Radiation Absorption in a Particle Curtain Exposed to Direct High-Flux Solar Irradiation

2018 ◽  
Vol 140 (6) ◽  
Author(s):  
Apurv Kumar ◽  
Jin-Soo Kim ◽  
Wojciech Lipiński
Keyword(s):  
Solar Radiation ◽  
Particle Distribution ◽  
Radiative Transfer Equation ◽  
Hydrodynamic Instability ◽  
Solar Irradiation ◽  
Radiation Absorption ◽  
Two Phase ◽  
Computational Fluid Dynamics Cfd ◽  
Radiation Extinction ◽  
Free Falling

Radiation absorption is investigated in a particle curtain formed in a solar free-falling particle receiver. An Eulerian–Eulerian granular two-phase model is used to solve the two-dimensional mass and momentum equations by employing computational fluid dynamics (CFD) to find particle distribution in the curtain. The radiative transfer equation (RTE) is subsequently solved by the Monte Carlo (MC) ray-tracing technique to obtain the radiation intensity distribution in the particle curtain. The predicted opacity is validated with the experimental results reported in the literature for 280 and 697 μm sintered bauxite particles. The particle curtain is found to absorb the solar radiation most efficiently at flowrates upper-bounded at approximately 20 kg s−1 m−1. In comparison, 280 μm particles have higher average absorptance than 697 μm particles (due to higher radiation extinction characteristics) at similar particle flowrates. However, as the absorption of solar radiation becomes more efficient, nonuniform radiation absorption across the particle curtain and hydrodynamic instability in the receiver are more probable.

Radiation Characteristics of a Particle Curtain in a Free-Falling Particle Solar Receiver

2017 ◽  
Author(s):  
Apurv Kumar ◽  
Jin-Soo Kim ◽  
Wojciech Lipiński
Keyword(s):  
Volume Fraction ◽  
Particle Volume Fraction ◽  
Absorption Efficiency ◽  
Radiation Absorption ◽  
Particle Volume ◽  
Two Phase ◽  
Low Mass ◽  
Radiation Extinction ◽  
Solar Receiver ◽  
Free Falling

Radiation absorption by a particle curtain formed in a solar free falling particle receiver is investigated using a Eulerian-Eulerian granular two-phase model to solve the two-dimensional mass and momentum equations (CFD). The radiative transfer equation is subsequently solved by the Monte-Carlo (MC) ray-tracing technique using the CFD results to quantify the radiation intensity through the particle curtain. The CFD and MC results provide reliable opacity predictions and are validated with the experimental results available in literature. The particle curtain was found to absorb the solar radiation efficiently for smaller particles at high flowrates due to higher particle volume fraction and increased radiation extinction. However, at low mass-flowrates the absorption efficiency decreases for small and large particles.

scholarly journals Local Tilt Optimization of Photovoltaic Solar Panels for Maximum Radiation Absorption

2019 ◽  
Vol 2019 ◽  
pp. 1-10
Author(s):  
Mauro Masili ◽  
Liliane Ventura
Keyword(s):  
Solar Radiation ◽  
Tilt Angle ◽  
Spectral Response ◽  
Solar Spectrum ◽  
Weather Conditions ◽  
Solar Irradiation ◽  
Radiation Absorption ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Solar Panels

Incident solar radiation on photovoltaic (PV) solar panels is not constant throughout the year. Besides dependence on the season, solar radiation is reliant on the location and weather conditions. For a given location on Earth, the best-fixed orientation of a PV panel can be determined by achieving the maximum incident solar irradiance throughout the year or for a predetermined period. In this paper, we use a sophisticated atmospheric radiative transfer model to calculate the direct and diffuse solar irradiation (radiant exposure) for the solar spectrum incident on PV solar panels to determine the best tilt angle of the panel in order to maximize absorption of solar radiation for selected periods. We used the Regula-Falsi numerical method to obtain the tilt angle at which the derivative of solar irradiation (concerning the tilt angle) approaches zero. Moreover, the spectral response of typical silicon cells is taken into account. These calculations were carried out in São Carlos (SP), a town in the southeast of Brazil. The best tilt angle was obtained for three selected periods. Additionally, we provide results for Southern latitudes ranging from 0° to −55° in steps of −5° for the meteorological seasons. We have shown that for each period, there is an increase in solar radiation absorption compared to the traditional installation angle based exclusively on the local latitude. These calculations can be extended to any location.

