Evaluation of Finite Element Modelling Techniques of Printed Circuit Boards under Dynamic and Static Loading and Validation with Experimental Data

2021 ◽  
Author(s):  
Iulia n Eliza Tinca ◽  
Iulian n Ionut Ailinei ◽  
Andrei-Marius Silaghi ◽  
Ciprian Bleoju ◽  
Arjana Davidescu ◽  
...  
Keyword(s):  
Experimental Data ◽  
Finite Element ◽  
Static Loading ◽  
Finite Element Modelling ◽  
Printed Circuit Boards ◽  
Circuit Boards ◽  
Element Modelling ◽  
Printed Circuit ◽  
Modelling Techniques

Dielectric Breakdown in Printed Circuit Boards at Elevated Temperatures

1996 ◽  
Author(s):  
P. Singh ◽  
G.T. Galyon ◽  
J. Obrzut ◽  
W.A. Alpaugh
Keyword(s):  
Experimental Data ◽  
Thermal Degradation ◽  
Printed Circuit Boards ◽  
Printed Circuit Board ◽  
Elevated Temperatures ◽  
Dielectric Breakdown ◽  
Circuit Board ◽  
Circuit Boards ◽  
Printed Circuit ◽  
Data Matching

Abstract A time delayed dielectric breakdown in printed circuit boards, operating at temperatures below the epoxy resin insulation thermo-electrical limits, is reported. The safe temperature-voltage operating regime was estimated and related to the glass-rubber transition (To) of printed circuit board dielectric. The TG was measured using DSC and compared with that determined from electrical conductivity of the laminate in the glassy and rubbery state. A failure model was developed and fitted to the experimental data matching a localized thermal degradation of the dielectric and time dependency. The model is based on localized heating of an insulation resistance defect that under certain voltage bias can exceed the TG, thus, initiating thermal degradation of the resin. The model agrees well with the experimental data and indicates that the failure rate and truncation time beyond which the probability of failure becomes insignificant, decreases with increasing glass-rubber transition temperature.

Identification of printed circuit boards mechanical properties using response surface methods

2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Mohammad Gharaibeh
Keyword(s):  
Finite Element ◽  
Response Surface ◽  
Material Properties ◽  
Printed Circuit Boards ◽  
Dynamic Testing ◽  
Mode Shapes ◽  
Fe Model ◽  
Circuit Boards ◽  
Content Type ◽  
Printed Circuit

Purpose This study aims to discuss the determination of the unknown in-plane mechanical material properties of printed circuit boards (PCBs) by correlating the results from dynamic testing and finite element (FE) models using the response surface method (RSM). Design/methodology/approach The first 10 resonant frequencies and vibratory mode shapes are measured using modal analysis with hammer testing experiment, and hence, systematically compared with finite element analysis (FEA) results. The RSM is consequently used to minimize the cumulative error between dynamic testing and FEA results by continuously modifying the FE model, to acquire material properties of PCBs. Findings Great agreement is shown when comparing FEA to measurements, the optimum in-plane material properties were identified, and hence, verified. Originality/value This paper used FEA and RSMs along with modal measurements to obtain in-plane material properties of PCBs. The methodology presented here can be easily generalized and repeated for different board designs and configurations.

Sign in / Sign up

Export Citation Format

Share Document