC-2, (PtFe)<sub>1</sub>@NC), ternary (MSAC-3, (PtFeIr)<sub>1</sub>@NC), quaternary (MSAC-4, (PtFeIrRu)<sub>1</sub>@NC), quinary (MSAC-5, (PtFeIrRuCo)<sub>1</sub>@NC), senary (MSAC-6, (PtFeIrRuCoPd)<sub>1</sub>@NC), and septenary (MSAC-7, (PtFeIrRuCoPdIn)<sub>1</sub>@NC) samples. The structural evolution of carbon surface dictates the activities of both ORR and HER. The senary MSAC-6 achieves the ORR mass activity of 18.1 A·mg<sub>metal</sub><sup>-1</sup> at 0.9 V (Vs reversible hydrogen electrode (RHE)) over 30K cycles, which is 164 times higher than that of commercial Pt/C. The quaternary MSAC-4 presented a comparable HER catalytic capability with that of Pt/C. These results indicate that the highly complexed carbon surface can enhance its ability over general electrochemical catalytic reactions. The mechanisms regarding of the ORR and HER activities of the alternated carbon surface are also theoretically and experimentally investigated in this work, showing that the synergistic effects amongst the co-doped atoms can activate or inactivate certain single-atom sites.</p>

Sign in / Sign up

Export Citation Format

Share Document