Three-Dimensional Numerical Simulation of Fluid with Sparse Particles' Erosion to Pipelines

2013 ◽  
Vol 805-806 ◽  
pp. 1785-1789
Author(s):  
Chang Bin Wang ◽  
Miao Wang ◽  
Xiao Xu Li ◽  
Yu Liu ◽  
Jie Nan Dong
Keyword(s):  
Fluid Dynamics ◽  
Numerical Simulation ◽  
Flow Model ◽  
Particle Distribution ◽  
Three Dimensional ◽  
Two Phase ◽  
Wear Area ◽  
Computational Fluid Dynamics Cfd ◽  
Set Up ◽  
Volume Method

A three dimensional fluid flow model was set up in this paper, based on the computational fluid dynamics (CFD) and the elasticity theory. Using the finite volume method, a 120° bend was taken as a research object to simulate the erosion to the wall of fluid with sparse particles, finally, to determine the most severe wear areas.At the same time, the distribution of two-phase flows pressure and velocity was analyzed in 45° and 90° bends, then tracked the trajectory of the particles. The results show that the 90°bend has the smallest wear area and particle distribution or combination property is the best.

Liver Radioembolization: An Analysis of Parameters that Influence the Catheter-Based Particle-Delivery via CFD

2020 ◽  
Vol 27 (10) ◽  
pp. 1600-1615 ◽  
Author(s):  
Jorge Aramburu ◽  
Raúl Antón ◽  
Alejandro Rivas ◽  
Juan C. Ramos ◽  
Bruno Sangro ◽  
...  
Keyword(s):  
Numerical Simulations ◽  
Particle Distribution ◽  
Numerical Approach ◽  
Radioactive Microspheres ◽  
Tumor Bearing ◽  
Hemodynamic Pattern ◽  
Valuable Treatment ◽  
Catheter Tip ◽  
Radiation Induced ◽  
Computational Fluid Dynamics Cfd

Radioembolization (RE) is a valuable treatment for liver cancer. It consists of administering radioactive microspheres by an intra-arterially placed catheter with the aim of lodging these microspheres, which are driven by the bloodstream, in the tumoral bed. Even though it is a safe treatment, some radiation-induced complications may arise. In trying to detect or solve the possible incidences that cause nontarget irradiation, simulating the particle- hemodynamics in hepatic arteries during RE by computational fluid dynamics (CFD) tools has become a valuable approach. This paper reviews the parameters that influence the outcome of RE and that have been studied via numerical simulations. In this numerical approach, the outcome of RE is regarded as successful if particles reach the artery branches that feed tumor-bearing liver segments. Up to 10 parameters have been reviewed. The variation of each parameter actually alters the hemodynamic pattern in the vicinities of the catheter tip and locally alters the incorporation of the particles into the bloodstream. Therefore, in general, the local influences of these parameters should result in global differences in terms of particle distribution in the hepatic artery branches. However, it has been observed that under some (qualitatively described) appropriate conditions where particles align with blood streamlines, the local influence resulting from a variation of a given parameter vanishes and no global differences are observed. Furthermore, the increasing number of CFD studies on RE suggests that numerical simulations have become an invaluable research tool in the study of RE.

Further Computational Investigations Into Aero-Engine Bearing Chamber Off-Take Flows

2010 ◽  
Author(s):  
Adam Robinson ◽  
Carol Eastwick ◽  
Herve´ Morvan
Keyword(s):  
Experimental Work ◽  
Symmetry Plane ◽  
Two Phase ◽  
Pipe System ◽  
Aero Engine ◽  
Gravity Driven ◽  
Computational Fluid Dynamics Cfd ◽  
Modelling Assumptions ◽  
Static Head ◽  
Engine Bearing

Within an aero-engine bearing chamber oil is provided to components to lubricate and cool. This oil must be efficiently removed (scavenged) from the chamber to ensure it does not overheat and degrade. Bearing chambers typically contain a sump section with an exit pipe leading to a scavenge pump. In this paper a simplified geometry of a sump section, here simply made of a radial off-take port on a walled inclined plane, is analysed computationally. This paper follows on work presented within GT2008-50634. In the previous paper it was shown that simple gravity draining from a static head of liquid cold be modelled accurately, for what was akin to a deep sump situation fond in integrated gear boxes for example. The work within this paper will show that the draining of flow perpendicular to a moving film can be modelled. This situation is similar to the arrangements found in transmission bearing chambers. The case modelled is of a walled gravity driven film running down a plane with a circular off-take port, this replicates experimental work similar to that reported in GT2008-50632. The commercial computational fluid dynamics (CFD) code, Fluent 6 [1] has been employed for modelling, sing the Volume of Fluid (VOF) approach of Hirt and Nichols [2, 3] to capture the physics of both the film motion and the two phase flow in the scavenge pipe system. Surface tension [4] and a sharpening algorithm [5] are used to complement the representation of the free surface and associated effects. This initial CFD investigation is supported and validated with experimental work, which is only depicted briefly here as it is mainly sued to support the CFD methodology. The case has been modelled in full as well as with the use of a symmetry plane running down the centre of the plane parallel to the channel walls. This paper includes details of the meshing methodology, the boundary conditions sued, which will be shown to be of critical importance to accurate modelling, and the modelling assumptions. Finally, insight into the flow patterns observed for the cases modelled are summarised. The paper further reinforces that CFD is a promising approach to analysing bearing chamber scavenge flows although it can still be relatively costly.

