scholarly journals The Low Emission Gas Turbine Passenger Car: What Does the Future Hold?

1973 ◽  
Author(s):  
T. F. Nagey ◽  
P. Mykolenko ◽  
M. E. Naylor ◽  
F. J. Verkemp
Keyword(s):  
Gas Turbine ◽  
State Of The Art ◽  
Gas Turbine Engine ◽  
Design Criteria ◽  
Passenger Cars ◽  
Passenger Car ◽  
Turbine Engine ◽  
Low Emission ◽  
The Future ◽  
Fundamental Design

This paper reviews the potential of the gas turbine as a low emission engine for passenger cars. State-of-the-art emission levels for turbines are identified together with the causes for the typically high levels of NOx that are encountered. Laboratory solutions for reduced NOx are discussed and some of the recent GM accomplishments defined. Fundamental design criteria for low emission combustors are identified. The paper concludes with a brief discussion of the problems remaining in the area of combustors for which solutions must be found before the gas turbine engine can be considered for general use.

Analytical efficiency comparison between gas turbine and gas turbine hybrid engines for passenger cars

1997 ◽  
Vol 211 (2) ◽  
pp. 113-119 ◽  
Author(s):  
W Cheng ◽  
D. G. Wilson ◽  
A. C. Pfahnl
Keyword(s):  
Gas Turbine ◽  
Gas Turbine Engine ◽  
Passenger Cars ◽  
Long Distance ◽  
Vehicle Performance ◽  
Turbine Engine ◽  
Compression Ignition Engines ◽  
Power Turbine ◽  
Performance And Emissions ◽  
Efficiency Comparison

The performance and emissions of two alternative types of gas turbine engine for a chosen family vehicle are compared. One engine is a regenerative 71 kW gas turbine; the other is a hybrid power plant composed of a 15 kW gas turbine and a 7 MJ flywheel. These engines would give generally similar vehicle performance to that produced by 71 kW spark ignition and compression ignition engines. (The turbine engines would be lighter and, with a free power turbine, would have a more favourable torque-speed curve (1), giving them some advantages.) Results predict that for long-distance trips the hybrid engine would have a considerably better fuel economy and would produce lower emissions than the piston engines, and that the ‘straight’ gas turbine would be even better. For shorter commuting trips the hybrid would be able to run entirely from energy acquired and stored from house electricity, and it could therefore be the preferred choice for automobiles used primarily for urban driving when environmental factors are taken into account. However, the degradation of remaining energy in flywheel batteries and thermal energy in the regenerator and other engine hot parts between use periods will result in more energy being used than for the straight gas turbine engine using normal liquid fuel. The higher initial cost and greater complexity of the hybrid engine will be additional disadvantages.

The Potential Impact of Future Fuels on Small Gas Turbine Engines

1982 ◽  
Author(s):  
J. A. Saintsbury ◽  
P. Sampath
Keyword(s):  
Gas Turbine ◽  
Operating Experience ◽  
Gas Turbine Engine ◽  
Turbine Engines ◽  
Gas Turbine Engines ◽  
Turbine Engine ◽  
The Future ◽  
Potential Impact ◽  
The Impact ◽  
Whitney Aircraft

The impact of potential aviation gas turbine fuels available in the near to midterm, is reviewed with particular reference to the small aviation gas turbine engine. The future course of gas turbine combustion R&D, and the probable need for compromise in fuels and engine technology, is also discussed. Operating experience to date on Pratt & Whitney Aircraft of Canada PT6 engines, with fuels not currently considered of aviation quality, is reported.

Development of the Ceramic Gas Turbine Engine System (CGT301)

1999 ◽  
Author(s):  
Takeshi Sakida ◽  
Shinya Tanaka ◽  
Takao Mikami ◽  
Masashi Tatsuzawa ◽  
Tomoki Taoka
Keyword(s):  
Gas Turbine ◽  
Turbine Blades ◽  
Gas Turbine Engine ◽  
Turbine Engine ◽  
The Future ◽  
Engine System ◽  
Primary Type ◽  
Three Phases

The CGT301 ceramic gas turbine has been developed under a contract from NEDO as a part of the New Sunshine Program of MITI since 1988 to 1998. The CGT301 is a recuperated, single-shaft ceramic gas turbine. Ceramic parts are used in the hot section of the engine, such as turbine blades, nozzle vanes, combustion liners and so on. As a primary feature of this turbine, the rotors are composed of ceramic blades inserted into metallic disks (“hybrid rotor”) for the future applicability to the large gas turbine. The R & D program consists of three phases, the model metal gas turbine, the primary type ceramic gas turbine and the pilot ceramic gas turbine. The pilot ceramic gas turbine showed etable operation at TIT of 1,350°C. This paper presents the progress in the development of the pilot ceramic gas turbine of CGT301.

