THE EFFECT OF COLOSTRUM AND COLOSTRAL ANTIBODY SIgA ON THE PHYSICO-CHEMICAL PROPERTIES AND PHAGOCYTOSIS OF ESCHERICHIA COLI O86

2009 ◽  
Vol 86B (1-6) ◽  
pp. 113-120
Author(s):  
K. E. MAGNUSSON ◽  
O. STENDAHL ◽  
I. STJERNSTRÖM ◽  
L. EDEBO
Keyword(s):  
Escherichia Coli ◽  
Chemical Properties ◽  
Physico Chemical ◽  
Colostral Antibody

scholarly journals Optimization of Electrolysis Parameters for Green Sanitation Chemicals Production Using Response Surface Methodology

Processes ◽  
2020 ◽  
Vol 8 (7) ◽  
pp. 792
Author(s):  
Nurul Izzah Khalid ◽  
Nurul Shaqirah Sulaiman ◽  
Norashikin Ab Aziz ◽  
Farah Saleena Taip ◽  
Shafreeza Sobri ◽  
...  
Keyword(s):  
Escherichia Coli ◽  
Food Industry ◽  
Chemical Properties ◽  
Bactericidal Effect ◽  
Electrolyzed Water ◽  
Optimum Parameters ◽  
Physico Chemical ◽  
Different Types ◽  
Different Temperatures ◽  
Optimized Conditions

Electrolyzed water (EW) shows great potential as a green and economical sanitation solution for the food industry. However, only limited studies have investigated the optimum electrolysis parameters and the bactericidal effect of acidic electrolyzed water (AcEW) and alkaline electrolyzed water (AlEW). Here, the Box–Behnken experimental design was used to identify the optimum parameters. The tests were conducted with different types of electrodes, electrical voltages, electrolysis times, and NaCl concentrations. There were no obvious differences observed in the physico-chemical properties of EW when different electrodes were used. However, stainless steel was chosen as it meets most of the selection criteria. The best-optimized conditions for AcEW were at 11.39 V, 0.65 wt.% NaCl, and 7.23 min, while the best-optimized conditions for AlEW were at 10.32 V, 0.6 wt.% NaCl, and 7.49 min. The performance of the optimum EW (AcEW and AlEW) compared with commercial cleaning detergents for the food industry was then evaluated. The bactericidal activity of AcEW and AlEW was examined against Escherichia coli ATCC 10536 at different temperatures (30 °C and 50 °C) for 30 s. The results show that both AcEW and AlEW have the ability to reduce the Escherichia coli to non-detectable levels (less than 2 log CFU/mL).

scholarly journals A benchmark of protein solubility prediction methods on UDP-dependent glycosyltransferases

2020 ◽  
Author(s):  
Fatemeh Ashari Ghomi ◽  
Tiia Kittilä ◽  
Ditte Hededam Welner
Keyword(s):  
Escherichia Coli ◽  
Protein Solubility ◽  
Chemical Properties ◽  
Prediction Methods ◽  
Solubility Prediction ◽  
E Coli ◽  
Physico Chemical ◽  
And Function ◽  
Better Than

AbstractUDP-dependent glycosyltransferases (UGTs) are enzymes that glycosylate a wide variety of natural products, thereby modifying their physico-chemical properties, i.e. solubility, stability, reactivity, and function. To successfully leverage the UGTs in biocatalytic processes, we need to be able to screen and characterise them in vitro, which requires efficient heterologous expression in amenable hosts, preferably Escherichia coli. However, many UGTs are insoluble when expressed in standard and attempted optimised E. coli conditions, resulting in many unproductive and costly experiments. To overcome this limitation, we have investigated the performance of 11 existing solubility predictors on a dataset of 57 UGTs expressed in E. coli. We show that SoluProt outperforms other methods in terms of both threshold-independent and threshold-dependent measures. Among the benchmarked methods, only SoluProt is significantly better than random predictors using both measures. Moreover, we show that SoluProt uses a threshold for separating soluble and insoluble proteins that is optimal for our dataset. Hence, we conclude that using SoluProt to select UGT sequences for in vitro investigation will significantly increase the success rate of soluble expression, thereby minimising cost and enabling efficient characterisation efforts for biocatalysis research.

Decoration of specific sites on freeze-fractured membranes

1978 ◽  
Vol 36 (2) ◽  
pp. 140-141
Author(s):  
H. Gross ◽  
H. Moor
Keyword(s):  
Pure Water ◽  
Freeze Fracture ◽  
Chemical Properties ◽  
Surface Forces ◽  
Sulfate Pentahydrate ◽  
Copper Sulfate Pentahydrate ◽  
Physico Chemical ◽  
Water Of Hydration ◽  
Small Container ◽  
Binding Forces

Fracturing under ultrahigh vacuum (UHV, p ≤ 10-9 Torr) produces membrane fracture faces devoid of contamination. Such clean surfaces are a prerequisite foe studies of interactions between condensing molecules is possible and surface forces are unequally distributed, the condensate will accumulate at places with high binding forces; crystallites will arise which may be useful a probes for surface sites with specific physico-chemical properties. Specific “decoration” with crystallites can be achieved nby exposing membrane fracture faces to water vopour. A device was developed which enables the production of pure water vapour and the controlled variation of its partial pressure in an UHV freeze-fracture apparatus (Fig.1a). Under vaccum (≤ 10-3 Torr), small container filled with copper-sulfate-pentahydrate is heated with a heating coil, with the temperature controlled by means of a thermocouple. The water of hydration thereby released enters a storage vessel.