scholarly journals Calibration and Validation of ArcGIS Solar Radiation Tool for Photovoltaic Potential Determination in the Netherlands

Energies ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1865
Author(s):  
Bala Bhavya Kausika ◽  
Wilfried G. J. H. M. van Sark
Keyword(s):  
Solar Radiation ◽  
The Netherlands ◽  
Urban Areas ◽  
Input Data ◽  
Solar Irradiation ◽  
Energy Yield ◽  
Atmospheric Parameters ◽  
Factors Affecting ◽  
Calibration And Validation ◽  
Solar Radiation Model

Geographic information system (GIS) based tools have become popular for solar photovoltaic (PV) potential estimations, especially in urban areas. There are readily available tools for the mapping and estimation of solar irradiation that give results with the click of a button. Although these tools capture the complexities of the urban environment, they often miss the more important atmospheric parameters that determine the irradiation and potential estimations. Therefore, validation of these models is necessary for accurate potential energy yield and capacity estimations. This paper demonstrates the calibration and validation of the solar radiation model developed by Fu and Rich, employed within ArcGIS, with a focus on the input atmospheric parameters, diffusivity and transmissivity for the Netherlands. In addition, factors affecting the model’s performance with respect to the resolution of the input data were studied. Data were calibrated using ground measurements from Royal Netherlands Meteorological Institute (KNMI) stations in the Netherlands and validated with the station data from Cabauw. The results show that the default model values of diffusivity and transmissivity lead to substantial underestimation or overestimation of solar insolation. In addition, this paper also shows that calibration can be performed at different time scales depending on the purpose and spatial resolution of the input data.

The Effect of Turbulence and Real Gas Models on the Two Phase Spontaneously Condensing Flows in Nozzle

2013 ◽  
Author(s):  
Yogini Patel ◽  
Giteshkumar Patel ◽  
Teemu Turunen-Saaresti
Keyword(s):  
Fluid Dynamics ◽  
Experimental Data ◽  
Nucleation Theory ◽  
Classical Nucleation Theory ◽  
Navier Stokes ◽  
Two Phase ◽  
Real Gas ◽  
Spontaneous Condensation ◽  
Condensing Flows ◽  
Computational Fluid Dynamics Cfd

The aim of the paper is to analyse the effect of turbulence and real gas models on the process of spontaneous condensation in converging diverging (CD) nozzle by using commercial Computational Fluid Dynamics (CFD) code. The calculations were based on the 2-D compressible Navier-Stokes (NS) equations coupled with two-equation turbulence model, and the non-equilibrium spontaneous condensing steam flow was solved on the basis of the classical nucleation theory. The results were validated to the available experimental data.

scholarly journals A Two-Phase Model of Air Shock Wave Induced by Rock-Fall in Closed Goaf

2017 ◽  
Author(s):  
Fengyu Ren ◽  
Yang Liu ◽  
Jianli Cao ◽  
Rongxing He ◽  
Yuan Xu ◽  
...  
Keyword(s):  
Shock Wave ◽  
Theoretical Analysis ◽  
Phase Model ◽  
Rock Fall ◽  
Uniform Motion ◽  
Two Phase ◽  
Protective Measures ◽  
Computational Fluid Dynamics Cfd ◽  
Series Of Experiments ◽  
Wave Induced

In this paper, a two-phase model of air shock wave induced by rock-fall was described. The model was made up of the uniform motion phase (velocity was close to 0 m·s-1) and the acceleration movement phase. The uniform motion phase was determined by experience, meanwhile the acceleration movement phase was derived by the theoretical analysis. A series of experiments were performed to verify the two-phase model and obtained the law of the uniform motion phase. The acceleration movement phase was taking a larger portion when height of rock-fall was higher with the observations. Experimental results of different falling heights showed good agreements with theoretical analysis values. Computational fluid dynamics (CFD) numerical simulation had been carried out to study the variation velocity with different falling height. As a result of this, the two-phase model could accurately and convenient estimating the velocity of air shock wave induced by rock-fall. The two-phase model could provide a reference and basis for estimating the air shock waves' velocity and designing the protective measures.

Sign in / Sign up

Export Citation Format

Share Document