Low Emission Variable Area Combustor for Vehicular Gas Turbines

1973 ◽  
Vol 95 (3) ◽  
pp. 191-198 ◽  
Author(s):  
D. J. White ◽  
P. B. Roberts ◽  
W. A. Compton
Keyword(s):  
Power Systems ◽  
Gas Turbine ◽  
Environmental Protection Agency ◽  
Gas Turbines ◽  
Gas Turbine Engine ◽  
Protection Agency ◽  
Engine Emissions ◽  
Turbine Engine ◽  
Automotive Engine ◽  
Low Emission

In recent years automotive engine emissions have become subject to stringent Federal legislation. The most severe of these regulations pertains to the 1976 Emission Standards as defined by the Advanced Automotive Power Systems (AAPS) Division of the Environmental Protection Agency (EPA). A unique combustor concept has been developed by Solar which has demonstrated the feasibility of meeting these emission requirements. The integrated emissions of a typical regenerative gas turbine engine employing this combustor type were each below one half of the levels specified by the Federal 1976 Standards, when tested over a simulated federal driving cycle. The success of the feasibility tests for this combustor concept has lead to more fundamental studies and the planned development of a prototype combustor for demonstration on the EPA-AAPS baseline gas turbine engine. The prototype combustor for the baseline engine is described together with its variable area port mechanisms, which has been demonstrated as necessary for emission control.

Development of the Centaur Type H Gas Turbine Engine

1985 ◽  
Author(s):  
G. L. Padgett ◽  
W. W. Davis
Keyword(s):  
Gas Turbine ◽  
High Efficiency ◽  
State Of The Art ◽  
Gas Turbine Engine ◽  
Development Plan ◽  
Inlet Temperature ◽  
Market Place ◽  
Turbine Inlet Temperature ◽  
Turbine Engine ◽  
Computer Aided

In response to the needs of the market place for turbines in the 5000 to 6000 hp class, Solar Turbines Incorporated has responded with an uprate of their Centaur engine. Discussed in this paper are the features of the uprated engine, the Development Plan and the methodology for incorporating into the design the advanced aerodynamic and mechanical technology of the Mars engine. The Mars engine is a high efficiency 12,500 hp engine which operates at a turbine inlet temperature of 1935°F. State-of-the-art computer aided methods have been applied to produce the design, and the results from this approach are displayed.

THERMO ACOUSTIC PROCESSES IN LOW EMISSION COMBUSTION CHAMBER OF GAS TURBINE ENGINE CAPACITY 25 MW

2019 ◽  
pp. 86-90
Author(s):  
Sergey Serbin
Keyword(s):  
Mathematical Models ◽  
Combustion Chamber ◽  
Gas Turbine ◽  
Three Dimensional ◽  
Fuel Mixture ◽  
Gas Turbine Engine ◽  
Operational Parameters ◽  
Combustion Chambers ◽  
Turbine Engine ◽  
Low Emission

The appliance of modern tools of the computational fluid dynamics for the investigation of the pulsation processes in the combustion chamber caused by the design features of flame tubes and aerodynamic interaction compressor, combustor and turbine is discussed. The aim of the research is to investigate and forecast the non-stationary processes in the gas turbine combustion chambers. The results of the numerical experiments which were carried out using three-dimensional mathematical models in gaseous fuels combustion chambers reflect sufficiently the physical and chemical processes of the unsteady combustion and can be recommended to optimize the geometrical and operational parameters of the low-emission combustion chamber. The appliance of such mathematical models are reasonable for the development of new samples of combustors which operate at the lean air-fuel mixture as well as for the modernization of the existing chambers with the aim to develop the constructive measures aimed at reducing the probability of the occurrence of the pulsation combustion modes. Keywords: gas turbine engine, combustor, turbulent combustion, pulsation combustion, numerical methods, mathematical simulation.

Sign in / Sign up

Export Citation Format

Share Document