Physico-Chemical Properties of Recombinant Desulphatohirudin

1990 ◽  
Vol 63 (03) ◽  
pp. 499-504 ◽  
Author(s):  
A Electricwala ◽  
L Irons ◽  
R Wait ◽  
R J G Carr ◽  
R J Ling ◽  
...  
Keyword(s):  
Molecular Weight ◽  
Gel Filtration ◽  
Chemical Properties ◽  
Alpha Helix ◽  
Apparent Molecular Weight ◽  
Correlation Spectroscopy ◽  
Nmr Studies ◽  
Recombinant Hirudin ◽  
Physico Chemical ◽  
Recombinant Molecule

SummaryPhysico-chemical properties of recombinant desulphatohirudin expressed in yeast (CIBA GEIGY code No. CGP 39393) were reinvestigated. As previously reported for natural hirudin, the recombinant molecule exhibited abnormal behaviour by gel filtration with an apparent molecular weight greater than that based on the primary structure. However, molecular weight estimation by SDS gel electrophoresis, FAB-mass spectrometry and Photon Correlation Spectroscopy were in agreement with the theoretical molecular weight, with little suggestion of dimer or aggregate formation. Circular dichroism studies of the recombinant molecule show similar spectra at different pH values but are markedly different from that reported by Konno et al. (13) for a natural hirudin-variant. Our CD studies indicate the presence of about 60% beta sheet and the absence of alpha helix in the secondary structure of recombinant hirudin, in agreement with the conformation determined by NMR studies (17)

Physico-chemical properties of the rare-earth metals, scandium, and yttrium

1963 ◽  
Vol 79 (2) ◽  
pp. 263-293 ◽  
Author(s):  
E.M. Savitskii ◽  
V.F. Terekhova ◽  
O.P. Naumkin
Keyword(s):  
Rare Earth ◽  
Rare Earth Metals ◽  
Chemical Properties ◽  
Physico Chemical ◽  
The Rare Earth

Physico chemical properties and gas adsorption separation characteristics of Itaya zeolite and its modified products.

1990 ◽  
Vol 39 (442) ◽  
pp. 996-1000 ◽  
Author(s):  
Ayao TAKASAKA ◽  
Hideyuki NEMOTO ◽  
Hirohiko KONO ◽  
Yoshihiro MATSUDA
Keyword(s):  
Gas Adsorption ◽  
Chemical Properties ◽  
Physico Chemical

Development of Ketchup from Sudanese Red karkade (Hibiscus sabdariffa L.) byproduct

Food Biology ◽  
1970 ◽  
pp. 19-23
Author(s):  
Nawal Abdel-Gayoum Abdel-Rahman
Keyword(s):  
Sensory Quality ◽  
Chemical Properties ◽  
Storage Period ◽  
Gum Arabic ◽  
Raw Material ◽  
Soluble Solids ◽  
Hibiscus Sabdariffa ◽  
Overall Acceptability ◽  
Physico Chemical ◽  
Tomato Ketchup

The aim of this study is to use of karkede (Hibiscus sabdariffa L.) byproduct as raw material to make ketchup instead of tomato. Ketchup is making of various pulps, but the best type made from tomatoes. Roselle having adequate amounts of macro and micro elements, and it is rich in source of anthocyanine. The ketchup made from pulped of waste of soaked karkede, and homogenized with starch, salt, sugar, ginger (Zingiber officinale), kusbara (Coriandrum sativum) and gum Arabic. Then processed and filled in glass bottles and stored at two different temperatures, ambient and refrigeration. The total solids, total soluble solids, pH, ash, total titratable acidity and vitamin C of ketchup were determined. As well as, total sugars, reducing sugars, colour density, and sodium chloride percentage were evaluated. The sensory quality of developed product was determined immediately and after processing, which included colour, taste, odour, consistency and overall acceptability. The suitability during storage included microbial growth, physico-chemical properties and sensory quality. The karkede ketchup was found free of contaminants throughout storage period at both storage temperatures. Physico-chemical properties were found to be significantly differences at p?0.05 level during storage. There were no differences between karkade ketchup and market tomato ketchup concerning odour, taste, odour, consistency and overall acceptability. These results are encouraging for use of roselle cycle as a raw material to make acceptable karkade ketchup.

Sign in / Sign up

Export Citation Format

Share Document